MegaLite Cobra 1500 Manual de usuario

Check that the unit has not been damaged during transport

Protection Against Fire

1. Maintain a minimum of 1 foot distance from any type of flame.

2. This equipment is designed to be used only with Mega-Lite Fog Fluid

3. Replace fuse only with the specified type and rating.

4. Do Not install the unit to close to a heat source.

5. Make sure cable are properly secured away from unit movement.

6. Maximum surface operating temperature 80º.

Protection Against Electrical Shock

1. Disconnect power before servicing.

2. For connection to main power supply proceed to page 4.

3. This unit must be earthed. (electronically grounded)

4. Do not expose unit to rain or moisture.

5. Always unplug your Cobra fogger before filling it’s tank

6. Running a fog machine with no liquid can permanently damage the unit.

Protection Against Mechanical Hazards

1. Hot fog! Keep away at least 6 feet from nozzle fog output may be hot. Do not aim output at person.

2. Make sure fogger output is not blocked.

3. Fogger output nozzle maybe hot do not touch until unit has been given ample amount of time to cool.

4. Use safety chain when hanging unit

5. Unit may release hot oil do not hang directly above a person or delicate surface.

6. Unit releases an oil base fog that may increase the risk of slipping. Do not aim devise at floor.

7. Unit surface may reach high temperature. Allow about 10 minutes after unit has been turned off be-

fore moving.

8. Never drink fog fluid. If it’s ingested, call a doctor immediately. If fog fluid comes into contact with Skin

or eyes, rinse thoroughly with water.

9. Danger of burns. Fogger must be installed out of reach of children. Never leave the unit running unat-

tended.

Warning!!!

To reduce the risk of fire, electric shock, or injury to person please read the user manual in

it’s entirety, and follow the above safety instructions.

Part Numbers

Fixture Wire Remote Wireless Remote

9215–Cobra 1500 9216–Wire Remote 9217-Wireless Remote

Mechanical Specifications

Fixture Packaged for Shipping

Size: 19.5”L x 9.5”W x 8”H

Weight: 24

Size: 21” x 14” x 14”

Weight: 28lb

DMX Connectors: 3-pin XLR connectors

Power Connection: IEC Power Head

Fastening System: Single Bracket

Tank Capacity: 3.5 Liters / .92 Gallons

Electrical Specifications

Power Input: Ac120V 60Hz

Heater: 1350 Watts

Warm-Up Time: 7~8 min

Output: 25,000 Cuft/min

Heat Ready indicator:Red/Green LED

Operating modes: DMX, Master/Slave

Wire Remote on/off (included)

Wireless Remote Controller (included)

DMX Channels: 1 Channel

Operating mode: DMX, Master/Slave

Control & Programming

Specifications

Main Power Connection

Caution!

1. Do not connect fixture to a dimmer system.

2. This unit must be earthed. (electronically grounded)

3. Replace fuse only with the specified type and rating.

The occupation of the connection-cable is as follows:

Cable (USA) Cable (EU) Pin International

Black Brown

White

Green

Light Blue

Yellow/Green

Live

Neutral

DMX-512 Connection

110V 50/60hz Connection

The fixture is equipped with 3 pin XLR Sockets for DMX input and output. The sockets are wired in parallel. Only use a shielded

twisted pair cable designed for RS-485 and 3 pin XLR plugs and connectors in order to connect the controller with the fixture or

the fixture with another.

DMX—input DMX—output

1. Shield

2. Signal (-)

3. Signal (+)

Caution!

At the last fixture the DMX signal needs to be terminated with a terminator. Solder a 120

Ohm resistor between the (-) and the (+) signal into a 3 pin XLR plug and plug it in to the

last fixture on the signal run. Pre-manufactured terminator plugs are available for

purchase from your Mega-Lite dealer (HOS-DMXT).

DMX-512 Addressing

1 2 3 4 5 6 7 8 9 10

DMX ON

256

128

To address the unit each dipswitch from one to 9 hold a nu-

merical value located on the below the image. You will have to

add the numerical value to give you the correct fixture start

address. The user must assign a start address on the fixture

that indicates the first channel reserved in the controller.

For example if you wish the first unit to start on address chan-

nel 85 you will need to turn on dipswitch 1,3,5 and 7

(1+4+16+64=85)

The Cobra 1500 uses only one DMX Channel for output volume.

For DMX mode set dipswitch 10 to the on position

A blue LED flashing will indicate DMX signal is receiving.

Warm Up Time

There is a approximate 7 to 8 min warm up time for the heat element to be ready.

