MIMAKI JFX 200-2513 Manual

Make sure to wear the attached

goggles and glove when you work.

JFX200-2513 / JFX500-2131

Cleaning procedure of head nozzle

Only when the nozzle drop out doesn’t recover with cleaning, daily care and maintenance, please clean

the head nozzle following the procedure below.

Procedure

1. Remove the left side cover of

the machine.

Remove the screw and remove the

cover.

2. Move the carriage(head) to the maintenance space.

(1) Press the key in LOCAL.

(2) Press the key.

(3) Press to select [HEAD MAINT.].

(4) Press the key.

•

Before performing the maintenance, please make sure to attend the training by our engineers. Maintenance

without training may cause failure of the head.

• During maintenance, never rub the nozzles of the head. If rub the nozzle part, the water-repellent surface is

degraded and the head might need to be replaced.

Supply goods for cleaning

Nozzle swab (100) Cleaning stick (50) F200/LF200 Cleaning liquid

for maintenance (100mℓ)

No.SPC-0421 No.SPC-0527 No.SPC-0568

• Make sure to use designated supply goods for nozzle cleaning. Other cleaning goods may cause early

deterioration of the head.

• Head will move for maintenance, please be careful.

[JFX200] Remove the screws

at two positions.

[JFX500] Remove the screws

at four positions.

Cover

Cover

MAINT.

© 2016 MIMAKI ENGINEERING CO., LTD. M018365-00(D203018-10)-15042016

3. Wet a new “nozzle swab” or “clean stick” with the cleaning

solution.

Please wet enough the cleaning solution.

4. Clean the nozzle surface.

(1) Press the "nozzle swab" or "cleaning stick", absorbing cleaning liquid,

against nozzle surface softly for about 10 seconds.

(2) Perform the work (1) to the entire nozzle surface.

5. Press the key after the cleaning.

After initial operation, carriage (head) return to the original position.

Please close the cover.

6. Implement the cleaning [NORMAL].

Please operate with reference to Chapter 4 of the Operation Manual.

7. Perform test printing and check the print result.

Repeat the cleaning and test printing until the result becomes normal.

• Please do not reuse the used clean stick.

It may cause nozzle clogging.

• Please do not rub the nozzle surface and press down strongly

sponge part with your fingers. Nozzle surface is damaged, and it

may cause the discharging defects.

• Please do not re-use the clean stick which was used once. Always

use a new clean stick seconds.

Press softly for 10 seconds

Nozzle surface

KT

Otros manuales para JFX 200-2513

5

Este manual sirve para los siguientes modelos

1

Tabla de contenidos

Otros manuales de Trazador de MIMAKI

MIMAKI

MIMAKI GP-604D Manual de usuario

MIMAKI

MIMAKI JV33-260 Manual de usuario

MIMAKI

MIMAKI CJV30 Series Manual de usuario

MIMAKI

MIMAKI CG-AR Series Manual de mantenimiento

MIMAKI

MIMAKI CG-60AR Instrucciones de instalación

MIMAKI

MIMAKI TS34-1800A Guía de referencia

MIMAKI

MIMAKI CF-0912 Manual de usuario

MIMAKI

MIMAKI DM3-1810S Manual de usuario

MIMAKI

MIMAKI CG-AR Manual de usuario

MIMAKI

MIMAKI CF3-1631 Manual de usuario

MIMAKI

MIMAKI JV400-SUV Series Manual de mantenimiento

MIMAKI

MIMAKI JV33 Series Instrucciones de montaje

MIMAKI

MIMAKI APC-130 Manual de usuario

MIMAKI

MIMAKI CG-AR Series Manual técnico

MIMAKI

MIMAKI cg-100AP Manual de usuario

MIMAKI

MIMAKI CG-60SL Instrucciones de montaje

MIMAKI

MIMAKI CFL-605RT Manual de usuario

MIMAKI

MIMAKI CF22-1225 Instrucciones de instalación

MIMAKI

MIMAKI UJF-7151 plus Manual de usuario

MIMAKI

MIMAKI CG-FX SERIES Manual técnico

MIMAKI

MIMAKI UJF-605C Instrucciones de montaje

MIMAKI

MIMAKI TEXTILE JET TX400 Manual de usuario

MIMAKI

MIMAKI CJV150-75 Manual de usuario

MIMAKI

MIMAKI DM3-1810S Manual de usuario

Manuales populares de Trazador de otras marcas

MUTOH

MUTOH Kona 760 Manual de usuario

HP

HP 7475a Manual de usuario

Vulcan-Hart

Vulcan-Hart FC-500VC Manual de usuario

Roland

Roland TrueVIS VG-640 Manual del propietario

Furuno

Furuno RP-180 Manual de usuario

Roland

Roland VersaCamm SP-540V Manual de usuario

Ioline

Ioline Summit Manual de usuario

Summa

Summa S CLASS Manual de usuario

Gerber Technology

Gerber Technology GERBERplotter MP Series Manual de usuario

Furuno

Furuno RP-17 Manual de usuario

HP

HP 7470A Manual de usuario

SII

SII LP-1010 Manual de usuario

Great Computer

Great Computer JII-61 Manual de usuario

Roland

Roland VersaUv LEF - 12i Manual de usuario

Lectra

Lectra Alys 120 Manual de usuario

MUTOH

MUTOH Ultima SC-850D Manual de usuario

Skycut

Skycut D Series Manual de usuario

Commodore

Commodore 1520 Manual de usuario