6. NHK HELMET INNER LINING
With the comfort inner lining system, we bring you a completely new development in
regards to; noise reduction, ventilation, and fitment. The innovative soft mesh material
forms around the curves of your head, this way the material does not only feels soft on
your skin but also stays firmly placed. To clean you interior padding, use only mild soap
and water to wash you interior of your helmet. Never allow your helmet to come in
contact high chemical liquid. Do not use washing machine and hot water to clean and
wash.
5
• Micromatic Buckle Strap :
To release the helmet, unfasten the press stud
by pulling on the end of the tape and loosen
the tape by sliding it through the rings, using
the red tab.
How To Fasten :
How To Release :
4. PINLOCK ( ANTI FOG LENS ) *
This NHK GT Avenger series equipped with Pinlock Pin on the visor. You can add and
install your NHK Pinlock® 70 lens. Pinlock® 70 lens is made from a moisture absorbing
plastic. The Pinlock® lens fits exactly into the dedicated recess in the helmet shield and
provides you with a maximized free feld of view. The silicon seal on the Pinlock® lens
creates an insulating air pocket between the Pinlock® lens and the helmet shield. The
pins, between which the Pinlock® lens is to be fitted, are eccentric, which means that the
axis of the pin is not precisely in the center. This enables you to increase or decrease the
tension on the Pinlock® lens by turning the pins, allowing the silicone seal to have a
perfect fit. Please notice! The Pinlock® lens is less resistant to scratching than the helmet
shield!
Buckle Chinstrap
Strap ladder
(A)
(B)
To fasten the strap, push the long tongue firmly into
the buckle until it locks with a click. Pull chinstrap
tight against your throat and the end of chinstrap
ladder to secure it.
-
To release the chinstrap, lift up the red lever and then
release the lock.
-
