Planet ENW-1281 Manual de usuario
ISDN TA PC Card
User Manual
CONTENTS
Introduction....................................................................................................................1
System Requirements...............................................................................................1
Specifications.............................................................................................................1
Parts Names.................................................................................................................2
FIRST THING TO KNOW ABOUT SOFTWARE INSTALLATION...............4
Software Installation for Windows 95/98..................................................................6
Installing the Device Driver...........................................................................................6
Installing The Application Programs.............................................................................6
VCOMM Mode....................................................................................................6
Making PPP Connection (Basic Internet)..............................................6
Making Multilink PPP Connections..........................................................9
Making V.110 Connections........................................................................9
Making V.120 Connections......................................................................10
Making Multi-destination Connections .................................................10
CAPI Mode.........................................................................................................12
Installing RVS.COM Lite...........................................................................12
Making PPP connections..........................................................................14
Making Multilink PPP Connections........................................................15
Making V.110 Connections......................................................................19
Making V.120 Connections......................................................................19
Making X.75 Connections.........................................................................20
EuroFile Transfer Applications................................................................20
Making “Modem over ISDN” Connections..........................................22
Making G3 Fax over ISDN.......................................................................23
Voice Applications........................................................................................26
NDIS Mode.........................................................................................................30
Making PPP Connections.........................................................................30
Making Multilink PPP Connections........................................................31
Software Installation for Windows NT4.x...............................................................34
Installing the Device Driver.........................................................................................34
Installing the Application Programs ............................................................................39
NDIS Mode.........................................................................................................39
Internet Access...............................................................................................40
CAPI Mode.........................................................................................................41
Installing RVS-COM Lite...........................................................................41
Applications....................................................................................................41
Making PPP connections..............................................................................41
Making Multilink PPP connections............................................................42
Making “Modem over ISDN” Connections (Using CAPI software)
...........................................................................................................................43
Making G3 Fax over ISDN.......................................................................44
ISDN AT Commands.................................................................................................45
Using ISDN AT Commands.............................................................................45
Appendix: ISDN AT Command................................................................................47
1
INTRODUCTION
The ISDN TA PC Card brings the latest in mobile communication technology
with flexibility and convenience. With the wide range ISDN signaling
protocols switches supports, mobile experts may enjoy the mobile
communication across the world and the high speed digital service.
System Requirements
§Pentium 75 or above
§At least 30MB free hard disk space
§At least 16MB RAM
§PCMCIA Type II/III slot
§PCMCIA Card Services and Socket Services v.2.1 or higher pre-installed
§Windows 95/98 or Windows NT pre-installed
Specifications
Standard
PCMCIA 2.1 & JEIDA 4.1 compliant
ISDN standards
Basic Rate Access (2B+D)
S/T-Interface:
Compliant with ITU-T I.430
D-channel:
ITU-T Q.921, Q.931
ETSI NET3
B-channel:
V.120,
V.110,
X.75/T.70NL/ISO8208
Async-to-Sync PPP conversion
Multilink PPP,
56 K Modem (CAPI only)
G3 fax (CAPI only)
Voice (CAPI only)
Line Rate
64/56 Kbps on 1 B-channel
128/112 Kbps on 2 B-channel
(PPP/MP)
64/56Kbps on 1 B-channel
16Kbps on D-channel
ISDN Network & Switch
Compatibility
National ISDN-1 (NI-1)
AT&T 5ESS Custom
Northen Telecom DMS-100 Custom
DSS1 (Euro-ISDN)
INS-Net 64
2
Application Program Interface
Supported
VCOMM
WinISDN
CAPI 2.0
NDIS WAN
Operating System Supported
Windows 95 and OSR2
Windows 98
Windows NT 4.0
Physical Specifications
RJ-45 ISDN line interface
Dimension: 85.6 x 54 x 5 (mm)
PCMCIA Type II
Parts Names
15-pin PC Card Connector
ISDNNetwork
Connection Cable
3
HARDWARE INSTALLATION
If you are using the ISDN TA PC Card under Windows 95/98, Do NOT insert the PCMCIA card until
after the software installation is completed.
1. Align the PC card with the arrow sign pointing toward the computer’s
PCMCIA slot.
2. Connect the 15-pin PC card connectors with the two exposed end of the
PC card. Push evenly and steadily until the units ‘click’.
Connect the ISDN line to the opposite end of the ISDN Network Connection
Cable.
Connects to ISDN TA PC Card
Connects to ISDN line
4
FIRST THING TO KNOW ABOUT SOFTWARE INSTALLATION
The ISDN TA PC Card is designed to support a wide bandwidth of
interfaces/drivers for a total solution in different environments. The software
setup procedures accordingly vary from interfaces/drivers to interfaces/drivers.
