4.1.2. Check the IP address of the miner.
(1) The Miner is powered on after about 30s, the yellow light of the network
port is always on and the green light is flashing under normal circumstances.
Press the IPFOUND button on the panel of the control board (long button) for 5s
or more, The two LEDs on the right side will flash several times to indicate
that the miner has broadcast the IP and MAC addresses to the network.
(2) In whatsMinerTools software to view the miner reported dynamic IP, MAC
address and position.
Notes:
(1) If all the lights on the panel of the control board are not on, please
check the power supply 220V power cable, 12V power cable connection is
reliable, the connection is correct.
(2) If the indicator on the right side of the panel of the control board is
on, but the network port light is off, or the green light does not flash,
please check whether the switch is normal, whether the cable connection is
reliable and the quality of the cable is faulty.
(3) PC running WhatsMinerTools and miner must be in the same network
segment, otherwise it will cause the software not to receive ipfound button
reported IP address and mac address.
(4) If the PC and miner in the same network segment, and the network has
opened the DHCP service, but press the ipfound button, WhatsMinerTools can
not find the miner's ip. Press the reset button on the control board for
more than 5 seconds to restore the factory default configuration, and then
power off the miner and power it on again. Press the ipfound button to
check the miner's ip address after powering on for 30 seconds.
(5) If the PC is running WhatsMinerTools, press the "Start", did not press
ipfound button, but the software automatically found the miner's IP address,
mac address, the reason may be miner's ipfound button stuck panel, to find
the software display mac address corresponding to the miner (control board
