Philips HC9490/15 Manual de usuario
Always here to help you
Register your product and get support at
www.philips.com/welcome
HC9490
Downloaded from www.vandenborre.be
1
Downloaded from www.vandenborre.be
4
Introduction
Congratulations on your purchase and welcome to Philips!
To fully benet from the support that Philips offers, register your product
at www.philips.com/welcome.
General description (Fig. 1)
1 Cutting unit
2 Flywheel
3 On/off button
4 M-symbol
5 Length setting lock
6 Charging light
7 Length settings
8 Display
9 Trimming comb 1-7 mm
10 Trimming comb 7-24 mm
11 Trimming comb 24-42 mm
12 Adapter
13 Small plug
14 Charging stand
15 Cleaning brush
16 Pouch
Important
Read this user manual carefully before you use the appliance and save it for
future reference.
Danger
- Keep the appliance, the adapter and the charging stand dry.
Warning
- The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
- This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and if
they understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by
children without supervision..
Caution
- This appliance is not washable. Never immerse the appliance or
charging stand in water, nor rinse it under the tap.
- Always check the appliance before you use it. Do not use the appliance,
adapter, charging stand or any other part if it is damaged, as this may
cause injury. Always replace a damaged adapter, charging stand or part
with one of the original type.
- Always replace a damaged adapter or part with one of the original type.
- Only use this appliance for its intended purpose as shown in the
user manual.
- Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
ENGLISH
Downloaded from www.vandenborre.be
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic elds (EMF).
General
- The appliance is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 100-240 volts to a safe low voltage of less
than 24 volts.
Charging
Charge the appliance fully before you use it for the rst time or after a long
period of disuse.
When it is charged for 1 hour, the appliance has a cordless operating time
of up to 180 minutes.
Note: After charging the appliance once fully for the rst time, you can also use
the appliance directly from the mains. Simply connect the appliance to
the mains.
Charging indications
Battery low indication
- When the battery is almost empty, the charging light starts to ash
orange.
Charging
- When the appliance is charging, the charging light ashes blue.
Battery fully charged
- When the battery is fully charged, the charging light lights up blue
continuously.
Note: After 30 minutes, the charging light goes out.
ENGLISH 5
Downloaded from www.vandenborre.be
Charging in the charging stand
1 Put the small plug in the charging stand.
2 Put the adapter in the wall socket.
3 Place the appliance in the charging stand.
4 After charging, remove the adapter from the wall socket and pull the
appliance plug out of the charging stand.
Charging with the adapter
1 Make sure the appliance is switched off.
2 Insert the small plug into the appliance.
3 Put the adapter in the wall socket.
4 After charging, remove the adapter from the wall socket and pull
the small plug out of the appliance.
Optimising the lifetime of the rechargeable battery
When you have charged the appliance for the rst time, we advise you to
use it until the battery is completely empty. Continue to use the appliance
until the motor almost stops operating during a session.Then recharge the
battery. Follow this procedure at least twice a year.
Using the appliance
The hair length settings are indicated in millimeters.The settings
correspond to the remaining hair length after trimming.
Be careful when you trim for the rst time. Do not move the trimmer
too fast. Make smooth and gentle movements.
Tip: Start trimming at a high length setting and reduce the length setting
gradually until you have reached the desired hair length.
1-7
ENGLISH6
Downloaded from www.vandenborre.be
Trimming with comb
There are 3 different combs.
- 1-7mm
- 7-24mm
- 24-42mm
1 Attach one of the combs to the appliance.
2 Scroll upwards or downwards to select the desired length setting.
Note: When you trim for the rst time, start at the highest length setting to
familiarise yourself with the appliance.
3 Switch on the appliance.
4 To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in contact
with the skin.
Trimming without comb
Use the trimmer without the trimming comb to trim hair close to the skin
(0.5mm) or to contour the neckline and sideburns.
Be careful when you trim without comb because the cutting
element removes every hair it touches.
ENGLISH 7
Downloaded from www.vandenborre.be
1 Push the comb off the appliance.
2 Switch on the appliance.
3 Touch the hair lightly with the trimmer. Make well-controlled
movements
Features
Memory settings
The appliance has a memory which allows you to save three frequently
used length settings for each comb. Each comb has different length ranges.
Saving a setting
1 Scroll upwards or downwards to select the desired length setting.
2 To enter the memory, press the on/off button for 2 seconds.
,Number 1 starts to ash.
Note: If you want to save a setting as number 2 or 3 of the memory,
scroll upwards or downwards to select number 2 or 3.
ENGLISH8
Downloaded from www.vandenborre.be
3 To save a length setting as number 1,2 or 3 of the memory settings,
press the on/off button for 2 seconds.
,The display shows the word ‘SEt’ when the length setting is correctly
saved. Memory setting number 1,2 or 3 lights up continuously.
Selecting a memory setting
1 To enter the memory, press the on/off button for 2 seconds.
,Number 1 starts to ash.
Note: To select number 2 or 3 in the memory, scroll upwards or downwards
until number 2 or 3 ashes on the display.
2 Press the on/off button to conrm the selected memory setting.
,The number of the selected setting lights up continuously.
Length setting lock
This feature prevents accidental changing of the length setting during
trimming. Every time you switch on the appliance, the length setting lock
is activated.You can only change the length setting if you switch off
the appliance.
1 Scroll upwards and downwards to select the desired length setting.
2 Switch on the appliance.
,The lock symbol starts to ash. You cannot change the length setting
anymore.
Note: If you want to select a different length setting, switch off the appliance.
Scroll upwards or downwards to select the desired length setting and switch on
the appliance again.
Cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as alcohol, petrol or acetone to clean the appliance.
Never immerse the appliance or the charging stand in water or rinse it
under the tap.
1 Make sure the appliance is switched off and disconnected from
the mains.
2 Wipe the housing of the appliance with a dry cloth.
ENGLISH 9
Downloaded from www.vandenborre.be
3 Remove the comb and clean it with the cleaning brush.
4 Press the release button (1).The cutting unit comes off the
appliance (2).
5 Clean the cutting unit with the cleaning brush.
6 Clean the inside of the appliance with the cleaning brush.
7 To reattach the cutting unit, insert the lug of the cutting unit into
the guiding slot.
8 Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
9 Wipe the charging stand with a dry cloth.
Note: If the message ‘CL’ is shown on the display, too much hair has collected
between the comb and the cutting unit. Remove the comb and cutting unit and
clean them with the cleaning brush supplied. Also clean the top edge of the
handle with the cleaning brush supplied.
ENGLISH10
Downloaded from www.vandenborre.be
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Rasuradora eléctrica de Philips
Philips
Philips HQ7180 Manual de usuario
Philips
Philips BT9295 Manual de usuario
Philips
Philips Norelco Spectra 8825XL Manual de usuario
Philips
Philips BT3301 Manual de usuario
Philips
Philips HQ5870/01 Manual de usuario
Philips
Philips Norelco 5864XL Manual de usuario
Philips
Philips QT4050/41 Manual de usuario
Philips
Philips TW-RQ1050 Manual de usuario
Philips
Philips MG3711 Manual de usuario
Philips
Philips HQ42/15 Manual de usuario
Philips
Philips SS572/90 Manual de usuario
Philips
Philips Norelco QT4050 Manual de usuario
Philips
Philips CoolSkin HS8040 Manual de usuario
Philips
Philips RQ1051 Manual de usuario
Philips
Philips HQ7760 Manual de usuario
Philips
Philips Philishave HQC446/20 Manual de usuario
Philips
Philips Ladyshave Body Contour HP6319/01 Manual de usuario
Philips
Philips HS890/01 Manual de usuario
Philips
Philips Norelco S7370 Manual de usuario
Philips
Philips HQ8160/16 Manual de usuario
