MinimumRC Butterfly V1 Manual de usuario

The Ultimate Possibility of Airplane Kits!

Butterfly V1

Assembly Instructions

1. Cut off the connections (shown blue in the picture) and remove the parts.

2. Use utility knife to cut carbon rods.

3. Divide φ0.8mm carbon rod into: 2x 425mm; 2x 300mm; 1x 117mm; 1x 38mm；1x 31mm.

4. Use 502 glue to attach the φ0.8mm carbon rod to the fuselage frame.

5.

6. Insert a φ1.5mm x 250mm carbon rod into the fuselage and glue it with 502 glue.

7. Install part I.

Note: Place the fuselage on a level surface to ensure part I level. The slots are facing the tail.

8. Assemble the landing gear. Use heat-shrinkable tube to hold the wheels.

9. Combined motor unit. Note: Only the non-skid end of the shaft can be put into the

copper bushing, otherwise it will be stuck.

10. Use glue to bond copper bushing.

11. Install landing gear and battery seat (E), servo seat (L).

In case of resistance, slightly polish the clamp. Temporarily not bonded.

12. Take two φ0.8x300mm carbon rods, combine with part C, and fix with 502 glue.

13. Bend the carbon into tail frame; The end of the carbon rod is extended by 10 mm.

Note: The direction of carbon rod bending is confusing. Please observe the picture.

14. The carbon rod end stopper (part G) has a gap of 4-5 mm between the stopper and the

bracket. (Please read step 13 before bonding)

15. The root of the tail fin needs to be inserted into the groove of part I, and it can rotate

freely without sticking. Excess carbon rods are removed at the end.

16. Use the screws to secure part H to form a full-motion V-tail.

17. Two φ0.8x425mm carbon rods were taken and combined with Part B to form a wing.

Both ends of the carbon rod are 80 mm apart from part B.

18. Use heat-shrink tube to connect the wings on both sides and glue with 502 glue.

19.

20.

21. Use part D to secure the wing.

22.

23. Six propeller adapters (K) have different diameters. Please choose the optimum size

according to the propeller aperture.

24. The propeller adapter is wedge-shaped and is installed with the smaller end facing

forward.

25.Install the propeller.

26.Install the servos. Use Velcro to attach the battery and receiver.

Adjust the center of gravity to 40mm back from the leading edge of wing, glue the

mounting base.

27. Use heat-shrinkable tube to connect the φ1mm carbon rod to the clips.

Note: The length of the push rods needs to be cut according to the actual demand.

Otros manuales de Juguete de MinimumRC

MinimumRC

MinimumRC PZL106 Q Series Manual de usuario

MinimumRC

MinimumRC Ju-87 Manual de usuario

MinimumRC

MinimumRC F4U Corsair Manual de usuario

MinimumRC

MinimumRC Spacewalker V2 Manual de usuario

MinimumRC

MinimumRC LISA Manual de usuario

MinimumRC

MinimumRC Flycat Manual de usuario

MinimumRC

MinimumRC Cessna L-19 Manual de usuario

MinimumRC

MinimumRC P40 Q Series Manual de usuario

MinimumRC

MinimumRC Messerschmitt BF-109 Manual de usuario

MinimumRC

MinimumRC F8F-RareBear Pro Manual de usuario

MinimumRC

MinimumRC Spitfire Manual de usuario

MinimumRC

MinimumRC P-51 Mustang Manual de usuario

MinimumRC

MinimumRC F8F Rare Bear Manual

MinimumRC

MinimumRC T-34 Mentor Manual de usuario

MinimumRC

MinimumRC Shrimp V2 Manual de usuario

MinimumRC

MinimumRC J-3 Manual de usuario

MinimumRC

MinimumRC A6M5-Q Series Manual de usuario

MinimumRC

MinimumRC ASG-32 Manual de usuario

MinimumRC

MinimumRC T-28 Trojan Manual de usuario

MinimumRC

MinimumRC Beech V-35 Manual de usuario

MinimumRC

MinimumRC F8F-RareBear Pro Manual de usuario

MinimumRC

MinimumRC Fan-Jet 600 Manual de usuario

MinimumRC

MinimumRC R-51 Mustang Manual de usuario

MinimumRC

MinimumRC Tigermoth Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario