Nortel DMS-100 Series Manual de usuario

Critical Release Notice

Publication number: 297-8021-545

Publication release: Standard 14.03

The content of this customer NTP supports the

SN09 software release.

Bookmarks used in this NTP highlight the changes between the NA015 baseline and the current

release. The bookmarks provided are color-coded to identify release-specific content changes. NTP

volumes that do not contain bookmarks indicate that the NA015 baseline remains unchanged and is

valid for the current release.

Bookmark Color Legend

Orange: Applies to new or modified content for SN09 that is valid through the current

release.

Attention!

Adobe

Acrobat

Reader

™

5.0 or higher is required to view bookmarks in color.

Publication History

January 2006

Standard release 14.03 for software release SN09. Updates made for this release are shown

below:

Changed procedure: Emergency power conservation Shutdown – Showing that the XPM

unit to be powered down must match the ENET/JNET plane number that is to be powered

down.

297-8021-545

DMS-100 Family

North American DMS-100

Recovery Procedures

LET0015 and up Standard 14.02 May 2001

DMS-100 Family

North American DMS-100

Recovery Procedures

Publication number: 297-8021-545

Product release: LET0015 and up

Document release: Standard 14.02

Date: May 2001

Printed in the United States of America

NORTEL NETWORKS CONFIDENTIAL: The information contained herein is the property of Nortel Networks and is

strictly conﬁdential. Except as expressly authorized in writing by Nortel Networks, the holder shall keep all information contained

herein conﬁdential, shall disclose the information only to its employees with a need to know, and shall protect the information, in

whole or in part, from disclosure and dissemination to third parties with the same degree of care it uses to protect its own

conﬁdential information, but with no less than reasonable care. Except as expressly authorized in writing by Nortel Networks, the

holder is granted no rights to use the information contained herein.

Information is subject to change without notice. Nortel Networks reserves the right to make changes in design or components as

progress in engineering and manufacturing may warrant. Changes or modiﬁcation to the DMS-100 without the express consent of

Nortel Networks may void its warranty and void the user’s authority to operate the equipment.

Nortel Networks, the Nortel Networks logo, the Globemark, How the World Shares Ideas, Uniﬁed Networks, DMS, DMS-100,

Helmsman, MAP, Meridian, Nortel, Northern Telecom, NT, SuperNode, and TOPS are trademarks of Nortel Networks.

