Notilo Plus Seasam Manual de usuario
Quick Start Guide
Seasam with Gripper
December 2022
Content
I - GRIPPER INSTALLATION
●Installation of the Gripper
II - STARTING UP
●Connecting the battery
●Connecting the WiFi Reel to the drone
●Starting up the equipment
●Connecting to the WiFi Reel
○Delivery after September 2021
○Delivery before September 2021
●Connection of the controller
●Choice of configuration
●Checking the connections
●Seasam Control
●Set up and calibration
●Adding the gripper to the interface
III - USING SEASAM WITH THE GRIPPER
●Drone launching
●Using the gripper during your dive
●At the end of the exploration
I - GRIPPER
INSTALLATION
Installation of the Gripper
I - GRIPPER INSTALLATION
Place the drone on its back and open the battery compartment
and pass on the gripper cable from the front of the drone to the
battery compartment
Recover the cable from the drone
The battery must not be connected to the drone during this step
5
Installation of the Gripper
I - GRIPPER INSTALLATION
Connect the gripper cable with the connecter inside the drone.
The two white dots must face each other and the two caps
closed together The battery must not be connected to the drone during this step
Store the two connectors and the caps on the side of the battery
compartment under the hull
6
Installation of the Gripper
I - GRIPPER INSTALLATION
Position the foam around the gripper arm
●Smallest part of the foam must face the front of the drone.
●The open part of the foam should face you when the drone
is upside down
Insert the cubic part of the cable inside the drone’s hull until it gets
close to the battery compartment
7
The battery must not be
connected to the drone during
this step
Installation of the Gripper
I - GRIPPER INSTALLATION
Position the ring with the two nuts around the gripper arm
●Unscrew the two silver screw
●Screw the blue screw to maintain the ring around
the arm
Place the drone on its feets
Position the foam on the metallic plate on the drone
Slide the ring under the metallic plate and screw the 2 silver screw
8
Installation of the Gripper
I - GRIPPER INSTALLATION
You can now connect the battery.
Make sure the battery is never connected when
you connect or disconnect the gripper connector
under the drone.
9
II - STARTING
UP THE DRONE
Otros manuales para Seasam
4
Otros manuales de Zumbido de Notilo Plus
