MikroTik RouterBOARD 750UP Manual de usuario

www.routerboard.com 1 7-Dec-11

RouterBOARD 750UP

Quick Setup Guide and Warranty Information

The RB750UP is a router with five Ethernet ports. It has one USB 2.0 port, and supports PoE power output to

ports 2-5 (500mA maximum per port).

First use

Connect your WAN cable to port 1,

and LAN computers to ports 2-5

Set LAN computer IP configuration to automatic (DHCP)

RB750UP Default IP address from LAN is 192.168.88.1

Powering

The board accepts powering from the power jack or from the

first Ethernet port (Passive PoE):

direct-input power jack (5.5mm outside and 2mm inside, female, pin positive plug) accepts 8-28V DC

first Ethernet port accepts passive Power over Ethernet accepts 8-28V DC

Normally the power consumption of this device is 2.4W, under maximum load - 3.6W

Power output

This RouterBOARD device can supply PoE powering to external devices from its Ethernet ports. This is convenient as

you don't need any additional PoE injectors to power other devices. This feature is indicated by the letter “P” in the

device model name. The output Voltage will be the same as input Voltage, and this feature will have to be enabled

on the specific ports in RouterOS software. By default it is disabled. Maximum power output of each ethernet port in

this mode is 500mA.

Booting process

This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet

cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of 192.168.88.1

with the username admin and no password.

In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. More

information here: http://wiki.mikrotik.com/wiki/First_time_startup

In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of

the device when starting it until the LED light turns off, and RB750 will start to look for Netinstall servers.

Extension Slots and Ports

Five individual Ethernet ports, supporting automatic cross/straight cable correction (Auto MDI/X), so you can

use either straight or cross-over cables for connecting to other network devices. The Ethernet port accepts

8-28 V DC powering from a passive PoE injector, 12V or more is recommended to compensate for loss in

cables.

www.routerboard.com 2 7-Dec-11

Buttons and Jumpers

ROS reset jumper hole (on the bottom of case, behind one of the rubber feet) –resets RouterOS software to

defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the

device. Hold screwdriver in place until RouterOS configuration is cleared.

RouterBOOT reset button (RESET, front panel) has two functions:

oHold this button during boot time until LED light starts flashing, release the button to reset

RouterOS configuration (same result as with reset hole)

oHold this button during boot time longer, until LED turns off, and then release it to make RB750 look

for Netinstall servers.

Operating System Support

Currently tested operating system is MikroTik RouterOS (starting from v4.17).

reproduced or transmitted in any form without prior written permission from the copyright holder. RouterBOARD,

RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks

appearing in this manual are the property of their respective holders.

Hardware. MikroTik warrants all RouterBOARD series equipment for the term of fifteen (15) months from the

shipping date to be free of defects in materials and workmanship under normal use and service, except in case of

damage caused by mechanical, electrical or other accidental or intended damages caused by improper use or due to

wind, rain, fire or other acts of nature.

To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization)

procedure. Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA

process.

If you have purchased your product from a MikroTik Reseller, please contact the Reseller Company regarding

all warranty and repair issues, the following instructions apply ONLY if you purchased your equipment

directly from MikroTik in Latvia.

We do not offer repairs for products that are not covered by warranty. Exceptions can be made for RB1000,

RB1100 and RB1200.

Out-of-warranty devices and devices not covered by warranty sent to MikroTikls will be returned to the

sender at sender's cost.

RMA Instructions are located on our webpage here: http://rma.mikrotik.com

Manual. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not

limited to, the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made

every effort to ensure the accuracy of the contents of this manual; however, it is possible that it may contain

technical inaccuracies, typographical or other errors. No liability is assumed for any inaccuracy found in this

publication, nor for direct or indirect, incidental, consequential or other damages that may result from such an

inaccuracy, including, but not limited to, loss of data or profits. Please report any inaccuracies found to

[email protected]om

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Enrutador de red de MikroTik

MikroTik

MikroTik BaseBox 2 Manual de usuario

MikroTik

MikroTik RBmAP2nD Manual de usuario

MikroTik

MikroTik RouterBOARD 711-2Hn Manual de usuario

MikroTik

MikroTik RB2011iL-RM Manual de usuario

MikroTik

MikroTik RBSXTR&R11e-LTE6 Manual de usuario

MikroTik

MikroTik netPower Lite 7R Manual de usuario

MikroTik

MikroTik RouterBOARD CRS125-24G-1S-2HnD-IN Manual de usuario

MikroTik

MikroTik RB800 Manual de usuario

MikroTik

MikroTik RB750UPr2 Manual de usuario

MikroTik

MikroTik RB450G Instrucciones de funcionamiento

MikroTik

MikroTik SXTsq Lite2 Manual de usuario

MikroTik

MikroTik Chateau Series Manual de usuario

MikroTik

MikroTik RouterBOARD 951-2n Manual de usuario

MikroTik

MikroTik RouterBOARD 433 Manual de usuario

MikroTik

MikroTik RouterBOARD 711UA-5HnD Manual de usuario

MikroTik

MikroTik RouterBOARD 951-2n Manual de usuario

MikroTik

MikroTik RouterBOARD 2011U Series Manual de usuario

MikroTik

MikroTik RouterBOARD CCR2004-1G-12S+2XS Manual de usuario

MikroTik

MikroTik RouterBOARD 711G-5HnD Manual de usuario

MikroTik

MikroTik RouterBOARD 1100Hx2 Manual de usuario

MikroTik

MikroTik RB2011UAS-RM Manual de usuario

MikroTik

MikroTik hAP ac3 Series Manual de usuario

MikroTik

MikroTik RB2011iL-IN Manual

MikroTik

MikroTik RouterBOARD RB2011U Manual de usuario

Manuales populares de Enrutador de red de otras marcas

Allnet

Allnet ALL0333AU Manual de usuario

HomeSeer

HomeSeer HT-SEL Manual de usuario

Sercomm

Sercomm Genesis OC3505D Manual de usuario

Billion

Billion BIPAC 5102 Series Manual de usuario

TP-Link

TP-Link TD-8817 Manual de usuario

Motorola

Motorola MR1900 Manual de usuario

Digi

Digi IX14 Manual de usuario

Cisco

Cisco NCS 540 Manual

XAVi

XAVi X8821e Manual de usuario

BEC

BEC 6200WZL Manual de usuario

Korenix

Korenix JetNet 5428G Series Manual de usuario

NETGEAR

NETGEAR FS526T - Switch Manual de usuario

Korenix

Korenix JetNet 5710G Series Manual de usuario

Automated Logic

Automated Logic ZN551 Manual del propietario

Cisco

Cisco ASR 1000 Series Manual del operador

EnGenius

EnGenius ESR-9710 Manual de usuario

Cisco

Cisco 805 Series Instrucciones de funcionamiento y seguridad

LevelOne

LevelOne FBR-1416 Manual de usuario