Zigbee Switching Actuator Mini
– Setting device parameters: Operating mode (Operation with switch or push-button), nor-
mally open or normally closed contact operation
– Connecting the actuator with Zigbee transmitters or gateways
– Connecting the input to Zigbee devices
– Displaying the switching status: On, Off
– Displaying device information: Device type, software version, hardware version
– Performing a software update
– Resetting to the default setting
– Operating the actuator for test purposes
Coupling and registering new devices
The coupling of new devices is always only possible for approx. 1 minute after mains
voltage return to prevent unauthorised access. Coupling is possible at any time with
devices registered in the app.
￭ Couple the mobile end device via Bluetooth with the device.
￭ Add the new device to the list of registered devices.
￭ Assign a device name.
Performing Zigbee configuration
The actuator can be added to an existing Zigbee network to control the Zigbee devices present
there or to be controlled by transmitters present there.
If no Zigbee network exists, the actuator can create its own Zigbee network by calling it in the
app.
Adding an actuator to the Zigbee network of a gateway
With certain gateways, adding to a network is done via the Touchlink function.
￭ Start search mode for new devices in the Zigbee system. The function call depends on
the gateway, e.g. "Search devices".
￭ Select the Join Network function.
The actuator is displayed in the app of the gateway.
The NEXENTRO Config App displays all available Zigbee devices to which the actuator
can be connected.
￭ Further actions in the NEXENTRO Config App follow.
Using the actuator without an existing Zigbee network, the actuator forms its own network
￭ Select the Create Network function.
The NEXENTRO Config App displays all available Zigbee devices to which the actuator
can be connected.
￭ Further actions in the NEXENTRO Config App follow.
Connecting the actuator to devices via Touchlink
To connect the actuator to another Zigbee device via Touchlink, e.g. a hand-held transmitter or
gateway, Touchlink must be first activated on the actuator.
Requirement: The distance between the devices to be connected is 10 to 50 cm.
￭ Select the Touchlink function.
The actuator is ready to be connected to a device via Touchlink.
￭ Trigger Touchlink on the other Zigbee device.
The actuator is connected to the device.
￭ Further optional actions in the NEXENTRO Config App follow.
8 Commissioning without app
A simplified commissioning can also be carried out without the app.
4 / 7
82403410 11.01.2021
