Philips WP3822 Micro X-Pure Manual de usuario

WP3822

ENGLISH 6

 23

 39

 55

 72

 87

 105

 121

 138

 157

 174

Introduction

Congratulations on your purchase and welcome to Philips! To fully benet

from the support that Philips offers, register your product at www.philips.

com/welcome.

General description (Fig. 1)

Filter cartridge

B Water purier housing

CFilter capacity selection button

DBattery low indication

E Selected lter capacity indication

F Remaining lter capacity indication

GReset button

HWater selection lever

IBattery compartment cover

JStainless steel screen

Rubber washer

LAdapter

1 A-type

2 B-type

3 C-type

4 D-type

MAttachment nut

NFiltered water outlet

O Unltered water inlet

PGranular activated carbon & ion exchanger

Q Hollow bre

R Unltered water outlet

Important

Read this user manual carefully before you use the appliance and save it

for future reference.

ENGLISH

Warning

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person

responsible for their safety.

Children should be supervised to ensure that they do not play with

the appliance.

Before daily use

To prevent quick clogging of the lter cartridge, let the water run at

the unltered setting for around 5 seconds before every use.

If the water is highly coloured or turbid due to work on your water

network, do not let the water run at the ltered setting until the

water is clear.

Let the water run at the ltered setting for 10 seconds before use

each day.

Let the water run at the ltered setting for 60 seconds before use if

you have not used the water purier for more than two days.

If you have not used the water purier for more than two weeks, let

the water run at the ltered setting for 2-3 minutes before use. If the

lter cartridge emits an unpleasant smell, replace it with a new one.

Water temperature

Do not let water hotter than 50°C run through the water purier,

because this may damage the appliance.

Do not let the water purier freeze.

Battery

To prevent that the battery leaks, overheats or explodes:

Do not disassemble the battery.

Do not charge the battery.

Do not use a damaged battery.

Do not expose the battery to water or high humidity levels.

Do not expose the battery to direct sunlight, high temperatures or

re.

ENGLISH 7

Any liquid leaking from the battery is harmful to eyes and skin. Avoid

eye and skin contact.



Only use the appliance to lter water that meets drinking water

standards at the point of use.

Do not block the ltered water outlet or connect other devices to it.

If the water pressure is very high, reduce the water ow of the tap to

prevent damage to the cartridge.

Keep the water purier away from heat to avoid distortion or

breakage.

Do not tamper with the water purier.

Do not remove the lter cartridge while you use the water purier.

Do not use the water purier without a lter cartridge.

Do not place the appliance near a window where it is exposed to

direct sunlight.

This appliance does not soften water.

Do not use ltered water in aquariums. Tap water, ltered or

unltered, can be harmful to sh.

Do not store puried water to avoid contamination. Air contact

contaminates puried water quickly. If you want to store puried

water, use a clean container and keep it in the refrigerator. Do not

keep it in the refrigerator longer than 1 day to avoid contamination.

Features

Philips’ multi-ltration system consists of a primary lter, a secondary

lter, a high-tech hollow-bre membrane lter, an ion exchanger

lter and a granular activated carbon lter.

The hollow bre membrane contains more than 300 billion

micropores that are small enough to remove particles down to

0.1µm. It eliminates 99.99%* of bacteria, rust and other particles

larger than the micropore size from your tap water without removing

calcium, magnesium and other minerals that are vital to your body.

(* tested according to Japanese Water Purier Association (JWPA)

standard).

The ion exchanger removes soluble lead.

ENGLISH8

The granular activated carbon removes harmful chlorination by-

products, harmful industrial pollutants, such as volatile organic

chemicals, and agricultural pollutants, such as the pesticide CAT. It also

removes the unpleasant chlorine smell and taste from your tap water.

The LCD display on the water purier shows the current remaining

lter capacity. A remaining lter capacity of 0 tells you that you

have to replace the lter. Philips’ unique cartridge replacement

indicator also helps you to determine when to replace the lter.

The high-speed initial ow rate of 1.6 litres per minute gives you

plenty of clean water instantly.

The water selection lever offers you a choice of three water ow

types: unltered spray, unltered stream or ltered spray.

The eight tap-mounting adapters supplied with the water purier

allow easy installation on almost any type of tap.

The bayonet-type mount ensures quick, easy and secure lter

cartridge replacement.

Preparing for use

Inserting the battery

Before you insert the battery, make sure your hands and the water

purier are dry.

Keep away from the kitchen sink to prevent the battery from falling

down the drain.

Insert the battery before you install the water purier on the tap.

