Panasonic Aw-he40 series Manual de usuario

★ AW-HE40 camera can superimpose the audio signal from an external microphone onto the video signal and can

output it.

Also, it can superimpose the audio onto SD output through AW-HS50 switcher.

To allow the audio to pass through, both AW-HE40 camera and AW-HS50 switcher require changing the settings.

1．AW-HE40 Audio Settings

(Example 1) Using AW-RP50 Cont olle

* Below is the explanation about the audio settings of a camera registered as [CAM1].

① Press the button 1 at <CAMERA STATUS/SELECT ON>. – (Fig.1-A)

② Hold down CAMERA OSD button – (Fig.1-B) for 2 seconds to open the on-screen menu. (Hold it down again for 2

seconds to close the menu.)

③ Use F1 dial – (Fig.1-C) to set the item “Audio” to [On].

【Location】 System ＞ Others ＞ Others 4/4 ＞ Audio ⇒ [On] – (Figure 2 of next page) * Default: Off

* When “Audio” is [On], the audio-related setting items are available. Set them according to the installation

environment of your cameras. – (Figure 3 of next page)

(*) The HDM model requires an SD converter

in order to connect with AW-HS50.

HDMI Connection (*)

(AW-HE40 Rear Panel)

(AW-HS50)

(AW-HE40)

SDI Connection SDI Connection

AW-HE40 & AW-HS50 – Audio (Passing Th ough) Settings

（A）

（B）

（C）

(Figure 1: AW-RP50 Control Panel)

Recorder

(Video & Audio Recording)

Schematic View

Specifications of External Audio nput Connector [AUD O N]

- Stereo mini-jack (φ3.5mm)

- Mic input: nput level -60dBV±3dBV

* Supported mic: Stereo mic (plug-in power), Supplied voltage: 2.5V±0.5V

- Line input: nput level -10dBV±3dBV

Microphone

(Figure 3: AW-HE40 On-Screen Menu)

(Figure 2: AW-HE40 On-Screen Menu)

Equalizer: Setting for the equalizer function * Default: Off

・Off: Equalizer function is disabled.

・Low Cut: Low frequencies are cut to reduce noise levels of air

conditioning units, projectors or other equipment.

・Speech Enhancement: Low and high frequencies are cut to

enhance human voices so that they

sound more clearly.

Plugin Power: Setting for the plugin power * Default: Off

ALC: Automatic adjustment of audio level * Default: On

Select “System”

and press F1.

Select “Others”

and press F1.

Turn F1 to display “Others 4/4”.

nput Volume: Setting for Mic/Line and its volume

* Default: Line Middle

Turn F1 to select [On].

(Example 2) Using Web Sc een

① Start the Web screen. – (Figure 4)

② Follow the procedure below to enable the audio input from the device connected to the external input connector.

Procedure: ［Setup］＞［mage/Audio］＞［Audio］＞ Audio ⇒ [On] * Default: Off

* f the login screen is displayed, please enter the user name and password.

③ When “Audio” is [On], the audio-related setting items are available. Set them according to the installation

environment of your cameras.

* To determine the settings, be sure to press [Set] button after having changed them.

(Figure 4: Web Screen)

Audio: Setting for enabling/disabling the audio input from the

device connected to the audio input connector

* Default: Off

Equalizer: Setting for the equalizer function * Default: Off

・Off: Equalizer function is disabled.

・Low Cut: Low frequencies are cut to reduce noise levels of air

conditioning units, projectors or other equipment.

・Speech Enhancement: Low and high frequencies are cut to

enhance human voices so that they

sound more clearly.

nput Volume: Setting for Mic/Line and its volume

* Default: Line Middle

Plugin Power: Setting for the plugin power * Default: Off

ALC: Automatic adjustment of audio level * Default: On

2．AW-HS50 Audio Settings

* n order that the audio superimposed on an SD input signal is can pass through, the setting change below is required.

① Hold down OSD ON button – (Fig.5-A) for 2 seconds to open the menu. (Hold it down again for 2 seconds to

close the menu.)

② Use OSD/T ME dial – (Fig.5-B) to set the settings for individual output signals you want to allow to pass through.

Menu: ［14］SYSTEM Menu – (Figure 6) ＞［Set the settings for output signals individually. – (Figure 7)］

<Note>

・You cannot fix and continue to output the audio of a specific input. When the video is switched, the audio is

also switched together.

・Even if an SD signal is input in DbyD or UC mode while AW-HS50’s format setting is 1080/59.94i, 720/59.94p

or 1080/50i, the audio is not allowed to pass through.

