06/09 Rev. 5.02-01 OPERATING INSTRUCTIONS Setting up, operation
U-RX
8
Basic operation
Plugging in and powering up
1. Ensure that the mains voltage set for the
unit is the same voltage as the local
electricity supply. To do this, look for the
number in the small window next to the
power switch [1]. This number indicates
the required voltage.
¯If the voltage set is not the same as the
local voltage, please call a qualified
technician to change the setting.
PFor further information, refer to the service
manual.
2. Ensure that power switch [2B] on the U-RX
is set to “0” (off).
3. Using the power cord [2A] supplied, plug
the U-RX into a socket connected to the
local electricity supply.
4. Turn on the unit (switch set to “I”).
WARNING!
The unit operates using mains voltage! Touching electrically live parts may
expose you to hazardous electrical currents and may lead to burns.
«Make sure that the unit is switched off before connecting the power cable.
«Only operate the unit with mains voltage set in the fuse insert[1].
«Ensure that the unit is set to the mains voltage supplied by your electricity
provider.
«Only connect the unit to a grounded power socket fitted to authorised
standards.
«The power cable should not be more than 3meters long.
The device can only be disconnected completely by pulling off the power
supply cable. For this reason:
«Make sure, that the power supply socket for the device is readily
accessible!
«In case of emergency, switch off the device and disconnect the power
supply cable!
[1] Check the mains voltage set for the U-RX on the power
socket of the unit (shown here as 230V).
[2] U-RX power supply
A
B
