Philips WelcomeEye Lite Manual de usuario
V1
User
Manual
V1
Videophone
WelcomeEye
Lite
Register your product on www.philips.com/register
Contents
1. Safety instructions.....................................................................................2
2. Contents of the kit.....................................................................................2
3. General information..................................................................................3
4. Component names.............................................................. ......................3
5. Product installation...................................................................... ...........5
5.1. Wiring...................................................................................................5
5.2.Conguringtheintercom.................................................................5
5.3 Monitor installation................... ........................................................6
5.4 Intercom panel installation.................................. ............................7
6. Monitor interface.......................................................................................8
6.1. Settings menu................................................... .................................8
6.2. Monitoring function and answering a call.................................10
7. Use....................................................................... ......................................10
8.Technicalspecications.........................................................................11
9. FAQ ......................... ................................................................................. .12
10. Technical support - Warranty............................................................ .13
11. Safety precautions …………………………....................................... .14
12. FCC/CE warning …………………………............................. ................15
2Philips - Lite - V1
1. SAFETY INSTRUCTIONS
Important!
• Please read the user manual carefully before installing or using this product.
• If you are installing this product for someone else, remember to leave the manual or a copy of it
with the end user.
Warning:
• The various components should be dismantled by an authorised technician only.
Safety precautions:
• To operate this system in complete safety, it is essential that installers, users and technicians follow
all the safety procedures described in this manual.
• Specic warnings and warning symbols are given for items where necessary.
2. KIT CONTENTS
1. 7’’ monitor (Lite) 2. Wall bracket
3. Plug-in power supply 4. Intercom panel
3
Philips - Lite - V1
3. GENERAL
This videophone is composed of an interior response station with touch-sensitive buttons and an
exterior panel with an intercom and camera, allowing the person inside to see and communicate
with the visitor outside who rings the doorbell. It is easy to install as only two wires are needed for
all functions: bell, video image, intercom and strike plate and automatic opener controls.
For e ective use, please carefully read this instruction manual.
4. COMPONENT NAMES
Monitor:
Screen
Power supply terminal
block
Terminal block for connection
to the intercom panel and
accessories
Loudspeaker Microphone
DES 9900 VDP
+-12
4Philips - Lite - V1
Intercom panel:
Infrared LED (night vision)
Twilight sensor
Camera lens
Microphone
Loudspeaker
Name plate lighting
Tamper-resistant
retaining screw
Wire connection terminal
block
Loudspeaker volume settings
Made in P.R.C
IP44
1
1
2345 6
Made in P.R.C
IP44
1
1
2345 6
Made in P.R.C
IP44
1
1
2345 6
Notes:
- When someone presses the call button, the inside monitor rings and the video is displayed.
- To change the nameplate label, remove the front cover and unclip the plastic cap behind the label.
Call button, name plate
5
Philips - Lite - V1
5. PRODUCT INSTALLATION
Important notes and advice:
- If you test your product before installing it, ensure that you do not test it with the intercom panel
and the monitor in the same room or the videophone may emit a shrill noise (feedback).
- Do not expose the camera lens to direct sunlight or a reective surface.
- We recommend running the cables through a protective sheath to protect them against breakage
and bad weather.
5.1 Wiring
In order to avoid the risk of interference and malfunction, do not pass the wire for your videophone
through the same sheath as the electrical wires.
Warning: Do not under any circumstances double wires to increase the wire size.
a. Connecting the videophone (monitor, intercom panel and camera, see g. 1, g. 2 or g. 3)
Wires to be used: 2 wires 0.75 mm2up to 80 m long or 2 wires 1.5 mm2up to 120 m long.
- Be sure to connect the wires in accordance with the wiring diagram.
- Be sure to refer to the labelling on the back of the monitor and the back of the intercom panel.
b. Connecting an electric strike plate or lock
Important: The electric strike plate or lock that you install must be equipped with a mechanical
memory. The strike plate current cannot exceed 1.1A.
- Connect it directly to terminals 5 and 6 at the back of the intercom panel (no need to observe
polarity).
- The opening function is only possible if the video from the respective intercom panel is displayed.
c. Connecting a gate motor
- The intercom provides a dry contact (without power) to be connected to the push button control
of the automatic opener.
- Connect it directly to terminals 3 and 4 at the back of the intercom panel (no need to observe
polarity).
- The opening function is only possible if the video from the respective intercom panel is displayed.
5.2Conguringtheintercom(seeFig.1)
a. Intercom volume settings:
Turn the volume control with a Phillips head screwdriver to adjust the intercom volume.
6Philips - Lite - V1
5.3 Installing the monitor
1m60
DES9900 VDP
+-12
1 2
4
7
5 6
3
1 - Position the wall bracket so that the screen of the monitor is approximately 1.60m above the
oor.
2 – Mark the location of the holes using the monitor bracket.
3 – Drill.
4 – Use pegs adapted to the bracket (those supplied are suitable for solid walls).
5 - Attach the wall bracket.
6 – Connect the two intercom panel wires and the two power supply wires following the wiring
diagram.
7 - Position the monitor on the wall bracket.
Warning: for this step, do not connect the 230VAC power supply.
7
Philips - Lite - V1
5.4 Intercom panel installation
Warning: The product must not be connected to the power supply before the wiring has been
completed.
1m60
1
1
2
2
1 2
4
7
5
3
6
8 9
Made in P.R.C
IP44
Avidsen
1
1
2 3 4 5 6
19avenue Marcel Dassault
37200TOURS
FRANCE
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom’s lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use pegs adapted to the type of support (the screws supplied are suitable for solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike plate and
the gate (see section 1. Wiring).
8 – Insert the screws and ret the two caps concealing the retaining screws.
8Philips - Lite - V1
Note: screw through the black covers on the back of the intercom panel without removing them.
9 – Re t the front cover of the intercom and tighten the tamper-resistant retaining screw.
10 - Connect the 230VAC power supply.
- Check that everything is working properly (video call, etc.).
11 - Apply a silicone seal* between the shield and the wall to stop owing water. *Do not use acetic
acid-based silicone (vinegar odour).
6. MONITOR INTERFACE
6.1 Settings menu
First page of the settings menu
With the screen o , press the button to display the rst page of the settings menu:
05
05
05
Adjustment buttons
1
Back: turns the screen o and
returns the videophone to standby
mode.
2Next: goes to the next setting or
next page.
3Decrease: decreases the value being
adjusted (highlighted).
4Increase: increases the value being
adjusted (highlighted).
1 2 3 4
1Image brightness settings from 0 to
10.
2Image colour settings from 0 to 10.
3Image contrast settings from 0 to 10.
4Assignment of the 4 control buttons.
1
43
2
Tabla de contenidos
Otros manuales de Teléfono de Philips
Philips
Philips D131 Hoja de información del producto
Philips
Philips M455 Hoja de información del producto
Philips
Philips VOIP4331 Manual de instrucciones
Philips
Philips BaseLine Pro Manual de usuario
Philips
Philips VOIP3211 Manual de usuario
Philips
Philips SE765 Manual de usuario
Philips
Philips E105 Manual de usuario
Philips
Philips DECT5250S/05 Manual de usuario
Philips
Philips DECT3112B/07 Manual de usuario
Philips
Philips Onis 300 Manual de usuario
Philips
Philips DECT6171H/05 Manual de usuario
Philips
Philips VOIP8410B Guía de inicio rápido
Philips
Philips D126 Manual del operador
Philips
Philips Xenium X650 Manual de usuario
Philips
Philips D260 Hoja de información del producto
Philips
Philips D120 Manual de usuario
Philips
Philips VOIP8411B/05B Manual de usuario
Philips
Philips DECT5154S/07 Manual de usuario
Philips
Philips Xalio 200 Manual de usuario
Philips
Philips X200 Manual del operador