DMS-100 Family NA100 Recovery Procedures LET0015 and up

iii

Contents

Recovery Procedures

About this document vii

How to check the version and issue of this document vii

References in this document vii

What precautionary messages mean viii

How commands, parameters, and responses are represented ix

Input prompt (>) ix

Commands and fixed parameters ix

Variables ix

Responses ix

1 System recovery controller 1-1

About the system recovery controller 1-1

SRC functions 1-2

Required SRC conditions for PM recovery 1-4

SRC triggers 1-4

SRC dependency manager 1-5

SRC group manager 1-6

Limit of concurrent load activities 1-9

Example of automatic broadcast loading 1-9

Automatic single loading 1-10

SRC recovery methods 1-10

Series I PMs that the SRC automatically recovers 1-11

Series II PMs that the SRC automatically recovers 1-11

Series II XMS-based PMs that the SRC automatically recovers 1-12

Series III LPP-based PMs that the SRC automatically recovers 1-13

How to monitor SRC operation 1-13

MAP terminal displays 1-14

Log reports 1-29

Failure of SRC to recover a PM 1-32

Manual override of the SRC 1-33

2 System level recovery procedures 2-1

Introduction to system level recovery procedures 2-1

Explanatory and context-setting information 2-1

Summary flowchart 2-1

Step-action instructions 2-1

iv Contents

297-8021-545 Standard 14.02 May 2001

Booting a DMS switch 2-2

DMS-Spectrum Peripheral Module recovery process 2-17

Performing a cold restart 2-21

Performing a reload-restart 2-30

Performing a warm restart 2-39

Recovering a composite clock 2-48

Recovering from a dead system in a SuperNode switch 2-55

Recovering from a dead system in a SuperNode SE switch 2-86

3 Node level recovery procedures 3-1

Introduction to node level recovery procedures 3-1

Explanatory and context-setting information 3-1

Summary flowchart 3-1

Step-action instructions 3-1

Recovering the enhanced network 3-2

Recovering link peripheral processors 3-15

Recovering SuperNode SE application specific units 3-34

4 Recovery procedures for individual devices and services 4-1

Introduction to recovery procedures for individual devices and services 4-1

Explanatory and context-setting information 4-1

Summary flowchart 4-1

Step-action instructions 4-1

Checking for call completion 4-3

Checking for message throughput 4-16

MP position (integrated) recovery 4-30

MP position (standalone) recovery 4-35

PM TPC recovery 4-41

Recovering AMA data with block numbers 4-53

Recovering AMA data without DIRP block numbers 4-59

Recovering CCS7 linksets 4-76

Recovering CompuCALL 4-88

Recovering data from a disk to tape 4-96

Recovering a dead DIRP utility 4-102

Recovering enhanced link peripheral processors 4-106

Recovering a stuck HLIU or HSLR 4-114

Recovering a stuck HLIU under a composite clock failure 4-122

Recovering a stuck LIU7 4-128

Recovering volumes marked INERROR 4-137

5 Emergency power conservation recovery procedures 5-1

Introduction to emergency power conservation recovery procedures 5-1

Explanatory and context-setting information 5-1

Summary flowchart 5-1

Step-action instructions 5-1

Restoration 5-3

Restoring the CM to duplex operation in SuperNode 5-7

Restoring the CM duplex operation in SuperNode SE 5-12

Restoring the ELPP LIM to duplex operation 5-18

Restoring the junctored network to duplex operation 5-23

Contents v

DMS-100 Family NA100 Recovery Procedures LET0015 and up

Restoring the LCMs to duplex operation 5-28

measures Restoring the LGCs, LTCs, and DTCs to duplex operation 5-32

Restoring the line modules to duplex operation 5-40

Restoring the LPP LIM to duplex operation 5-45

Restoring the maintenance trunk modules to service 5-49

Restoring the MS to duplex operation 5-53

Restoring the MSB7 to duplex operation 5-58

Restoring the remote oscillator shelf to duplex operation 5-65

Restoring a SuperNode ENET to duplex operation 5-68

Restoring a SuperNode SE ENET to duplex operation 5-77

Shutdown 5-85

Emergency shutdown of DMS system 5-91

Emergency shutdown of maintenance trunk modules 5-95

Emergency shutdown of one DMS SuperNode CM plane 5-100

Emergency shutdown of one DMS SuperNode MS plane 5-107

Emergency shutdown of one enhanced network plane 5-112

Emergency shutdown of one half of a line module pair 5-121

Emergency shutdown of one junctored network plane 5-125

Emergency shutdown of one LGC, LTC, and DTC unit 5-129

Emergency shutdown of one LIM unit on each ELPP 5-137

Emergency shutdown of one LIM unit on each LPP 5-143

Emergency shutdown of one MS plane 5-149

Emergency shutdown of one remote oscillator shelf plane 5-155

Emergency shutdown of one SuperNode SE CM plane 5-159

Emergency shutdown of one SuperNode SE MS plane 5-169

Emergency shutdown of one unit of LCMs 5-174

Emergency shutdown of one unit of MSB7s 5-178

DMS-100 Family NA100 Recovery Procedures LET0015 and up

vii

About this document

How to check the version and issue of this document

The version and issue of the document are indicated by numbers, for example,

01.01.

The ﬁrst two digits indicate the version. The version number increases each

time the document is updated to support a new software release. For example,

the ﬁrst release of a document is 01.01. In the next software release cycle, the

ﬁrst release of the same document is 02.01.

The second two digits indicate the issue. The issue number increases each

time the document is revised but rereleased in the same software release cycle.

For example, the second release of a document in the same software release

cycle is 01.02.

To determine which version of this document applies to the software in your

ofﬁce and how documentation for your product is organized, check the release

information in Product Documentation Directory, 297-8991-001.

References in this document

The following documents are referred to in this document:

•Alarm Clearing and Performance Monitoring Procedures

•Bellcore Format Automatic Message Accounting Reference Guide,

297-1001-830

•Card Replacement Procedures

•DMS-100 Family Commands Reference Manual, 297-1001-822

•Log Report Reference Manual

•Magentic Tape Reference Manual, 297-1001-118

•Operational Measurements Reference Manual

•Routine Maintenance Procedures

Otros manuales para DMS-100 Series

Tabla de contenidos

Otros manuales de Sistema de conferencias de Nortel

Nortel

Nortel Meridian Norstar Manual de usuario

Nortel

Nortel NN42030-101 Manual de usuario

Nortel

Nortel NN42030-102 Manual de usuario

Nortel

Nortel BCM50 Manual del producto

Nortel

Nortel BCM200 Manual de usuario

Nortel

Nortel 3100 Series Manual de usuario

Nortel

Nortel Agent Greeting 2.0 Instrucciones de funcionamiento

Nortel

Nortel Meridian 1 Option 11C Manual técnico

Nortel

Nortel NN42030-107 Manual de usuario

Nortel

Nortel Meridian 1 Mini-Carrier Remote Instrucciones de funcionamiento e instalación

Nortel

Nortel Meridian Meridian 1 Manual de usuario

Manuales populares de Sistema de conferencias de otras marcas

Kramer

Kramer VIA GO Manual de usuario

AVT

AVT MAGIC AC1 Go Manual de usuario

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Manual de usuario

Sony

Sony PCS-I150 Manual de usuario

Middle Atlantic Products

Middle Atlantic Products VTC Series Manual de usuario

Prentke Romich Company

Prentke Romich Company Vanguard Plus Guía

Speakerbus

Speakerbus iD 712 Manual de usuario

Trelleborg

Trelleborg SafePilot CAT PRO Manual de usuario

Sennheiser

Sennheiser ADN Manual de usuario

ADTRAN

ADTRAN NetVanta 7100 Manual de usuario

AINA

AINA PTT Voice Responder Manual de usuario

Yamaha

Yamaha ProjectPhone PJP-100H Manual de usuario

vissonic

vissonic VLI Series Manual de usuario

Panasonic

Panasonic KX-VC500 Manual de usuario

Poly

Poly Trio 8300 Manual de usuario

Crestron

Crestron Mercury CCS-UCA-SMK Dibujo dimensional

Inmarsat

Inmarsat mini M Manual de usuario

Tenveo

Tenveo ALL-IN-ONE Manual de usuario