1 Use a coin to turn the battery compartment cover on the back of

the water purier in the ‘OPEN’ direction. Remove the battery

compartment cover (Fig. 2).

2 Place the battery (included) in the cover, with the + pole facing the

battery compartment cover (Fig. 3).

3 Place the battery compartment cover back onto the water purier

in such a way that the ‘%’ mark on the cover is aligned with the ‘I’

mark on the water purier. (Fig. 4)

ENGLISH 9

4 Use a coin to turn the battery cover in the ‘CLOSE’ direction until

the ‘I’ mark on the cover is aligned with the ‘I’ mark on the water

purier (Fig. 5).

Note: Make sure you align the ‘I’ marks properly, otherwise water may leak

into the battery compartment.

When the battery is properly inserted, the LCD display performs a

self-check for approx. 9 seconds. Then the display goes off again.

Before installation

The screw thread of the tap is sharp.

Before you install the water purier, make sure all tap-mounting

adapters you require are present.

The tap must have a diameter of 13mm-25mm.

Determine what type of tap you have and select the appropriate

adapter.

The adapters supplied make the water purier suitable for almost

any kitchen tap. However, the water purier may not t some

uncommon types of taps.

The tap water pressure has to be between 0.7kgf/cm² (7 metres of

water column/70kPa) and 3.5kgf/cm² (35 metres of water column/

350kPa). If you use the water purier at a water pressure outside this

range, either the ltered water ow will be extremely low or the

water purier will get damaged.



For taps with a round spout with a diameter of 16mm, 17.5mm or

19mm (Fig. 6).

1 Remove the attachment nut and the adapter from the water

purier housing (Fig. 7).

2 Pass the attachment nut over the tap spout (Fig. 8).

3 Place the matching adapter (A-type) over the tip of the spout. The

16mm adapter is packed with the water purier. If necessary,

replace it with the 17.5mm adapter or 19mm adapter to t the

diameter of your tap (Fig. 9).

ENGLISH10

Otros manuales para WP3822 Micro X-Pure

Tabla de contenidos

Idiomas:

Otros manuales de Sistema de filtración de agua de Philips

Philips

Philips AWP3753 Manual de usuario

Philips

Philips WP3891/01 Manual de usuario

Philips

Philips AWP2900 Manual de usuario

Philips

Philips AC4142 Manual de usuario

Philips

Philips WP3822 Micro X-Pure Manual de usuario

Philips

Philips AC4012 Manual de usuario

Philips

Philips AC4012 Manual de usuario

Philips

Philips AWP2900 Manual de usuario

Philips

Philips WP3810 Manual de usuario

Philips

Philips WP3820 Manual de usuario

Philips

Philips Pure Taste WP3861 Manual de usuario

Philips

Philips WP3892 Manual de usuario

Philips

Philips GoZero Manual de usuario

Philips

Philips FC8044/02 Manual de usuario

Philips

Philips AUT3015 Manual de usuario

Philips

Philips Micro Pure WP3811 Manual de usuario

Philips

Philips WP3893/01 Manual de usuario

Philips

Philips Micro Pure WP3811 Manual de usuario

Philips

Philips ADD6910 Manual de usuario

Philips

Philips WP4161/90 Manual de usuario

Philips

Philips WP3970/01 Manual de usuario

Philips

Philips AWP1775 Manual de usuario

Philips

Philips HR6949/01 Manual de usuario

Philips

Philips Pure Taste WP3861 Manual de usuario

Manuales populares de Sistema de filtración de agua de otras marcas

Wisy

Wisy LineAir 100 Manual de usuario

Schaffner

Schaffner Ecosine FN3446 Series Manual de funcionamiento

Pentair

Pentair FLECK 4600 SXT Guía del usuario

H2O International

H2O International H20-500 Manual de usuario

Renkforce

Renkforce 2306241 Manual de usuario

Neo-Pure

Neo-Pure TL3-A502 Manual de usuario

FLTR

FLTR OBF Manual de usuario

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Manual de usuario

Applied Membranes

Applied Membranes W-G844EM Manual de usuario

BEGA

BEGA 116 Manual de usuario

WATA

WATA Standard Manual de usuario

Price

Price FFU series Manual

Gaggenau

Gaggenau BRITA INTENZA 467873 Manual de usuario

Brita

Brita SAFF-100 Manual de usuario

HEISSNER

HEISSNER FPU24000-00 Manual de usuario

BGS technic

BGS technic 1518 Manual de usuario

Reverse Osmosis

Reverse Osmosis RF Series Manual de usuario

ubbink

ubbink Filtramax Series Manual de usuario