Lutron Electronics GRAFIK Eye Architrave GRX-4SLB-DW Manual de usuario

Installation

Warning! Always turn Off the circuit breaker/MCB or remove

the main fuse from the power line before doing any work.

Failure to do so can result in serious personal injury.

Proper wiring of Wallstations is dependent upon the GRAFIK Eye Control

System that is providing power. GRAFIK Eye 3000 Series and GRAFIK Eye

4000 Series Control Units have different power limitations and wiring

techniques. Please confirm the type of Control Unit to which the

Wallstation is being wired and use the corresponding instructions that

follow.

Architrave™Style Controls

GRX-4SLB-DW 4 Button Control

(Class 2/PELV Device)

Description

The GRX-4SLB-DW Architrave™Style Control provides local access

to the Lighting Control System to:

■Select groups of scenes in the Lighting Control System.

■Temporarily change the light settings for the current scene.

■Turn lighting zones Off/On.

Indicator LEDs Scene Select

Buttons

Raise/Lower

GRX-4SLB 4 Button Control

2. Strip insulation from wires so that 3/8 in. (10 mm) of bare wire is

exposed for #18 AWG (1.0 mm2) wire.

Each Wallstation terminal accepts up to two #18 AWG (1.0 mm2)

wires. Wiring must be done in a daisy-chain configuration.

3/8 in. (10 mm)

Installation Instructions

Occupant Copy

3. Address Wallstations. Each Wallstation in a system must be

assigned a unique address. Set DIP switches 1—4 of each

Wallstation to one of the positions illustrated below and record its

location.

4. Select function. Set DIP switches 5 and 6

on the Wallstation to select its function. DIP

switch settings and their corresponding

function are shown below.

561234

1234 1234

Set

Address Set

Function

For this address

Set switches Set Switches

like this: Location: like this: Location:

5 6 5 6

Factory Set

Select Scenes 1 - 4 Select Scenes 5 - 8

Select Scenes 9 - 12 Select Scenes 13 - 16

Wiring Notes

■System Maximums:

—8 Unique GRAFIK Eye addresses per

system.

—16 Wallstations per system.

—GRAFIK Eye 3000 Series Control Units can

power a maximum of 3 Wallstations.

—2000 ft. (610 m) wiring length.

—0 °C—40 °C operating temperature.

—Power: wires 1 & 2, 12 VDC-24 VFW.

—Data: wires 3 & 4, twisted pair.

■Terminal 2 (power) is not connected between GRAFIK Eye

3000 Series Control Units.

1. Turn power Off.

Important Notes

1. READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING

INSTALLATION.

2. This control must be installed by a qualified electrician.

3. Install in accordance with the National Electric Code and all

applicable local regulations.

4. Turn power OFF at the control panel before installing controls.

Do not connect high-voltage power to low-voltage terminals.

Improper wiring can result in personal injury and damage to

the control or to other equipment.

5. Use only a cloth with warm water and mild soap to clean face-

plates (no chemical cleaners).

1 2 3 4

1 2 3 4 5 6

1 2 3 4

1 2 3 4 5 6

Wall Stud

Wood

Screws

Yoke

Optional Lutron

Wallbox P/N

241-663

Mounting Diagram

(with backbox) Mounting Diagram

(without backbox)

Lutron Electronics Co., Inc.

Made and printed in U.S.A.

P/N 030-720 Rev. A 7/01

LIMITED WARRANTY

Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture within one

year after purchase. For warranty service, return unit to place of purchase or mail to Lutron at 7200 Suter

Rd., Coopersburg, PA 18036-1299, postage pre-paid.

This warranty is in lieu of all other express warranties, and the implied warranty of mer-

chantability is limited to one year from purchase. This warranty does not cover the cost of

installation, removal or reinstallation, or damage resulting from misuse, abuse, or improper

or incorrect repair, or damage from improper wiring or installation. This warranty does

not cover incidental or consequential damages. Lutron’s liability on any claim for damages

arising out of or in connection with the manufacture, sale, installation, delivery, or use of

the unit shall never exceed the purchase price of the unit.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to

state. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation

may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential

damages, so the above limitation or exclusion may not apply to you.

This product may be covered under one or more of the following U.S. patents: 4,803,380; 4,835,343;

5,463,286; 5,530,322 and corresponding foreign patents

Architrave is a trademark of Lutron Electronics Co., Inc.

Lutron and GRAFIK Eye are registered trademarks of Lutron Electronics Co., Inc.;

Internet: www.lutron.com

E-mail: product@lutron.com

WORLD HEADQUARTERS

Lutron Electronics Co. Inc.,

TOLL FREE: (800) 523-9466

(U.S.A., Canada, Caribbean)

Tel: (610) 282-3800;

International ++1- 610-282-3800

Fax: (610) 282-1243;

International ++1-610-282-1243

GREAT BRITAIN

Lutron EA Ltd.,

Tel: (171) 702-0657;

International ++44-(0)207-702-0657

Fax: (171) 480-6899;

International ++44-(0)207-480-6899

GERMANY

Lutron Electronics GmbH

Tel: (309) 710-4590;

International ++49-30-97-10-4590

Fax: (309) 710-4591;

International ++49-30-97-10-4591

FRANCE

Lutron LTC

International ++33-(0)1-44-70-71-86

Int’l Fax: ++33-(0)1-44-70-70-97

ASIAN HEADQUARTERS

Lutron Asuka Corporation (Japan)

Tel: (03) 5405-7333;

International ++81-3-5405-7333

Fax: (03) 5405-7496;

International ++81-3-5405-7496

HONG KONG SALES OFFICE

Lutron GL (Hong Kong)

Tel: 2104-7733;

International ++852-2104-7733

Fax: 2104-7633;

International ++852-2104-7633

SINGAPORE

Lutron GL (Singapore)

Tel: ++65-220-4666

Fax: ++65-220-4333

6. Mount control as shown in diagram below with or without

optional Lutron backbox (P/N 241-663).