The Cobra 1500 will indicate that the unit is ready to start to produce fog. When the red LED in the tank storage is off and the

green LED is turned on.

Caution!

1. Do not run the fogger when there is no fog liquid in the storage tank. This may dam

age the liquid pump.

2. Only use Mega-Fog fog fluid liquid.

Wire Remote Control

Wireless Remote Control

1. Connect on/off Wire Remote Controller to Control input on back of machine

2. Switch on power. Red LED next to tank is on when Machine is warming up.

3. When Red LED turns off and the Green LED turns on next to holding tank machine

is ready to fog

4. Press fog button on remote to fog

1. Connect Wireless Receive to Control input on back of machine

2. Switch on power. Red LED next to tank is on when Machine is warming up.

3. When Red LED turns off and the Green LED turns on next to holding tank machine

is ready to fog

4. Press any button on wireless remote to fog

Rigging the fixture

Caution!

1. The installations must be carried out by an authorized dealer or trained professional.

2. Unit may cause severe injures if you have doubts concerning the safety do not install.

3. Use high quality installation equipment to hang unit.

When rigging a unit it is very important that you follow common safety procedures. Rigging requires extensive experience includ-

ing but not limited to calculating working loads, material being used and periodic safety inspections. If you lack these qualifica-

tions, do not attempt the installation yourself, instead use a professional structural rigger.

When rigging the unit always be secured with a secondary safety attachment. The installation location of the projector has got to

be built in the way that it can hold 10 times the weight for 1 hour with out any harming. Installation should be checked at least

one time a year by a skilled person.

Cleaning and maintenance

Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installations and electron-

ics checked by an expert every 2 years.

The following points have to be considered during the inspection:

1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.

2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).

3) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments. Further

instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems

have to be removed.

4) Any Spilled fog fluid showed be cleaned immediately while Fogger is disconnected.

Note: There is no serviceable parts inside the device. Maintenance and service operations are to be carried out by authorized

dealers.

Replacing the fuse: Only replace the fuse with the same type and rating.

Replacing the power cable: If the power cable of this device becomes damaged, it has to be replaced by authorized dealers only

In order to avoid hazards.

Should you have further questions , please contact your dealer.

Parts List

9201 Mega-Fog 55 Gal Drum

9215h Heater

9215p Pump

9215pcb Main PCB card

9200 Mega-Fog 1 Gal

Caution!

To maintain optimum performance fixture should be cleaned frequently. It is recom-

mended to run a cleaning solution composed of 80% distilled water and 20% white vine-

gar through the system to prevent accumulation of particles in the heating element.

Mega-Lite

5718 Kenwick St

San Antonio, TX 78238

Ph 210-684-2600 Fax 210-855-6279

www.mega-lite.com / [email protected]m

Tabla de contenidos

Otros manuales de Equipo de iluminación de MegaLite

MegaLite

MegaLite Axis LED Manual de usuario

MegaLite

MegaLite IDOL-LITE P24 Manual de usuario

MegaLite

MegaLite Outerbot WASH 340 Manual de usuario

MegaLite

MegaLite N-E COLOR Cannon Manual de usuario

MegaLite

MegaLite TUFFBABYVW-42 Manual de usuario

MegaLite

MegaLite HELIUS M Manual de usuario

MegaLite

MegaLite XWITCH Manual de usuario

MegaLite

MegaLite DECO TENTACLE Manual de usuario

MegaLite

MegaLite DECO Cove Q18 Manual de usuario

MegaLite

MegaLite PARAMOUNT PENDANT Q350 Manual de usuario

MegaLite

MegaLite outshine ww100 Manual de usuario

MegaLite

MegaLite Axis QD7 Manual de usuario

MegaLite

MegaLite AXIS 250 Manual de usuario

MegaLite

MegaLite AXIS CYCLOPS Manual de usuario

MegaLite

MegaLite DECO CITYSCAPE Q30 Manual de usuario

MegaLite

MegaLite N-E Color FX18 Manual de usuario

MegaLite

MegaLite ARFlood Manual de usuario

MegaLite

MegaLite Pro Color Cannon 3000 Manual de usuario

MegaLite

MegaLite EB1 Manual de usuario

MegaLite

MegaLite LUPA-7 Manual de usuario

MegaLite

MegaLite LEDiLINE M485 Series Guía

MegaLite

MegaLite Drama W50 LED Manual de usuario

MegaLite

MegaLite AXIS 500 Manual de usuario

MegaLite

MegaLite Drama Strip P840 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario

MegaLite cobra 1500 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas