MANUAL Document reference MACPUR/E
VM600 CPUR and IOCR rack controller Edition 2 - September 2019
vi
Applicability of the manual
The manual applies to VM600 rack-based machinery protection systems (MPSs) using a
CPUR/IOCR card pair installed in later versions of the VM600 rack (ABE04x) that contain an
I2C interface (part of the VM600 rack’s VME utility bus).
NOTE: Only later versions of the VM600 rack (ABE04x) containing the VME utility bus are
compatible with the CPUR/IOCR card pair. See 1.3.4 Rack compatibility.
Structure of the manual
This section gives an overview of the structure of the document and the information contained
within it. Some information has been deliberately repeated in different sections of the
document to minimize cross-referencing and to facilitate understanding through reiteration.
The chapters are presented in a logical order. You should read those that are most relevant
to you and then keep the document at hand for future reference.
The structure of the document is as follows:
Safety Contains important information for your personal safety and the correct use of the
equipment.
THIS SECTION SHOULD BE READ BEFORE ATTEMPTING TO INSTALL OR USE THE
EQUIPMENT.
Chapter 1 Introduction: Familiarises the user with the function and features of the CPUR/IOCR card
pair.
Chapter 2 Hardware overview: Provides information on the physical aspects of the CPUR/IOCR card
pair and other system components making up a CMS or MPS. (Provides a brief overview
and describes the elements on the front/rear panels of the CPUR and IOCR cards,
including indicators and connectors.)
Chapter 3 General system description: Describes the CPUR/IOCR card pair from a global, rack-level
point of view and implications for the VM600 rack and the buses.
Chapter 4 CPUR and IOCR card pair: Contains a block diagram of the CPUR/IOCR card pair and
more detail on the functions performed by the cards.
Chapter 5 Hardware installation: Provides information on installing the cards in a VM600 rack. Also
includes important rack safety requirements.
Chapter 6 Software overview: Introduces the software and configuration files applicable to the
CPUR/IOCR card pair, including information on installing VibroSight System Manager.
Chapter 7 Configuring a CPUR / IOCR card pair – hardware configuration: Contains details on
configuring jumpers on the IOCR card.
Chapter 8 Configuring a CPUR / IOCR card pair – configuration and management using VibroSight
System Manager: Contains details on configuring and managing a CPUR /IOCR card pair
using the VibroSight System Manager software. Operations include configuring IP and
time reference settings, uploading/downloading Modbus configurations, updating firmware
and downloading events logs and diagnostic information.
