Mobridge Bluetooth Gateway Manual de usuario
Bluetooth Gateway for Audi
User Manual
2010 Fiberdyne Systems Pty Ltd
Welcome
Congratulations on purchasing a mObridge
Bluetooth Gateway for your Audi. The mObridge
Bluetooth Gateway allows for full hands-free
phone control using the existing radio and
steering wheel controls in your Audi vehicle.
This booklet contains important information and warnings
on using your mObridge Bluetooth kit in your Audi.
The booklet is designed to t into
your Audi User Manual
folder. We recommend adding this
booklet to your Audi User
Manual
folder for further reference.
Some illustrations may vary from your vehicle. You should
therefore regard illustrations as a general guide.
Refer to the separate mObridge Bluetooth for Audi:
Installation document for the installation instructions.
An alphabetical index can be found at the end of the guide.
About this Manual
Contents
Getting Started
04
Supported Equipment 04
Features 04
Steering wheel controls 05
Head-Unit Control 06
Base Model Radios 06
Pairing your Bluetooth Phone
06
Connecting & Disconnecting the Phone 07
Operation: Combi-instrument Display
08
Menu Structure 08
Making a phone call from the phonebook
09
Dialing a telephone number 09
Accepting an incoming call 09
Ending a telephone call 09
Accessing Call Lists 10
Changing System Settings 11
Operation: Head Unit
12
Making a phone call from the phonebook 12
Dialing a telephone number 12
Accepting an incoming call 13
Ending a telephone call 13
Sending DTMF tones 13
Call Lists 14
Software Updates
15
Troubleshooting
15
Warranty
15
Index 16
'%44).'34!24%$
",5%4//4(&/2!5$)-!.5!,
GETTING STARTED
04
Supported Equipment
The mObridge Bluetooth kit supports
the following equipment:
RNS-E
BNS 5.0
Chorus II+, Chorus III
Concert II+, Concert III
Symphony II+, Symphony III
Features
Hands free functionality
Dial Numbers
Access your phone book
Answer and Reject Incoming Calls
On-board DSP (digital signal processor)
for advanced noise-free audio.
Getting Started
'%44).'34!24%$
",5%4//4(&/2!5$)-!.5!,
GETTING STARTED 05
NOTES Steering wheel controls and vehicle display may differ between Audi models. This may slightly
change the operation of the mObridge Bluetooth kit between vehicles.
The mObridge Bluetooth kit can be controlled via the steering wheel controls in your vehicle.
An example of the steering wheel controls is found in the diagram below. Your controls may
differ slightly from shown, but the basic operation will remain the same.
Steering Wheel Controls
Applies to vehicles: with steering wheel controls.
6/,5-%
-/$%"544/.
0RESSINGTHE;-/$%=
BUTTONWILLCYCLEBETWEEN
THEAVAILABLEMENUSON
THECLUSTERDISPLAYAND
CANBEUSEDTOSELECTTHE
4ELEPHONE-ENU
6/,5-%
"Y USING THEVOLUME
;6/,5-%=SCROLLWHEEL
ONTHERIGHTHANDSIDE
ITISPOSSIBLETOCHANGE
THEVOICEVOLUMEDURING
ACALL
,%&4(!.$3#2/,,
5SING THE ,EFT ;3#2/,,=
WHEELWILLSCROLLBETWEEN
THEAVAILABLEMENUOPTIONS
!LONGPRESSON
;3#2/,,=DROPSBACK
TOTHEPREVIOUSMENU
3TEERING7HEEL"UTTONS &)'
-/$%
3#2/,,7(%%,
'%44).'34!24%$
",5%4//4(&/2!5$)-!.5!,
PAIRING YOUR BLUETOOTH PHONE
06
Pairing your Bluetooth Phone
Applies to vehicles: All
To pair your Bluetooth phone with the
mObridge Bluetooth kit, you will need to
do the following:
01 Turn ignition on.
02 Using the Bluetooth features of your
phone, perform a search for new devices.
03 Your Bluetooth phone should nd a device
named “CAR BT”. Connect to this device.
04 When prompted for a passkey, enter 1234
which is the default passkey.
05 Your phone should now connect to
the mObridge kit where it can then be
accessed using the steering wheel or
the radio controls.
NOTES
Please consult your phone’s user manual if you
have trouble searching for the mObridge device
from your phone.
A maximum of 5 Bluetooth devices can be paired
with the mObridge system at any time. To pair
an additional device, one or more of the existing
pairings will need to be deleted from the mObridge,
or the factory settings of the mObridge need to
be restored.
For some phones, you must manually allow the
phonebook synchronization to occur, by pressing
“OK” on the phone.
Head-Unit Control
Applies to vehicles: with RNS-E, BNS 5.0,
Concert III, Symphony III
It is also possible to control the telephone
operation using the head unit. Only head
units featuring a telephone mode provide
this functionality.
Base Model Radios
Applies to vehicles: without telephone controls
on the head-unit
Audi base-model radios (i.e. those without
telephone controls) are not capable of
controlling the telephone. In this case the
telephone must be operated only using the
steering wheel controls and cluster display.
'%44).'34!24%$
",5%4//4(&/2!5$)-!.5!,
PAIRING YOUR BLUETOOTH PHONE 07
Connecting a Phone
Now that the phone has been paired to
the system, it will connect and disconnect
automatically when ignition is turned on/off.
When the key is inserted and ignition is on,
mObridge will begin searching for all paired
devices, beginning with the most recent one
connected. It will do this until a connection
has been made. When ignition is switched
off and the key is removed, mObridge will
disconnect from any connected phone. If a
call is ongoing at this time it will transfer to
private mode on the handset.
NOTES
Some phones do not support automatic
connection – for these phones you will need to
manually connect to mObridge using the controls
on your phone.
Automatic Connection & Disconnection
When no phone is connected to the system,
this will be indicated on both the MFD and
also the head-unit (if head-unit features
telephone controls).
When a phone is connected, the current
phone name, signal strength, and network
name will be sent to your vehicle, provided
the phone supports this.
,ATERMODE
VEHICLE
&)'
km
16 16.1
D +19.0°c
IZaZe]dcZ
CdiZ
Telephone not
End
connected or
attached.
#LUSTER$ISPLAY
0HONENOT
CONNECTED
&)'
`b
]
D
E
CD
E=DC:
VOperation: Combi-instrument Display
Applies to vehicles: with DIS display
'%44).'34!24%$
",5%4//4(&/2!5$)-!.5!,
OPERATION: COMBI-INSTRUMENT DISPLAY
08
Menu Structure
Applies to vehicles: All – except A4(B8), A5, Q5
Main Menu
The following menus are available in the Telephone menu on the combi-instrument.
When a phone is connected the entire menu is available.
Phonebook See page 08
Dialed List See page 10
Received Calls See page 10
Missed Calls See page 10
Settings Menu See page 11
When no phone is connected, only the Settings Menu is available.
4ELEPHONE-ENUS &)'
E
E=DC:
7DD@
&$&
!(,$+9
'&&ac
B
E
9>6A:9
A>HI
&$&
!(,$+9
'&&ac
B
E
G:8:>K:9
86AAH
&$&
!(,$+9
'&&ac
B
E
B>HH:9
86AAH
&$&
!(,$+9
'&&ac
B
E
H:II>C<H
B:CJ
&$&
!(,$+9
'&&ac
B
NOTE
In A4(B8), A5, Q5 vehicles, the DIS telephone display
is controlled by your radio. Please refer to your
vehicle documentation for the menu structure
in these vehicles. For instructions on changing
telephone settings in these vehicles, please refer
to the Installation guide.
Tabla de contenidos
