Milwaukee PH55 Manual de usuario

BATTERY REPLACEMENT:

Units are supplied with BEPS (Battery Error Pre-venting

System) which avoids any erroneous reading due to low

battery level, by switching the meter off. To replace the

batteries unscrew the battery compartment cap and replace all

three 1.5V batteries while paying attention to their polarity.

Make sure the gasket is in place before screwing back the cap.

Batteries should only be replaced in a nonhazardous area using

the battery type specified in this instruction manual.

WARRANTY:

This meter (base unit) is warranted from all defects in

materials and manufacturing for a period of two years.

The electrode (probe end) is warranted for a period of 6

months.

During this period, the required repair or replacement of parts,

where the damage is not due to negligence or erroneous

operation by the user, will be effected free of charge.

WARRANTY REGISTRATION:

Please go to our web site and register your unit at

http://www.milwaukeeinstruments.com/registration.html

__________________________________________________

FOR A MUCH MORE DETAILED

OPERATORS MANUAL

GO TO OUR WEB SITE / MANUALS SECTION

AT THE FOLLOWING ADDRESS

www.milwaukeeinstruments.com

_______________________________________

Milwaukee Instruments

2950 Business Park Drive

Rocky Mount, NC 27804

Phone # 242-443-3630

PH55 & PH56 WATERPROOF

METER

STARTER MANUAL

•When calibration is completed the unit LED will flash

“OK 2”for 2 sec. then return to the temperature display

& normal operation taking the unit out of the calibration

mode. ** YOU ARE NOW CALIBRATED AND

READY TO PERFORM MEASURMENTS

_____________________________________

#3: OPERATION OF THE PH55 –PH56:

• Remove the unit from your storage container cup or jar

( Remember to always store the probe wet )

• Turn the pH55 - Ph56 on by pressing the ON key.

• Immerse the electrode in the solution to be tested.

• Stir gently and wait for the reading to stabilize.

• After the reading is stable you can press “SET / HOLD”

button and unit will freeze display until you press the

“SET / HOLD” button again to release the display.

• After use, turn unit off by pressing the OFF key and

rinse the end of the probe with water and then return it

to jar or cup for storage.

____________________________________________

#3: STORAGE OF THE PH55 –PH56:

Leave the protective cap off and put the unit back in a

cup or jar that has 1” to 1.5” of either bottle drinking

water, or 4.01 calibration solution, or MA9015 storage

solution

___________________________________________

You Must Move Unit - VERY FAST –Between

The 7.0 & 4.0 Cal Solution During The

Calibration Procedure –> Please Read Through

Instructions prior to starting procedure

NEVER LET YOUR PROBE DRY OUT

_________________________________

NEVER USE DISTILLED OR

DEIONIZED WATER FOR STORAGE

PURPOSES.

Otros manuales para PH55

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de medición de Milwaukee

Milwaukee

Milwaukee MI 404 Manual de usuario

Milwaukee

Milwaukee pH54 Manual de usuario

Milwaukee

Milwaukee REDLITHIUM L4 3PL Manual de usuario

Milwaukee

Milwaukee pH51 Manual de usuario

Milwaukee

Milwaukee REDLITHIUM Manual de usuario

Milwaukee

Milwaukee MC310 Manual de usuario

Milwaukee

Milwaukee MW11 Manual de usuario

Milwaukee

Milwaukee MW11 Manual de usuario

Milwaukee

Milwaukee MI806 Manual de usuario

Milwaukee

Milwaukee T75 Manual de usuario

Milwaukee

Milwaukee M12 CLLP Manual de usuario

Milwaukee

Milwaukee pH600 Manual de usuario

Milwaukee

Milwaukee Mi170 Manual de usuario

Milwaukee

Milwaukee MW805 MAX Manual de usuario

Milwaukee

Milwaukee SM700 Manual de usuario

Milwaukee

Milwaukee C 12 IC AVD Manual de usuario

Milwaukee

Milwaukee REDLITHIUM Manual de usuario

Milwaukee

Milwaukee 2270-20 Manual de usuario

Milwaukee

Milwaukee L4 CLL Manual de usuario

Milwaukee

Milwaukee MW11 Manual de usuario

Milwaukee

Milwaukee MW301 Manual de usuario

Milwaukee

Milwaukee PH55 Manual de usuario

Milwaukee

Milwaukee MR100ATC Manual de usuario

Milwaukee

Milwaukee MC310 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario