Planet ENW-3503F Manual de usuario
1
10/100 Fast Ethernet
&
56K V.90 Fax/Modem
Multifunction PC Card
ENW-3503F
User’s Manual
PLANET ENW-3503F
2
FCC REGULATORY STATEMENTS
FCC Certification
10/100 Fast Ethernet + 56K Fax/Modem PC Card
PLANET ENW-3503F FCC ID: MQ4LF560TX
Made in Taiwan
The United States Federal Communication Commission (FCC) and the Canadian
Department of Communications have established certain rules governing the use of
modems and other electronic equipment.
FCC Part 68 Registration
This high speed 10/100 Fast Ethernet + 56K FAX/MODEM PC Card complies with
FCC Part 68 rules, and the use of this modem is subject to the following restrictions:
1. The FCC has established rules which permit this device to be directly connected to
the telephone network. Standardized jacks are used for these connections. This
equipment should not be used on party lines or coin phones.
2. If this device is malfunctioning, it may also be causing harm to the telephone
network; this device should be disconnected until the source of the problem can be
determined and until repair has been made. If this is not done, the telephone
company may temporarily disconnect service.
3. The telephone company may make changes in it's facilities, equipment, operation
and procedures; if such changes affect the compatibility or use of this device, the
telephone company is required to give adequate notice of the situation with the
FCC.
4. If the telephone company requests information on what equipment is connected to
their lines, inform them of:
a. The telephone number to which this unit is connected.
b. The Ringer Equivalence Number (REN).
c. The USOC jack required.
d. The FCC Registration number.
3
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN)
is used to determine how many devices can be connected to your telephone line. In
most areas, the sum of the REN's of all the devices on any one line should not exceed
5.0. If too many devices are attached, they may not ring properly.
FCC Part 15 Registration
This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interface, and
2) This device must accept any interface received, including interface that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
(1) Reorient or relocate the receiving antenna.
(a) Increase the distance between the equipment and receiver
(b) Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
(2) Consult an experienced radio/TV technician for help.
CTR 21 pan-European Certification
This equipment has been approved in accordance with Council Decision 98/482/EC
for pan-European single terminal connection to the public switched telephone
network (PSTN). However, due to differences between the individual PSTNs
provided in different countries, the approval does not, of itself, give an unconditional
assurance of successful operation on every PSTN network termination point. In the
event of problems, you should contact your equipment supplier in the first instance.
PLANET ENW-3503F
4
This device is designed to work with the notified networks in all EC member states.
Nevertheless, some of the network services in invidual countries might not be
supported, but they will not affect the normal data and fax applications. For example,
the metering charge service in Germany. Besides you may encounter difficulty of
using PULSE dialing function in some of the countries, such as Nordic countries.
This kind of network compatibility is dependent on the physical and software settings
of this device. If the users are desired to use this device on those networks, they
should contact the vendor or supplier first.
Trademarks
Copyright PLANET Technology Corp. 1999.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. The
information in this manual is subject to change without notice. All other
trademarks belong to their respective owners.
Revision
This user's manual is for PLANET PC Card family,
model -- ENW-3503F
10/100 Fast Ethernet + 56K Fax Modem multifunction card
Rev: 1.00 (January, 1999)
Part No: EM3503F
5
TABLE OF CONTENTS
GENERAL DESCRIPTION................................................................1
ABOUT THIS MANUAL...................................................................1
ABOUT THIS PRODUCT .................................................................1
Specifications ..................................................................................2
Features...........................................................................................3
SYSTEM REQUIREMENTS.............................................................4
CONTENTS INCLUDED IN THE PACKAGE................................4
INSTALLATION ..................................................................................5
HARDWARE INSTALLATION.......................................................5
INSTALLING THE SOFTWARE......................................................7
For Non-Windows 95/98 & Non-Windows NT System..................7
Novell Netware Installation............................................................7
MS LAN Manager Installation .......................................................9
Packet Driver Installation.............................................................11
Windows for Workgroups 3.11 Installation.................................12
Windows NT 3.51 & NT 4.0 Installation......................................13
Windows 95 Installation ...............................................................18
Working with Windows 98 ............................................................20
Artisoft Lantastic 6.0 Installation.................................................21
MODEM BASICS...............................................................................23
UNDERSTANDING AT COMMANDS....................................................23
DIALING AND ANSWERING TECHNIQUES...........................................26
DRIVERS INFORMATION .............................................................28
NOTES FOR NDIS DRIVER.................................................................28
NOTES FOR PACKET DRIVER..............................................................29
NOTES FOR WINDOWS FOR WORKGROUPS .......................................30
PLANET ENW-3503F
6
QUESTIONS AND ANSWERS ........................................................29
APPENDIX A: NDIS2 AND ODI DRIVERS FOR WFW 3.11....39
NDIS2 DRIVER FOR WORKGROUPS...................................................39
ODI DRIVER FOR WORKGROUPS.......................................................40
APPENDIX B: UNINSTALLATION THE 10/100 FAST
ETHERNET + FAXMODEM IN WIN 95/98..................................42
APPENDIX C: AT COMMAND QUICK REFERENCE.............45
MODEM AT COMMANDS ...................................................................45
Basic AT Command Set.................................................................45
Extended “AT&”(Ampersand) Command Set.............................47
Extended “AT”(Back Slash) Command Set ...............................49
Extended “AT%”(Percent) Command Set...................................49
Extended “AT-”(Dash) Command Set ........................................50
Result Code Options......................................................................50
Extended Result Code Options Table...........................................51
APPENDIX D: S-REGISTERS QUICK REFERENCE ...............54
LAN + Fax Modem User's Manual 1
GENERAL DESCRIPTION
ABOUT THIS MANUAL
This manual will explain how to install and use your ENW-3503F,
the multifunction 10/100 Fast Ethernet + 56K Fax/Modem PC Card
ABOUT THIS PRODUCT
ENW-3503, the 10/100 Fast Ethernet + 56K Fax/Modem PC Card
is a multifunction communication device that lets you perform
multiple communication tasks at the same time:
(1) transmit and receive data up to 56,000 bps
send and receive FAXes from computers or FAX machines
(2) connect to an 10/100 Fast Ethernet LAN
And it uses only one PCMCIA socket while it can provide the
functions listed above.
This PC Card is a credit-card-size Type II PCMCIA adapter that
complies with the PCMCIA 2.1 and JEIDA 4.1 standards and works
with computers that incorporate a compatible interface.
It is Bell, ITU-T (formerly CCITT) and Hayes AT commands
compatible, allowing it to be used worldwide with today's popular
communication software programs. You will be able to send and
receive faxes with any Group 3 fax machine. Using standard phone
lines and 10/100 Fast Ethernet, the data communication functions of
the 10/100 Fast Ethernet + 56K Fax/Modem PC Card will enable
you to successfully access to the servers on 10/100 Fast Ethernet
LAN and hook up to the Internet, transmit E-Mail, send and receive
information and communicate with other PCs, Bulletin Board
PLANET ENW-3503F
2
Services (BBS) or on-line computer networks such as CompuServe
and America On line.
Specifications
PC Card Interface
PCMCIA Type II.
Dimension
3.37”X 2.128”X 0.197”or
85.6 mm X 54 mm X 5 mm
Weight
60 g
Power
+5V ±5%
Cable and Connector
Two 15-pin detachable connector to PC Card, one with a RJ-11 6-
pin jack for 56K Fax/Modem and one with a RJ-45 8-pin jack for
10/100 Fast Ethernet LAN connections.
Network
IEEE 802.3 10BaseT, 10Mbps.
IEEE 802.3u 100BaseTX, 100Mbps.
NE2000 compatible.
Modem
LAN + Fax Modem User's Manual 3
V.90, K56flex 56Kbps, V.34+ 33.6Kbps, V.34 28.8Kbps, V.32bis
14.4Kbps.
V.42bis/V.42, MNP 2-5 data compression and error correction.
AT command set.
Fax
Group 3, V.17 14400bps, V.29 9600bps
Fax Service Class 1 compliant.
Modem COM Port
COM2, COM3, COM4
IRQ 3, 4, 5, 7, 9, 10, 11, 12, 15
I/O Address 220, 300, 320, 340
Features
♦Compatible with most notebook computers and PCMCIA Card and
Socket Service drivers.
♦High degree of reliability letting you out of trouble.
♦Easy to install and play.
♦Support most of the popular Network Operating Systems.
♦Include popular 56K Fax/Modem communication programs.
♦Hot swappable.
♦Feature concurrent use of 10/100 Fast Ethernet LAN and 56K
Fax/Modem.
PLANET ENW-3503F
4
SYSTEM REQUIREMENTS
•An IBM compatible PC or notebook computer with 386SX or faster
processor
•At least one type II PCMCIA socket
•PCMCIA release 2.1 compliant Card Services and Socket Services
•Drivers and utilities provided with this product
•RJ11 jack for connecting to a phone plug
•RJ45 jack for 10/100Tx connectivity to your network resources
•Driver software loaded on your PC
•Data and/or fax communications software.
CONTENTS INCLUDED IN THE PACKAGE
•ENW-3503F, Multifunction 10/100 Fast Ethernet + 56K
Fax/Modem PC Card
•Two 15-pins PCMCIA cable with RJ-11 and RJ-45 jacks
•A 3-1/2”driver diskette
•User's Manual
•Windows-based 56K Fax/Modem application program
Tabla de contenidos
Otros manuales de Hardware de computadora de Planet
Manuales populares de Hardware de computadora de otras marcas
EMC2
EMC2 VNX Series Manual del propietario
Panasonic
Panasonic DV0PM20105 Manual de usuario
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manual de usuario
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manual de usuario
Raidon
Raidon iT2300 Manual de usuario
National Instruments
National Instruments PXI-8186 Manual de usuario
