Nibe SAM 40 Guía del usuario

Installer manual

LEK

SAM 40

Supply air module

IHB GB 1549-4

031934

LEK

Table of Contents

41 Important information

4Safety information

72 Delivery and handling

7Transport

7Assembly

7Removing the covers

3 The design of the supply air mod-

ule

104 Pipe and ventilation connections

10General pipe connections

10Symbol key

10Outline diagram

11Dimensions and pipe connections

11Mounting

12Heating medium side

16General ventilation connection

16Ventilation flow

16Adjusting ventilation

175 Electrical connections

17General

17Connections

186 Commissioning and adjusting

18Preparations

18Connecting to heating medium system

18Start-up and inspection

217 Disturbances in comfort

21Info menu

21Manage alarm

21Troubleshooting

238 Accessories

249 Technical data

24Dimensions and setting-out coordinates

25Technical specifications

26Energy labelling

27Electrical circuit diagram

28Index

3Table of Contents |SAM 40

Safety information

This manual describes installation and service proced-

ures for implementation by specialists.

This appliance can be used by children

aged from 8 years and above and per-

sons with reduced physical, sensory or

mental capabilities or lack of experience

and knowledge if they have been given

supervision or instruction concerning

use of the appliance in a safe way and

understand the hazards involved. Chil-

dren shall not play with the appliance.

Cleaning and user maintenance shall

not be made by children without super-

vision.

Rights to make any design or technical

modifications are reserved.

©NIBE 2015.

Symbols

NOTE

This symbol indicates danger to machine or

person.

Caution

This symbol indicates important information

about what you should observe when main-

taining your installation.

TIP

This symbol indicates tips on how to facilitate

using the product.

Marking

SAM 40 is CE marked and fulfils IP21.

The CE marking means that NIBE ensures that the

product meets all regulations that are placed on it

based on relevant EU directives. The CE mark is obligat-

ory for most products sold in the EU, regardless where

they are made.

IP21 means that objects with a diameter larger than

or equivalent to 12.5 mm cannot penetrate and cause

damage and that the product is protected against

vertically falling drops of water.

Serial number

The serial number can be found at the bottom left in-

side the front cover.

LEK

Serial number

LEK

Caution

Always give the product's serial number (14

digits) when contacting your installer.

Recovery

Leave the disposal of the packaging to the in-

staller who installed the product or to special

waste stations.

When disposing of the product, the constitu-

ent materials and components, such as com-

pressors, fans, circulation pumps and circuit boards,

must be disposed of at a special waste station or at a

dealer who provides this type of service.

To access the separate components, refer to the section

that shows the construction of the product. No special

tools are required for access.

Improper disposal of the product by the user results in

administrative penalties in accordance with current

legislation.

Country specific information

Installer manual

This installer manual must be left with the customer.

SAM 40Chapter 1 | Important information4

1 Important information

Inspection of the installation

In addition, fill in the page for the installation data in the User Manual.

Current regulations require the supply air module to be inspected before it is put into service. The inspection must

be carried out by a suitably qualified person.

DateSignatureNotesDescription

✔

Ventilation (page 16)

Setting ventilation flow exhaust air

Setting ventilation flow supply air

Heating medium (page 12)

System flushed

Accessories bled

Check against output and pressure drop

diagrams

Connected according to outline diagram

Electricity (page 17)

Connections

Phase voltage

Supply connected 230 V

Connected communication

5Chapter 1 | Important informationSAM 40

Contact information

KNV Energietechnik GmbH, Gahberggasse 11, 4861 SchörflingAT

Tel: +43 (0)7662 8963-0 Fax: +43 (0)7662 8963-44 E-mail: mail@knv.at www.knv.at

NIBE Wärmetechnik c/o ait Schweiz AG, Industriepark, CH-6246 AltishofenCH

Tel: (52) 647 00 30 Fax: (52) 647 00 31 E-mail: [email protected] www.nibe.ch

Druzstevni zavody Drazice s.r.o, Drazice 69, CZ - 294 71 Benatky nad JizerouCZ

Tel: +420 326 373 801 Fax: +420 326 373 803 E-mail: [email protected] www.nibe.cz

NIBE Systemtechnik GmbH, Am Reiherpfahl 3, 29223 CelleDE

Tel: 05141/7546-0 Fax: 05141/7546-99 E-mail: [email protected] www.nibe.de

Vølund Varmeteknik A/S, Member of the Nibe Group, Brogårdsvej 7, 6920 VidebækDK

Tel: 97 17 20 33 Fax: 97 17 29 33 E-mail: [email protected] www.volundvt.dk

NIBE Energy Systems OY, Juurakkotie 3, 01510 VantaaFI

Puh: 09-274 697 0 Fax: 09-274 697 40 E-mail: inf[email protected] www.nibe.fi

NIBE Energy Systems France Sarl, Zone industrielle RD 28, Rue du Pou du Ciel, 01600 ReyrieuxFR

Tel : 04 74 00 92 92 Fax : 04 74 00 42 00 E-mail: [email protected] www.nibe.fr

NIBE Energy Systems Ltd, 3C Broom Business Park, Bridge Way, Chesterfield S41 9QGGB

Tel: 0845 095 1200 Fax: 0845 095 1201 E-mail: [email protected].uk www.nibe.co.uk

NIBE Energietechniek B.V., Postbus 634, NL 4900 AP OosterhoutNL

Tel: 0168 477722 Fax: 0168 476998 E-mail: [email protected] www.nibenl.nl

ABK AS, Brobekkveien 80, 0582 Oslo, Postadresse: Postboks 64 Vollebekk, 0516 OsloNO

Tel. sentralbord: +47 23 17 05 20 E-mail: [email protected] www.nibeenergysystems.no

NIBE-BIAWAR Sp. z o. o. Aleja Jana Pawła II 57, 15-703 BIAŁYSTOKPL

Tel: 085 662 84 90 Fax: 085 662 84 14 E-mail: sekretariat@biawar.com.pl www.biawar.com.pl

Tel./fax +7 831 419 57 06 E-mail: [email protected] www.nibe-evan.ru

NIBE AB Sweden, Box 14, Hannabadsvägen 5, SE-285 21 MarkarydSE

Tel: +46-(0)433-73 000 Fax: +46-(0)433-73 190 E-mail: [email protected] www.nibe.se

For countries not mention in this list, please contact Nibe Sweden or check www.nibe.eu for more information.

SAM 40Chapter 1 | Important information6

Transport

The supply air module must be transported and stored

dry.

Assembly

SAM 40 is mounted free standing on brackets, altern-

atively above a VPB 200 (For VPB 300/VPBS 300 install-

ation is with the help of brackets). Noise from the fan

can be transferred to the brackets.

■Install the brackets to an outside wall, ideally in a

room where noise does not matter, in order to elim-

inate noise problems. If this is not possible, avoid

placing it against a wall behind a bedroom or other

room where noise may be a problem.

■Wherever the unit is located, walls to sound sensitive

rooms should be fitted with sound insulation.

■Route pipes so they are not fixed to an internal wall

that backs on to a bedroom or living room.

Installation area

Leave a free space of 500 mm in front of the supply air

module. All service on SAM 40 can be carried out from

the front.

800

NOTE

Ensure that there is sufficient space (300 mm)

above the supply air module for installing

ventilation hoses.

Removing the covers

Front cover

1. Remove the service cover by pulling it straight out.

LEK

7Chapter 2 | Delivery and handlingSAM 40

2 Delivery and handling

LEK

S3 AA5-S2 AA5

AA5

AA5-S2

LEK

XL33 XL34QM20

PF1 HQ11

Svenskt produktblad

XL33 BT23

HQ11

XL34

AA100

QM20

PF 1

BT22

LEK

W6 W1

SF1

W101

SF1

W102

LEK

EP13 XL37 XL36

QN40

GQ3

Svenskt produktblad

GQ3EP13 XL36

XL37

BT69 BT68

QN40

SAM 40Chapter 3 | The design of the supply air module8

3 The design of the supply air module

Pipe connections

Ventilation connection supply airXL33

Ventilation connection outdoor airXL34

Connection, heating medium inXL36

Connection, heating medium out 1

XL37

HVAC components

Supply air batteryEP13

Venting heating mediumQM20

Control valve heating mediumQN40

Sensors etc.

Temperature sensor, supply airBT22

Temperature sensor, outdoor airBT23

Temperature sensor, flowBT68

Temperature sensor, return1

BT69

Electrical components

Accessory cardAA5

AA5-S2 Dip switch

Joint cardAA100

Switch, position 0 - 1, main switchSF1

Cord with connection plugW101

Control cableW102

Ventilation

Supply air fanGQ3

Air filter supply airHQ11

Miscellaneous

Rating platePF1

1Not visible in the image

Designations in component locations according to

standard IEC 81346-1 and 81346-2.

9Chapter 3 | The design of the supply air moduleSAM 40

General pipe connections

Pipe installation must be carried out in accordance with

current norms and directives.

Symbol key

MeaningSymbol

Control valve

Shunt / shuttle valve

Temperature sensor

Expansion vessel

Circulation pump

Fan

Compressor

Heat exchanger

Outline diagram

-EB100 -AZ2

-CP1

Caution

If the total circulating volume in the climate

system (excluding the heat pump volume) falls

below 40 litres, extra system volume is connec-

ted, for example volume vessel UKV (CP1) ac-

cording to the outline diagram above.

NOTE

If several climate systems (ECS 40/ECS 41) are

present, SAM 40 must be connected in parallel

with climate system 1. A circulation pump must

be used to ensure the flow over SAM 40.

SAM 40Chapter 4 | Pipe and ventilation connections10

4 Pipe and ventilation connections

Otros manuales para SAM 40

Tabla de contenidos

Otros manuales de Unidad de control de Nibe

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario