Multitech MULTIVOIP MVP-410 Manual de usuario

MVP428 Upgrade Card Installation Instructions_______________________

11. Locate the male 60-pin vertical connector near the LED edge of the main

circuit card. Check that pins are straight and evenly spaced. If not, then

correct for straightness and spacing. Locate the 60-pin female connector

on the upgrade circuit card.

12. Set the upgrade circuit card on top of the main circuit card. Align the

upgrade card’s 4 pairs of phone-jacks with the 4 pairs of holes in the

backplane of the main card. Slide the phone jacks into the holes.

13. Mate the upgrade card’s 60-pin female connector with the main card’s 60-

pin male connector.

60-pin connectors

These screws (4 places)

attach upgrade card

to main card.

Figure 7. Attaching upgrade card to main circuit card

(secure 4 Phillips screws; mate 60-pin connectors)

14. There are four copper-plated attachment holes, two each at the front and

rear edges of the upgrade card. Attach the upgrade card to the main card

using 4 Phillips screws. The upgrade card should now be firmly attached

to the main card.

15. Slide the main circuit card back into the chassis far enough to allow re-

connection of power cable.

16. Re-connect power cable.

17. Slide the main circuit card fully into the chassis.

18. Re-attach the backplane of the main circuit card to the chassis with 3

screws.

(Doc. #82010151L, Rev B;

Nov 29, 2006)

Installation Instructions

for

MVP428 Upgrade Card

Note:Your MultiVOIP firmware must be at version 6.09 or higher

before you can install the MVP428 Upgrade Card.

In this procedure, you will install an additional circuit board into the MVP410,

converting it from a 4-channel voip to an 8-channel voip.

Procedure in Detail

1. Power down and unplug the MVP410 unit.

2. Using a Phillips driver, remove the blank cover plate at the rear of

the MVP410 chassis. Save the screws.

screws on blank cover plate (2)

Figure 2: Removing screws from blank cover plate

Summary: (A) Attach four standoffs to main circuit card.

(B) Mate the 60-pin connectors (male connector on main

circuit card; female on upgrade card).



(A)

Add standoffs here

(2 places).



Replace main card screws

with standoffs here

(2 places).

(B)

Mate 60-pin

connectors.

(C)

Attach upgrade card

(screws into standoffs

-- 4 places).

Figure 1. Installation Summary

MVP428 Upgrade Card Installation Instructions_______________________

3. Using a Phillips driver, remove the three screws that secure the main circuit

board and back panel assembly to the chassis.

NOTE:

Follow standard ESD precautions to

protect the circuit board from static

electricity damage.

backpanel screws (3)

Figure 3: Removing screws from back panel

4. Slide the main circuit board out of the chassis far enough to unplug the

power connector.

power connector

Figure 4: Accessing power connector

5. Unplug the power connector from the main circuit board.

6. Slide the main circuit board completely out of the chassis and place on a

non-conductive, static-safe table-top surface.

7. Remove mounting hardware (2 screws, 2 nuts, and 4 standoffs) from its

package.

8. On the phone-jack side of the circuit card, three screws attach the circuit

card to the back panel. Two of these screws are adjacent to the four phone-

jack pairs. Remove these two screws.

Screw locations (2)

at phone-jack edge

of board.

Figure 5: Screws to be replaced with standoffs

(phone-jack edge of board; top view)

9. Replace these two screws with standoffs.

10. There are two copper-plated holes at the LED edge of the circuit card.

Place a nut beneath each hole (lockwasher side should be in contact with

board) and attach a standoff to each location.

Standoff locations (2) at LED edge

of board (top view).

Standoff/nut attachment

(rear bottom view)

Figure 6: Standoffs at LED edge of board

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Hardware de computadora de Multitech

Multitech

Multitech MultiMobile MT10ZLX/E Manual de usuario

Multitech

Multitech MultiModem ISI5634UPCI-4 Manual de usuario

Multitech

Multitech MultiMobile MT56128ZLX-NT Manual de usuario

Multitech

Multitech MultiModem ISI ISI5634UPCI Series Manual de usuario

Multitech

Multitech MultiConnect Dragonfly MTQ-MNG6-B02 Guía de aplicación

Multitech

Multitech ISI608PC Manual de usuario

Multitech

Multitech ISI5634PCI/4/8 Manual de usuario

Multitech

Multitech QuickCarrier MT100UCC Series Manual de instrucciones

Multitech

Multitech CommPlete MTPRI-HD23B Manual de usuario

Multitech

Multitech MT5600SMI Manual de usuario

Multitech

Multitech MultiVOIP MVP24-48 Manual de usuario

Multitech

Multitech MultiModem ISI9234PCIe-4 Manual de usuario

Multitech

Multitech QuickCarrier USB-D MTD-MNA1 Manual de usuario

Multitech

Multitech CommPlete MTPRI-HD23B Manual

Multitech

Multitech MultiConnect Dragonfly MTQ-L1G2D Guía de aplicación

Multitech

Multitech ISI552PC Manual de usuario

Multitech

Multitech MultiModemISI Hybrid Series Manual de usuario

Multitech

Multitech MultiModem ISI9234HPCIE Manual de usuario

Multitech

Multitech MTDOT-915 Series Manual de instrucciones

Multitech

Multitech MultiMobile MT10ZLX/E Manual de usuario

Multitech

Multitech MultiModem ISI ISI5634UPCI Series Manual de usuario

Multitech

Multitech ISI4608-PCI Manual de usuario

Multitech

Multitech ISI3334/EC Guía de referencia

Multitech

Multitech RouteFinder RF802WLC Manual de usuario

Manuales populares de Hardware de computadora de otras marcas

EMC2

EMC2 VNX Series Manual del propietario

Panasonic

Panasonic DV0PM20105 Manual de usuario

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manual de usuario

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manual de usuario

Raidon

Raidon iT2300 Manual de usuario

National Instruments

National Instruments PXI-8186 Manual de usuario

Hauppauge

Hauppauge WinTV-HVR-2250 Manual de usuario

Kontron

Kontron CP6002 Manual de usuario

Manhattan

Manhattan 702843 Manual de usuario

Aphex

Aphex 230 Manual de usuario

AMD

AMD Phenom II Manual operacional

Intel

Intel NUC 12 Pro Manual de usuario

dbx

dbx Zone Pro 1260 Manual de usuario

Galaxy

Galaxy GHDX2-2430S-24F4D Manual de usuario

Intel

Intel AXXRMFBU4 Manual de usuario

Kontron

Kontron DIMM-PC/MD Manual de usuario

ST X-NUCLEO-SAFEA1B Instrucciones de funcionamiento

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manual de usuario