To help you set up the software efficiently, the software installation is
organized by interfaces under Windows 95/98 and Windows NT respectively.
The following figures are illustrated as guideline-like flow charts. If something
goes wrong, track down the flow to check if there is any procedure missing
while setting up; and move to the corresponding section for details.
VCOMM Port
Hyper Terminal
CAPI 2.0
RVS-COM
NDIS Port
ISDN Low
Driver
DUN
CAPI NDISVCOMM
Interface
Center
Driver
Level Driver
* PPP
*
V.120
V.110
*
* PPP
* V.110
*
X.75
*
V.120
*
Modem
* Eurofile Transfer
* G3 FAX over ISDN
* PPP
Windows 95/98
vThe blocked area indicate that after when setup.exe has been executed
(see section titled “Installing Device Driver”), the Phone Dialer
VCOMM Port driver, CAPI 2.0 and the ISDN Low Level Driver were
also installed. You may then use Phone Dialer or the functions with
VCOMM directly.
vFor CAPI mode, however, it is required to install RVS.COM Center
beforehand to enable the functions with CAPI.
vFor NDIS mode, unless the NDIS Port Driver has been installed, the
ISDN Low level Driver won’t be able to work.
5
Hyper Terminal
CAPI 2.0
RVS-COM
NDIS Port
ISDN Low
DUN
CAPI NDIS
Windows NT
Interface
Center
Driver
Level Driver
* PPP
* Modem over ISDN
* G3 Fax
* Voice application
* PPP
vThe blocked area indicate that after when setup.exe has been executed
(see section titled “Installing Device Driver”), the Phone Dialer CAPI
mode and NDIS were also installed. You may then use Phone Dialer or
the functions with NDIS mode directly.
vFor CAPI mode, however, it is required to install RVS.COM Center
beforehand to enable the functions with CAPI.
6
SOFTWARE INSTALLATION FOR WINDOWS 95/98
Installing the Device Driver
1. Insert the device driver compact disc or disks by sequence into your
computer.
2. Double-clickMy Computer.
3. Double-click the drive whichever contains the device driver. For example,
if you are using disks, insert the disks into drive A, double-click “3½
Floppy (A:)”. Or if you are using compact disc, select the CD-ROM drive
and double-click folderWin9x.
4. Double-click Setup.exe. Follow the on-screen instruction.
5. When finished, you will be asked to restart your computer. Before your
computer is reset, insert the PCMCIA card into your PCMCIA socket and
select YES to continue.
When your computer is reset, two additional icons will be added to the tool bar
on the bottom right of your screen, i.e. the Line Status and the Dialer, which
means the device driver has been installed successfully. You may perform the
following procedures to continue.
Installing The Application Programs
Before you start, make sure the type of your Application Program Interface. The Application
Program Interface (API) is used as the interface between the hardware (ISDN TA PC Card) and the
application programs. Before performing the installation, make sure the type of API matching your
system. The currently supported APIs are VCOMM,NDIS,andCAPI. Move to the specific section titled
the appropriate API for your need for installation.
VCOMM Mode
COM port is commonly used for connecting to the external ISDN devices.
With the VCOMM COM port emulation, the ISDN multifunction PC Card
works exactly like an ISDN TA (Terminal Adapter) external box, which can
run with traditional terminal program packages, such as Windows 95 Hyper
Terminal, ProcomPlus for Windows, Telix, pcAnywhere, etc., to hook up to
the on-line services and bulletin boards. In this mode, ISDN AT commands are
usually used to drive the ISDN multifunction PC Card.
Making PPP Connection (Basic Internet)
1. Go to My Computer.
7
2. Select Dial-Up Networking. Double-click Make a New Connection,a
dialogue box will appear as shown below.
3. Name the new connection appropriately.
4. Select Intelligent PCMCIA ISDN TA (modem).
5. Enter in the area code and phone number of your Internet Service Provider
(ISP). Leave out the ‘-‘. (Example: ‘1234567’ NOT ‘123-4567’ )
Typically, the country and area codes are not required and should be
disabled.
Tabla de contenidos
Otros manuales de Hardware de computadora de Planet
Manuales populares de Hardware de computadora de otras marcas
EMC2
EMC2 VNX Series Manual del propietario
Panasonic
Panasonic DV0PM20105 Manual de usuario
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manual de usuario
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manual de usuario
Raidon
Raidon iT2300 Manual de usuario
National Instruments
National Instruments PXI-8186 Manual de usuario