5. Wiring must be done in a daisy-chain and 1-to-1 configuration

(please see Installer's Guide included with Control Unit for more

information). Each Wallstation terminal will accept up to two #18

AWG (1.0 mm2) wires.

1 2 3 4

1 2 3 4 5 6

3000 Series System Wiring. Connect four #18 (1.0 mm2) twisted

pair wires to the Wallstation’s terminal block.

4000 Series System Wiring. Connect two #18 (1.0 mm2)

shielded, twisted pair wires to terminals 3 and 4 of the Wallstation’s

terminal block. Shielding/drain must be connected as shown, but do

not connect to Earth/Ground or Wallstation*. Two #12 AWG (2.5

mm2) power wires will not fit in the terminal blocks, however, #12

AWG (2.5 mm2) is necessary due to voltage drop on the wire. Use

the diagram shown below to make the connections in the wallbox.

2 #12 AWG

(2.5 mm2)

2 #12 AWG

(2.5 mm2)

4 twisted pair,

#18 AWG

(1.0 mm2)

1 #18 AWG

(1.0 mm2)

Drain

Daisy-Chain Configuration

4000 Series System Wiring

3000 Series System Wiring

*Please note that shielding/drain wires are connected to the terminal marked

"D", when available.

Note: Use the wire connector required by local code (those shown are

common in the USA).

Rear View

of Control

System Communications

In order for Wallstations to communicate with a Control Unit,

each Wallstation must be individually configured to “talk” by

putting the Wallstation in setup mode.

1. Put the NTGRX-4SLB-DW in setup mode (only

one Wallstation can be in setup mode at a time).

- Press and hold the buttons indicated for

about 3 seconds, until the LED(s) start

cycling.

Press here

for “talk”

2. Identify the Control Unit(s) that you want to “listen” to this

Wallstation. (Control Units must be addressed in order for

them to “llisten”!)

- Press and hold the top Scene button

on the Control Unit for about 3

seconds, until the LEDs flash in

unison. Repeat for each Control Unit

that you want to “listen” to the Wallstation.

LUTRON

Press

here

for

“listen”

LEDs flash in unison

3. Exit setup mode. Press and hold the same buttons indicated in

Step 1(above) for about 3 seconds until the LEDs stop cycling

(or flashing).

Note: To make a “listening” Control Unit not listen to a

Wallstation: Put the Wallstation in setup mode, then press

the “listening” Control Unit’s OFF button until the LEDs

stop flashing.

Otros manuales de Unidad de control de Lutron Electronics

Lutron Electronics

Lutron Electronics QSGRK-6D Manual del propietario

Lutron Electronics

Lutron Electronics GRAFIK Eye QSGRN-6PCE Instrucciones de funcionamiento

Lutron Electronics

Lutron Electronics PowPak RMJ-CCO1-24-B Manual de usuario

Lutron Electronics

Lutron Electronics Maestro Wireless MRF2-3PD-1 Manual de usuario

Lutron Electronics

Lutron Electronics Vive DFCSJ-OEM-OCC Manual de usuario

Lutron Electronics

Lutron Electronics seeTouch guestroom solutions Manual de usuario

Lutron Electronics

Lutron Electronics Vive PowPak Manual de usuario

Lutron Electronics

Lutron Electronics PowPak RMK-CCO1-24-B Manual de usuario

Lutron Electronics

Lutron Electronics Maestro Wireless Pico Series Manual de usuario

Lutron Electronics

Lutron Electronics RadioRA RAMC-5W Manual de usuario

Lutron Electronics

Lutron Electronics GRAFIK Eye QSGRJ-3P Instrucciones de funcionamiento

Lutron Electronics

Lutron Electronics Vive Series Manual de usuario

Lutron Electronics

Lutron Electronics GRAFIK Eye QSGRJ-3P Instrucciones de funcionamiento

Lutron Electronics

Lutron Electronics GRAFIK Eye QS with EcoSystem Instrucciones de funcionamiento

Lutron Electronics

Lutron Electronics LMM-16R-DV-B Manual de usuario

Lutron Electronics

Lutron Electronics Stanza SZ-2B Manual de usuario

Lutron Electronics

Lutron Electronics LCP128 Manual de funcionamiento

Lutron Electronics

Lutron Electronics PPS-9312 Manual de usuario

Lutron Electronics

Lutron Electronics PowPak Energi TriPak Series Manual de usuario

Lutron Electronics

Lutron Electronics PowPak FC-SENSOR Manual de usuario

Lutron Electronics

Lutron Electronics GRAFIK 6000 Manual de usuario

Lutron Electronics

Lutron Electronics Energi Savr Node Manual de usuario

Lutron Electronics

Lutron Electronics Maestro Wireless MRF2-3PD-1 Manual de usuario

Lutron Electronics

Lutron Electronics QS Timeclock Instrucciones de funcionamiento

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario