Philips CoolSkin HS8040 Manual de usuario
3
1
2
3
45
6
7
8
12
A
B
9
10
11
1
4
HS8040
ENGLISH 6
DANSK 23
DEUTSCH 39
58
SUOMI 79
NORSK 96
SVENSKA 113
144
160
6
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
Make sure the adapter does not get wet (your
adapter may differ from the one shown in the
gure).
Warning
The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Caution
Never immerse the charger in water nor rinse it
under the tap.
Always place and use the charger on a surface
that is uid-resistant.
Use, charge and store the appliance at a
temperature between 5°C and 35°C.
Only use the adapter and the charger supplied.
Do not use the shaver or the charger if it is
damaged.
If the adapter is damaged, always have it replaced
with one of the original type in order to avoid a
hazard.
-
-
-
-
-
-
-
-
-
-
ENGLISH
Compliance with standards
This shaver complies with the internationally
approved safety regulations and can be safely used
in the bath or shower and cleaned under the tap.
This Philips appliance complies with all standards
regarding electromagnetic elds (EMF). If handled
properly and according to the instructions in this
user manual, the appliance is safe to use based on
scientic evidence available today.
General
The adapter transforms 100-240 volts to a safe
low voltage of less than 24 volts.
Overview (Fig. 1)
AShaver
1 Protection cap
2 Trimmer
3 Shaving unit
4 Shaving conditioner cartridge
5 Shaving conditioner button
6 On/off button
7 Charging lights
BAccessories
8 NIVEA FOR MEN shaving conditioner bottle
9 Charger
10 Trimmer holder
11 Cleaning brush
12 Adapter (your adapter may differ from the one
shown in the gure)
-
-
-
ENGLISH 7
Getting started
Charging
1 Put the small plug in the charger and put the
adapter in the wall socket.
2 Put the shaver in the charger.
The shaver is being charged.
3 Charge the shaver for 4 hours.
Note: Charge the shaver before you use it for the
rst time or when the bottom charging light lights up
red (see section ‘Charge indications’).
Note: A fully charged shaver has a shaving time of up
to 40 minutes.
Quick charge
After the shaver has charged for 9 minutes, it
contains enough energy for one shave.
Note: Quick charging is only possible when you have
already charged the shaver for 4 hours once.
Charge indications
Charging
During charging, the bottom charging light rst
ashes red and then goes out. The top charging
light then starts to ash green and nally lights
up green continuously.
Quick charge
After the shaver has charged for 9 minutes, the
bottom charging light goes out and the top
,
-
-
ENGLISH8
charging light starts to ash green, to indicate that
the shaver contains enough energy for one shave.
Battery low
When the battery is low, the bottom charging light
lights up red during shaving and ashes red
when you switch off the shaver.
Battery full
When the battery is fully charged, the top charging
light lights up green continuously.
Filling the shaving conditioner cartridge
1 Remove the tab of the NIVEA FOR MEN
shaving conditioner bottle.
2 Turn the cap of the conditioner bottle
clockwise (‘click’).
The cap moves downwards and the conditioner
nozzle appears.
3 Place the nozzle of the conditioner bottle in
the lling opening of the conditioner cartridge.
4 Move the bottle up and down approx. 5 times
to pump shaving conditioner into the cartridge
until you see that the cartridge is full.
-
-
,
ENGLISH 9
Do not ll the cartridge beyond the MAX
indication.
Using your shaver
Shaving
Note: Your skin may need 2 to 3 weeks to get
accustomed to a new shaving system.
1 Make sure there is sufcient shaving
conditioner in the shaving conditioner
cartridge.
2 Press the on/off button to switch on the shaver.
3 Make sure the shaver is sufciently charged
(see chapter ‘Getting started’, section ‘Charge
indications’).
4 Gently move the shaving unit in circles over
your skin and press the shaving conditioner
button until there is enough shaving
conditioner on your skin for a comfortable
shave.
When you release the shaving conditioner button,
the appliance stops dispensing conditioner.
If you briey press the shaving conditioner button,
the appliance automatically applies a certain
amount of conditioner.
Press the shaving conditioner button again to
apply more shaving conditioner during shaving
to ensure that the shaving unit continues to glide
smoothly over your skin.
Note: The shaving conditioner button only works when
the shaver is switched on.
Note: This shaver can be used in a way similar to a
razor blade: you can use the shaver on a wet face.
-
-
-
ENGLISH10
Unlike a conventional electric shaver, this appliance
has no hair chamber that collects stubble. To prevent
stubble from falling on your clothes, apply sufcient
shaving conditioner while shaving.
5 Thoroughly clean the shaver after every use
(see chapter ‘Cleaning’).
6 Slide the protection cap onto the shaver to
prevent damage.
Tips for optimal gliding and a smooth
shaving result
Gently move the shaver in circles over your skin.
Do not exert too much pressure on the shaver, as
this may cause skin irritation.
To ensure proper gliding, apply shaving conditioner
regularly.
You can also use the shaver in the bath or shower.
Trimming
Note: Because of the new open design, you hear the
cutting action of the trimmer more clearly than with
other trimmers. This is normal.
1 Pull the shaving unit off the shaver.
2 Take the trimmer out of the trimmer holder
on the charger and put it on the shaver (‘click’).
3 Press the on/off button to switch on the shaver.
4 Use the trimmer to groom your sideburns
and/or moustache.
5 Thoroughly clean the trimmer after use (see
chapter ‘Cleaning’).
-
-
-
-
ENGLISH 11
6 Remove the trimmer and put it back into the
trimmer holder.
7 Put the shaving unit back onto the shaver
(‘click’).
8 Slide the protection cap onto the shaver to
prevent damage.
Cleaning and maintenance
Cleaning
Do not use abrasives, scourers or liquids such as
alcohol, petrol or acetone to clean the appliance.
Shaver/trimmer
Clean the shaver and the trimmer after every use.
Be careful with hot water.Always check if the
water is not too hot, to prevent your hands from
getting burnt.
Never dry the shaving unit with a towel or tissue,
as this may damage the shaving heads.
Note: The shaver is watertight and can be cleaned
under the tap.
1 Press the on/off button to switch on the shaver.
2 Clean the shaving unit and the trimmer while
the shaver is switched on.
ENGLISH12
Otros manuales para CoolSkin HS8040
4
Tabla de contenidos
Idiomas:
Otros manuales de Rasuradora eléctrica de Philips
Philips
Philips RQ1200 series Manual de usuario
Philips
Philips BT1216 Manual de usuario
Philips
Philips AquaTouch AT750 Manual de usuario
Philips
Philips S97XX Manual de usuario
Philips
Philips McLaren HQ7260 Manual de usuario
Philips
Philips QG3340 Manual de usuario
Philips
Philips S99 series Manual de usuario
Philips
Philips 9170XL/43 Manual de usuario
Philips
Philips 7240XL Manual de usuario
Philips
Philips Norelco SmartTouch-XL 9195XL Manual de usuario
Philips
Philips S5588/30 Instrucciones de funcionamiento
Philips
Philips HQ7120 Manual de usuario
Philips
Philips TT2020 Manual de usuario
Philips
Philips HQ6613 Manual de usuario
Philips
Philips HQ 7742 Manual de usuario
Philips
Philips 3000 series Manual de usuario
Philips
Philips QG3360/42 Manual de usuario
Philips
Philips Norelco RQ12+ Manual de usuario
Philips
Philips S5000 series Manual de usuario
Philips
Philips Lumea Prestige BRI959 Manual de usuario
