Philips HADCO WAMT14-H Manual de usuario

ALWAYS TURN FIXTURE OFF/DISCONNECT POWER AND ALLOW TO COOL BEFORE

PERFORMING ANY MAINTENANCE, INCLUDING RELAMPING AND CLEANING!

FOR USE ONLY WITH LINE VOLTAGE LANDSCAPE LIGHTING POWER UNITS THAT ARE RATED

MAXIMUM 120 VOLTS PER CIRCUIT.

! SAFETY WARNING:

This fixture can become very HOT! The fixture housing and lens, especially if it is glass, can become hot enough

to blister hands. Attention should be paid to where the fixture is mounted, particularly if it can be touched by

children or pets. To help prevent premature failure, decreased performance, overheating and risk of fire, keep

fixture and lens clean and free of leaves, mulch, debris and mineral deposits from water. The fixture and lens

can be cleaned using a soft cloth and a solution of mild liquid soap and warm water. Wipe clean and dry with a

soft, lint-free dry cloth. Avoid polishing fixture or lens.

Do not install fixture within 10 feet (3.05 meters) of a pool, spa or fountain.

SHROUD

HOUSING

1/2" N.P.S. FITTER

SHROUD SCREW

35W GY6.35 T-4 Bi-pin

The following lamps may

be used in this fixture:

50W GY6.35 T-4 Bi-pin

32001330, revision D

100 Craftway, P.O. Box 128

Littlestown, Pennsylvania 17340-0128

Phone: 800-331-4185 Fax: 717-359-9672

INSTALLATION INSTRUCTIONS:

WAMT14 FLOODLIGHT

This fixture is intended for installation in accordance with the National Electrical Code and local code

specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage

to the ballast and void the warranty. These instructions do not purport to cover all details or variations in

equipment, nor to provide for every possible contingency related to installation, operation, maintenance,

or mounting situation. Should specific problems occur that are not addressed by these instructions, contact

your Sales Representative or distributor for assistance. Retain these instructions for future reference.

page 1 of 2

INSTALLATION INSTRUCTIONS

1. Make sure power is turned OFF before installing or servicing this fixture.

2. This fixture must be mounted to a junction box or mounting stake that is UL Listed for line voltage.

Mounting stakes S3, M0028A, or junction box TM2H, TMC2H, BI1, BI2, BI3, BI4 may be used.

3. Insert wires through 1/2-14 NPS hole of mounting device and screw fixture onto junction box lid/stake cap.

4. Wire the fixture as follows, using wire nuts to make the splices inside the junction box.

-Connect white (positive) supply wire to white fixture wire.

-Connect black (negative) supply wire to black fixture wire.

-Connect green (ground) supply wire to green fixture wire.

5. Secure the junction box lid/stake cap back onto the junction box/mounting stake.

6. Loosen shroud screws and remove shroud by pulling off of housing.

7. Install specified lamp (not included).

8. Push shroud completely back into housing and tighten shroud screws to secure shroud in place.

9. Loosen screw in arm, aim fixture as desired and tighten screw.

10. Turn power ON.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS!

WARNING - Lamp gets HOT quickly! To reduce the risk of FIRE OR INJURY TO PERSONS:

Do not operate fixture with a missing or damaged lens/lens assembly.

Contact only switch or plug when turning fixture on or off. Do NOT touch hot lens or housing.

Turn off or unplug fixture and allow to cool before relamping. Keep lamp away from combustibles.

Do NOT touch lamp with bare hands at any time; use a soft cloth as oil from skin may damage lamp.

page 2 of 2

32001330, revision D

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Foco de Philips

Philips

Philips P-2558-C Manual de usuario

Philips

Philips 31607-48-16 Instrucciones de instalación

Philips

Philips BVP510 Guía del usuario

Philips

Philips SmartBright BVP171 Manual de usuario

Philips

Philips BVP500 Guía del usuario

Philips

Philips HADCO WAMT14 Manual de usuario

Philips

Philips EH313L Manual de usuario

Philips

Philips eXpanium eXp 401 Manual de usuario

Philips

Philips BVP131 Guía del usuario

Philips

Philips HNF901 Guía del usuario

Philips

Philips Tempo 3 RVP351 Series Manual de usuario

Philips

Philips BVP080 Guía del usuario

Philips

Philips ArenaVision LED gen2 BVP425 HGB Manual de usuario

Philips

Philips SmartBright BVP173 Manual de usuario

Philips

Philips BVP158 Manual de usuario

Philips

Philips 40745-17-16 Manual de usuario

Philips

Philips BVP158 LED24/WW NW CW PSU 20W SWB CN Manual de usuario

Philips

Philips GearUnits ECM 330 Manual de usuario

Philips

Philips Clearflood Large BVP651 Manual de usuario

Philips

Philips BVP483 Manual de usuario

Philips

Philips VARI-Lite VL4000 Manual de usuario

Philips

Philips Showline SL PAR 150 ZOOM Manual de usuario

Philips

Philips SL WASH 180 RGBW Manual de instrucciones

Philips

Philips BVP154 Series Manual de usuario

Manuales populares de Foco de otras marcas

VIZULO

VIZULO Micro Martin Guía del usuario

EuroLite

EuroLite LED IP FL-100 SMD Manual de usuario

Cooper Wheelock

Cooper Wheelock XB12 Manual de usuario

Allen + Roth

Allen + Roth 17624-000 Manual de usuario

ADJ

ADJ 4 STAGE PAK Manual de usuario

Cooper Lighting

Cooper Lighting EGL91SW233 Manual de usuario

Max

Max 37496 Manual de usuario

BEGA

BEGA 85 143 Manual de usuario

Beamz

Beamz 151.226 Manual de usuario

EuroLite

EuroLite LED IP FL-8 Manual de usuario

Ledj

Ledj PERFORMER 36 RGB Manual de usuario

Perel

Perel ELS3 Manual de usuario

Perel

Perel ELS3WD Manual de usuario

LumX

LumX LM 36130 Manual de usuario

Xtricity

Xtricity 4-80053 Manual de usuario

Stahl

Stahl 6521/4 Series Manual de usuario

Ecosense

Ecosense EcoSpec Manual de usuario

Ayrton

Ayrton minipanel FX Manual de usuario