(*1) f PGM bus or others are selected for the AUX output signal, only the [On] setting of “4. AUX Anci” is not enough

for the audio to pass through.

When the following buses are selected, please change their settings in addition to “4. AUX Anci [On]”.

・PGM is selected as a source. ⇒ 5．PGM Anci ［On］

・PVW is selected as a source. ⇒ 6．PVW Anci ［On］

・MV is selected as a source. ⇒ 7．MV Anci ［PGM or PVW］

* f a selected source is KEY_OUT or CLN, the audio will not pass through.

* Screen shows default settings

(Figure 5: AW-HS50 Control Panel)

（A）

（B）

(Figure 6: AW-HS50 Menu Display Screen)

4．For allowing the audio of a source selected at AUX buss to pass through: ［On］(*1)

5．For allowing the audio of a source selected at PGM buss to pass through: ［On］

6．For allowing the audio of a source selected at PVW buss to pass through: ［On］

7．Setting for the output signal for Multi View Display

For allowing the audio of a source selected at PGM bus to pass through: ［PGM］

For allowing the audio of a source selected at PVW bus to pass through: ［PVW］

(Figure 7)

Otros manuales para aw-he40 series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara digital de Panasonic

Panasonic

Panasonic Lumix DMC-FT20EB Manual de usuario

Panasonic

Panasonic BM-ET300AE Manual de usuario

Panasonic

Panasonic Lumix DC-G9L Manual de usuario

Panasonic

Panasonic Lumix DC-GH5EFK Manual de usuario

Panasonic

Panasonic Lumix DMC-TZ37EC Manual de usuario

Panasonic

Panasonic LUMIX DC-TZ90GN Especificaciones técnicas

Panasonic

Panasonic DMC-L1K - Lumix Digital Camera SLR Manual de usuario

Panasonic

Panasonic Lumix DMC-LX100 Manual del propietario

Panasonic

Panasonic LUMIX DC-ZS200D Manual de usuario

Panasonic

Panasonic PalmCam PV-DC1000 Manual de usuario

Panasonic

Panasonic WV-BWC4000 Manual de funcionamiento

Panasonic

Panasonic Lumix DMC-FX700P Manual de usuario

Panasonic

Panasonic Lumix DMC-FH6P Manual de usuario

Panasonic

Panasonic DMC-ZS5K Especificaciones técnicas

Panasonic

Panasonic DMCFZ30PP - DIGITAL STILL CAMERA Manual de usuario

Panasonic

Panasonic LUMIX DMC-TS30R Instrucciones de instalación y servicio

Panasonic

Panasonic LUMIX DMC-FS6 Manual de usuario

Panasonic

Panasonic Lumix DMC-TZ18 Especificaciones técnicas

Panasonic

Panasonic Lumix DMC-LZ20 Manual de instrucciones

Panasonic

Panasonic Lumix DC-GH5S Manual de usuario

Panasonic

Panasonic LUMIX DMC-FX75 Especificaciones técnicas

Panasonic

Panasonic S-S50E Manual de usuario

Panasonic

Panasonic Lumix DMC-TZ2 Manual de usuario

Panasonic

Panasonic Lumix DC-ZS80D Instrucciones de instalación y servicio

Manuales populares de Cámara digital de otras marcas

Mercury

Mercury 350K Manual de usuario

Pentax

Pentax Optio LS 465 Manual de usuario

Sanyo

Sanyo VPC-S1085 Manual de usuario

GE SMART A1255 Manual de usuario

Point Grey

Point Grey Gazelle Manual de usuario

Nikon

Nikon COOLPIX A Manual de usuario

Pentax

Pentax P-5 Manual de usuario

BlazeVideo

BlazeVideo A280 Manual de usuario

Sony

Sony MCA-20 Manual de usuario

Sony

Sony Alpha DSLR-A290 Manual de usuario

ATIK Cameras

ATIK Cameras One Manual de usuario

CohuHD Costar

CohuHD Costar 3930 Series Manual de usuario

Leica

Leica M10-R Manual de usuario

FujiFilm

FujiFilm FinePix A700 Manual de usuario

Lorex

Lorex LNZ81P25 Series Manual de usuario

GE J1470S Manual de usuario

Sony

Sony A6700 Guía del usuario

Canon

Canon EOS ELAN7 Manual de usuario

Panasonic aw-he40 series Manual de usuario

Manuales populares de Cámara digital de otras marcas