Lilin FD2452E Manual de usuario

FD2452E

D/N Megapixel 360° Panorama Dome IP Camera

Quick Installation Guide

CAUTION

 Do not drop or strike this equipment

 Do not install the equipment near any naked flames or heat

sources

 Do not expose this unit to rain, moisture, smoke or dust

environment

 Do not cover the opening of the cabinet with cloth and

plastic or to install this unit in poor ventilated places. Allow

10cm between this unit and its surroundings

 Do not continue to operate the unit under abnormal

conditions such as detection of smoke, strange smell or no

display on screen while power is turned on

 Do not touch the power connection with wet hands

 Do not damage the power cord or leave it under pressure

 Do not operate this unit near magnet, speaker system, etc., to

avoid unnecessary magnetic interference

 onnection cables should be grounded properly

Product Overview

① Alarm In/Out Terminal

② Audio Input 3.5mm Phone Jack (Red)

③ Audio Output 3.5mm Phone Jack (Green)

④ Live Video Output BN Jack

⑤ RJ-45 Network onnector (Support PoE)

⑥ D Power Input Jack (D 12V ±10%)

⑦ Top over

⑧ Micro SD ARD SLOT (Support SD/SDH )

⑨ Reset Key

To restore the server to factory default setting.

⑩ Lens

⑪ Light Sensor

⑫ Microphone

English

Unit: mm

- 1 -

Installation

Installation Structural Drawing

Embedded Mounting Attached Mounting

( eiling base is optional)

English

- 2 -

●

Embedded Mounting (False eiling)

1. Please use the screw driver to untighten the screws on the top

cover (FIG. 1), and to untighten the screws on the cylinder (FIG. 2).

2. Based on the hole site diagram below to cut the circle of diameter

3.6-4.1 inches (90-105mm) (FIG.3, FIG. 4, FIG. 5).

3. onnect the network cable to RJ-45 network port and connect

power cable to D power input jack of the IP camera (FIG.6)

English

- 3 -

4. Attach the camera body to the fixed ring (FIG. 7). Tighten the

screws to fix the camera body (FIG. 8).

5. Put the decorative ring on the camera body. Ring’s positioning

column should be between camera body positioning column and

screw nut (FIG. 9). Rotate the decorative ring counter clockwise

until its position column touch the camera body positioning

column. Tighten the 4 screws (FIG. 10).

English

- 4 -

●

Attached Mounting (Fixed eiling)

1. amera base size and screw location (FIG.11)，and tighten the four

tapping screws into the ceiling (FIG.12).

2. The fixed ring placed on the base (FIG.13). Tighten the four

screws into the base (FIG. 14).

3. onnect the network cable to RJ-45 network port and connect

power cable to D power input jack of the IP camera (FIG.15)

English

- 5 -

4. Attach the camera body to the fixed ring. amera body screw hole

should be aligning to fixed ring’s latch position (FIG.16). Tighten

the two screws to fix the camera body (FIG.17).

5. Put the decorative ring on the camera body. Ring’s positioning

column should be between camera body positioning column and

screw nut (FIG.18). Rotate the decorative ring counter clockwise

until its position column touch the camera body positioning

column. Tighten the 4 screws (FIG.19).

- 6 -

English

System Architectures

For connecting HD IP cameras to the network, please follow one of

the system architectures:

(1). Use a D 12V power adapter and a network switch to connect to

the network.

(2). Use a PoE network switch to connect to the network.

(3). Use a PoE power injector and a network switch to connect to the

network.

English

- 7 -

Emergency Factory Default

To restore factory default settings by hardware, please follow these

steps:

1. Hold “RESET Key” for 10 seconds, then release.

2. After about 40 seconds, the network LED light should turn off,

and the back on again.

3. This camera has completed the factory default settings, and can

then reboot.

4. Search for the IP device using the IPScan software.

5. Start the IP device via Internet browser.

6. Enter the default username “admin” and password “pass” to

operate.

NOTE: For user convenience, restoring the factory default settings

will revert to the default IP address 192.168.0.200.

Before Accessing IP Cameras

Before accessing the IP camera, make sure that the camera’s RJ-45

network, audio, and power cables are properly connected. To set the

IP address, consult your network administrator for an available IP

address. The default IP address for each IP camera is 192.168.0.200.

Users can use the default IP address for verifying the camera’s

network connection.

Software Requirements

Merit LILIN Universal ActiveX software components are required for

web interface display of JPEG or H.264 Full HD video. When you

dialog box will prompt the installation of the LILIN Universal ActiveX.

lick Install to download it.

English

- 8 -

Tabla de contenidos

Otros manuales de Cámara IP de Lilin

Lilin

Lilin IPS7224M Manual de usuario

Lilin

Lilin IPG012ES Manual de usuario

Lilin

Lilin IPS2102E Manual de usuario

Lilin

Lilin IPG1022ELS Manual de usuario

Lilin

Lilin iMEGAPRO IPR722ES Manual de usuario

Lilin

Lilin AHD7324AX10 Manual de usuario

Lilin

Lilin 6122 Manual

Lilin

Lilin iMEGAPRO IPD2220ES Manual de usuario

Lilin

Lilin D/N HD AF IR IP CAMERA Manual de usuario

Lilin

Lilin IPR7424 Manual de usuario

Lilin

Lilin MR3022 Manual de usuario

Lilin

Lilin ZG1232E Manual de usuario

Lilin

Lilin PZD6422X3 Manual de usuario

Lilin

Lilin IPD6220ES3.6 Manual de usuario

Lilin

Lilin H.264 Manual de usuario

Lilin

Lilin IPR414/418ESX3 Manual de usuario

Lilin

Lilin PIH - 7000 IP Series Manual de usuario

Lilin

Lilin IPS622M Manual de usuario

Lilin

Lilin IRS1308 Manual de usuario

Lilin

Lilin AHD DOME Manual de usuario

Lilin

Lilin PIH-0364X WN IP Manual de usuario

Lilin

Lilin iMEGAPRO IPD2122ES Manual de usuario

Lilin

Lilin IPG1022ESX3 Manual de usuario

Lilin

Lilin ipg1022esx Manual de usuario

Manuales populares de Cámara IP de otras marcas

FLIR

FLIR Exx series Manual de usuario

Avigilon

Avigilon H4A-BO1-IR Manual de usuario

Digital Watchdog

Digital Watchdog DWCA-C128-64 Manual de usuario

ShareTech

ShareTech AV1 Manual de usuario

Ezviz

Ezviz C6C Manual de usuario

Melchioni

Melchioni UCAM 2015 Manual de usuario

Geutebruck

Geutebruck G-Cam/ESD-4630 Manual de usuario

Arecont Vision

Arecont Vision MegaBall AV3146DN-3310-D-LG Manual de usuario

Mitel

Mitel 6800i Series Manual de servicio

Vitek

Vitek VTC-IR403-212NP Manual de usuario

THOMSON

THOMSON DSC - 323W Manual de usuario

AVer

AVer FB2027 Manual de usuario

ENFORCER

ENFORCER EV-T5105-N2SQ Manual de usuario

Wansview

Wansview NC543 Manual de usuario

Eneo

Eneo MCB-64A0003M0A Manual de usuario

deView electronics

deView electronics CBDNI36F Manual de usuario

Swann

Swann SwannEye Manual de usuario

LevelOne

LevelOne IP CamSecure Manual de usuario