Nikon MD-14 Manual de usuario
Iflikon Motor Drive
Instruction Monuol
NOMENCLATURE Anatomical grip @
Attachment wheel @
Battery chamber with battery clip @
OTripoO socket
@ gattery chamber locking screw
www.orphancameras.com
O Rewind button pin
? Mounting screw
C Electrical contacts
t0 Power switch/H-L firing rate selector
t i Rewind slide
Motor drive coupling prong @
Camera positioning pin @
GOItITENTS
]|oME]{CLATURE. . . .2-3
FOREWORD 4
BASIC OPERATIOIT| . 5-10
co]fTRotsrN DETATL.. ...11-12
Power Switch/H-L Firing Rate Selector. . 1',-12
TIPS ON TOTOR DRIVE GARE . 13
OPTITUT BATTERY PERFORMAilCE . . . . . . 14
SPECIFTCATTONS. .....15
FOREWORD
Congratulations You now own the Motor Drive MD-'14,
an accessory designed to advance the film auto-
matically through the Nikon FG or EM camera. You
can select f iring rates of approximately 3.2 fps or
2 f ps at shutter speeds of 11125 sec. or faster. Single-
f rame shooting, of cou rse, is also possible at any
shutte r speed
Even though the MD-14 is extremely easy to use, you
should familiarize yourself thoroughly with this
instruction manual, as well as your camera's
instruction manual, before actually using the product.
www.orphancameras.com
BASIGOPERATION
I Unscrew the
lr battery chamber
locklng screw @.
Lift the outside ring of the locking
screw and unscrew il
cl Remove the motor
G. dr,vets battery
cllp @ .
A Load the batterles.
rur Install eight 1.5V M-type
penlight batteries into the ctip
following the " + " and "-" indi-
cations.
IVotc; lmproper installation of the
batteries might cause the MD-14 to
malfunction or may result in damage
to the unit. (For information about
batteries, refer to page 14.)
- BASI C OPERATIO J[ -sontinued
A Install the battery
Tt clip.
Put the clip back into the chamber.
While pushing the clip down into
place, tighten the locking screw;
then return the outside ring of the
locking screw to its original position
E Remove the
er g66eratg handgrip.
When using the Nikon FG, remove
the camera's handgrip, referring
to the camera's instruction manu-
al. With the Nikon EM, this is
unnecessarv.
a Make sure the
tvr 1nglor drivets
power switch i, is in
the OFF positlon.
www.orphancameras.com
, Place the camera body on the
rt motor drlve.
Place the camera body on top of the motor drive so
that the motor drive's mounting screw @ lines up
with the camera's tripod socket and the camera
positioning pin @ is aligned with the motor drive
positioning hole.
a Attach the motor drlYe to the
ter gg6ora body.
Turn the attachment wheel @ clockwise until the two
units are screwed tightly together.
Note: Before attaching the motor drive, make sure the
camera's film advance lever is completely cocked.
- BASIC OPERATI O Jf -sontinued
a Load fllm Into the camera and
Y. make blank oxposurgs.
Load film into the camera in the normalway, and then
make blank exposures with the camera's shutter
release button and film advance lever in the normal
wav as if the MD-14 were not attached.
{ft Sllde the flrlng rate selector to
lYr the H or L posltlon.
This turns the motor drive on. At the H position, the
MD-14 operates continuously at approx. 3.2 fps, while
at L, it fires at approx. 2 fps.
IVotc;
1)With the MD-14 set at either H or L, you can make blank
exposures by holding the button down. However, at the H
position, be careful not to make too many blank exposures.
2) Sliding the selector to the H or L position without winding
the film after shutter is released advances the film by
one frame.
www.orphancameras.com
I
ru
,(
-\
aA Take the plcturc(sl.
r rr Push the camera's shutter release button
to take the shot(s). The LED indicator @ lights up to
indicate the motor drive is operating.
When you want to take a single shot, depress the
shutter button and remove your f inger f rom the button
before the motor drive advances the film to the next
frame. To take pictures continuously, hold the shutter
button down as long as you like.
Aq, lUrn off the powor swltch.
r-r When the film reaches the end of the roll,
the MD-14 will automatically stop and the LED indi-
cator will light up continuously. Then turn the motor
drive off .
Note: Do not repeatedly depress the camera's shufter
release button nor turn the motor dilve on and off rapidly
as these actions mav cause the film to break.
Tabla de contenidos
Otros manuales de Cámara de película de Nikon
Nikon
Nikon Fun >Touch 5 Manual de usuario
Nikon
Nikon FA Manual de usuario
Nikon
Nikon N55 Manual de usuario
Nikon
Nikon N4004s Manual de usuario
Nikon
Nikon 2170749 - Pronea S APS Camera Manual de usuario
Nikon
Nikon F75D - F75 QD = N75 35mm SLR Camera Body... Manual de usuario
Nikon
Nikon LITETOUCH - Lite Touch 35mm Camera Manual
Nikon
Nikon 120ED - Lite Touch 120 ED/QD Zoom Date 35mm... Instrucciones de funcionamiento
Nikon
Nikon Nice Touch 2 Manual de usuario
Nikon
Nikon FM3A Manual de usuario
Nikon
Nikon Nuvis A20 Manual de usuario
Nikon
Nikon D850 Manual de servicio
Nikon
Nikon F70 Manual de usuario
Nikon
Nikon 110i - Nuvis APS Camera Manual de usuario
Nikon
Nikon N2000 Manual de usuario
Nikon
Nikon Zoom Touch 400 Quartz Date Manual de usuario
Nikon
Nikon Lite Touch Zoom 70 W QD Manual de usuario
Nikon
Nikon F80 Manual de usuario
Nikon
Nikon PhotomicF Tn Finder Manual de usuario
Nikon
Nikon Nikomat (Nikkormat) FS Manual de usuario
