Panasonic AW-HS50 Series Manual de usuario

★This is to explain AW-HS50 switcher’s basic setup and how to deal with problems (e.g. no image output) when they

occur.

■Display of Menu Screen (OSD: On-Screen Display)

The menu screen is displayed by holding down OSD ON button –(Figure 1). It is superimposed on the image output

from SDI OUT 2 connector and DVI OUT connector.

(To clear the menu, hold down OSD ON button again.) * The menu screen is not output from SDI OUT 1 connector.

Turn OSD dial to select the setting, and press the dial to enter the selection. The setting value can be varied by turning

the dial while the value is blinking.

■Settings for Crosspoint

A source is selected by pressing one of A bus or B bus crosspoint buttons. It is the signal which has been set in

advance using the menu, and called up as the source.

Assignment to the crosspoint buttons is carried out using the menu: [9] XPT SW Assign Menu –(Figure 2).

By factory default, pressing the crosspoint button 1 will make the unit call up the source input into “SDI-IN1”.

If XPT6 –XPT10 need to be called up, press the crosspoint buttons while SHIFT button is held down.

AW-HS50 –Basic Operations & Troubleshooting

(Figure 1: AW-HS50 Control Panel)

(Figure 2: Menu Screen for [9] XPT SW Assign Menu *factory default)

A bus crosspoint buttons

OSD ON button

SHIFT button

B bus crosspoint buttons

OSD dial

BUS DELEGATION buttons

FTB ON button

To crosspoint buttons 1 –10, external video input signals, internally generated signals, etc. can be assigned as a

source.

■Settings for Output

This switcher can output signals from the three connectors: SDI OUT1, SDI OUT2 and DVI-D OUT.

The output signals are set on the menu: [11] Output Menu –(Figure 3).

The output systems can individually be assigned the following signals.

※For MV (Multi View Display), please see the following manual “AW-HS50 –Multi View Display”.

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/17_.pdf

★Need help? Troubleshooting ★

■“No image output”

・Does the signal format of the switcher match that of the input source?

If AW-HS50 switcher receives an input signal that is different from its system format, a black screen or distorted

image is displayed.

Please check if the switcher’s system format (see below for the menu) matches that of the input source.

※AW-HS50 Menu ：[14]SYSTEM Menu ＞1．Format

(Supported formats: 1080/59.94i, 1080/50i, 720/59.94p, 720/50i, 1080/24PsF, 1080/23.98PsF, 480/59.94i, 576/50i)

※Video signals will not be switched even if a button is pressed where “NoAssign” is assigned.

(Figure 3: Menu Screen for [11] Output Menu *factory default)

Crosspoint Button Source Name Source

SDI-IN1 to SDI‐IN4 Images inputted into SDI-IN1 to 4

DVI-IN Image inputted into DVI-IN

FMEM1, FMEM2 Images stored in the switcher

CBGD Signal outputted from the switcher's built-in color generator

CBAR Switcher's internal color-bar signal

Black Switcher's internally generated signal (black signal)

NoAsign No signal assigned

1 to 10

PGM

This is the main line output.

Images with wipe, mix, key, PinP or other effects added are outputted.

PVW

PVW images which enable the next operation to be checked are outputted.

CLN

Clean signals (images resulting when the key and PinP effects have been

removed from the PGM signal) are outputted.

AUX

The signal selected using the AUX bus is outputted.

MV Multi view display signal is outputted.

KEY OUT Key signal is outputted.

・If DVI input is being used as a source, does the output signal have the resolution supported by

AW-HS50 switcher?

When a signal is input with unsupported resolution, the switcher cannot take it in correctly. A black screen or

distorted image may be displayed.

※For DVI input, please see the following manual “AW-HS50 –DVI Input & Output”.

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/24_.pdf

Example: DVI input does not support “1080/59.94i”.

・The input signal is coming via a converter.

If the output signal from the source is being converted (HDMI⇒SDI, HDMI⇒DVI), please check if the format and

resolution of the output signal from the converter are supported byAW-HS50 switcher.

About the converter itself, please contact the manufacturer of your equipment.

・Is a copyright-protected device being used for an input source?

This switcher does not support HDCP. If a copyright-protected DVD player or PC is used as a source, the output

image is a black screen or distorted.

・Is FTB (fade to black) ON button –(Figure 1) lit?

When this button is lit, the screen is black after the program image has faded out.

Press FTB ON button to check if an image fades in to be displayed on the screen.

■“The image won’t be switched by pressing crosspoint buttons.”

・Is any of BUS DELEGATION buttons –(Figure 1) blinking?

These 3 buttons are used for selection at the time of setting the AUX bus, PinP source and key source/key fill.

When all of them are off, the switcher can select an input source for the background.

If one button is blinking, press it to turn it off. Then check if the image will be switched.

※For “BUS DELEGATION” features, please see the following manuals.

☆[AUX] button: Manual “AW-HS50 –AUX Bus”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/16_.pdf

☆[PinP] button: Manual “AW-HS50 –Combining PinP”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/15_.pdf

☆[KEY-F/S] button: Manual “AW-HS50 –Combining Telop”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/13_.pdf

: Manual “AW-HS50 –Chroma Keying”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/14_.pdf

■“The settings return to the default values by themselves after turning the power on.”

On the rear panel, is “BOOT” switch at [SV] side? If this switch is at [SV] side, the switcher boots up with its factory

default settings when you boot it up. Normally, please have it at [NM] side when using the switcher.

■Other Features

※Regarding the operations and setting procedures of major AW-HS50 features, illustrated manuals are

available at our website.

☆Frame Memory (FMEM): “AW-HS50 –Storing Still Images in FMEM”

(AUX version) https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/11_.pdf

(Software version) https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/12_.pdf

☆Setting for Linking AW-RP50: “AW-HS50 –Setting for LinkingAW-RP50”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/18_.pdf

☆Audio (Passing Through) Setting: “AW-HE40 & AW-HS50 –Audio (Passing Through) Settings”

https://eww.pass.panasonic.co.jp/pro-av/support/content/faq/EN/remcam/23_.pdf

Otros manuales para AW-HS50 Series

Tabla de contenidos

Otros manuales de Cambiar de Panasonic

Panasonic

Panasonic Switch-M24eG PN28240K-TH Manual de usuario

Panasonic

Panasonic EVQQ7 Manual de usuario

Panasonic

Panasonic AV FS Manual de usuario

Panasonic

Panasonic AV-HS450N Manual de usuario

Panasonic

Panasonic Swtich-M48eG Series Manual de usuario

Panasonic

Panasonic GA-AS12TPoE+ Series Manual de usuario

Panasonic

Panasonic KX-HNB600C Manual de usuario

Panasonic

Panasonic KX-HNB600 Manual de usuario

Panasonic

Panasonic AV-HS300 Manual de usuario

Panasonic

Panasonic PN28080K-ID Manual de usuario

Panasonic

Panasonic Switch-M24eGLPWR+ Series Manual de usuario

Panasonic

Panasonic AV3205G3 Manual de usuario

Panasonic

Panasonic Switch-M12PWR Manual de usuario

Panasonic

Panasonic KX-T206NZ Manual de usuario

Panasonic

Panasonic PN23129A Manual de usuario

Panasonic

Panasonic GA-AS12T Series Manual de usuario

Panasonic

Panasonic FP (ABP8) Manual de usuario

Panasonic

Panasonic WJ-SW208 Manual de usuario

Panasonic

Panasonic AV-UHS500P Manual de usuario

Panasonic

Panasonic WJ-SQ208 Manual de usuario

Panasonic

Panasonic AV-HS410N Manual de usuario

Panasonic

Panasonic AW-HS50N Manual de usuario

Panasonic

Panasonic AJ8 Manual de usuario

Panasonic

Panasonic AJ9 (J9) Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario