Leisurecraft Luna Manual de usuario

View the assembly process

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

09/2023

Requirements:

2 People (recommended)

Carpenter Level

Carpenter Square

Step Ladder

Cordless Drill

¼” Nut Driver

11mm Socket

Vice Grips

Tape Measure

Staple Gun

Utility Knife

Rubber Mallet

1 ½” staples , screws or nails to fasten siding

Luna Sauna

Assembly Instructions

Manufactured by:

Index

Base Preparation

Sauna Assembly

Back Wall Bench Assembly

Back Wall Bench with L Bench Assembly

Side Wall Bench Assembly

Standard Porch Bench Assembly

Lounge Bench Assembly

Lounge Bench for Porch Assembly

Electric Heater Installation

Wood Heater Installation (Chimney out the back wall)

Vent Kit Installation

Care &Maintenance

Warranty

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Luna Sauna

Assembly Instructions

Sauna Base Preparation

Make sure the base for your sauna is level with a slight slope to the back for drainage.

A solid base for your sauna is recommended and can be made from any of the following.

It is recommended to build a base larger than required to provide a sitting area for cooling

off during your sauna session.

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Wooden Deck

Crushed Gravel Patio Stones/Paver Blocks

Concrete Pad

Luna Sauna

Assembly Instructions

Sauna Assembly

Make sure you have a solid base for your Luna sauna

and lay out the floor joists.

Lay out the center stave as shown.

This stave will have convex edges on both sides as in

inset.1.

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Center the bottom stave ensuring the dado cuts are

facing upwards.

It should stick over the front floor joist 2” (51mm)

Using 2 ½” (64mm) screws , secure the center stave

to the floor joist.

Repeat at the rear of the sauna.

Space out the remaining floor joists evenly, measure

them to center and secure the center stave to the

joists using a 2 ½” (64mm) screw per floor joist.

Luna Sauna

Assembly Instructions

Inset. 1

Sauna Assembly

Start laying out the bottom staves, there will be 7

staves on either side of the center stave.

The staves for the Luna without the porch option are

symmetrical and can be used on the left or right side

of the center stave and if a porch option is chosen,

there will be left and right sides.

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Use a rubber mallet to tap all the staves tight

together.

Secure staves into each floor joist using 2 ½ (64mm)

screws.

Gather up your pieces for the back wall.

This should consist of 15 straight pcs and 4 pcs with

rounded corners of 2x6x80” (5cm x 15cm x 203cm)

Luna Sauna

Assembly Instructions

Line up the staves so they are flush to each other.

All of the grooves should line up with each other.

Sauna Assembly

The staves with the rounded corners with the holes

closer to the top are for the front wall and the staves

with the holes closer to the middle are for the back

wall.

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Once you get the back wall around halfway

assembled, Slide one of the threaded rods through

the top holes.

Repeat for the bottom holes.

This will take some finessing.

Add the remaining pieces of the back wall onto the

threaded rods.

Luna Sauna

Assembly Instructions

Start assembling the back wall.

Use a rubber mallet if required to tap the staves in

tight to each other.

Sauna Assembly

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Using the assembled back wall as a guide, lay out the

front wall including windows and door.

Slide the threaded rod through the bottom hole into

the small corner stave.

Luna Sauna

Assembly Instructions

Cut any excess threaded rod off from each of the four

holes.

Place a washer and nut on each end of the threaded

rods.

Tighten up the nuts with a wrench, socket or impact

driver.

Sauna Assembly

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Place a washer and nut on each end of the threaded

rods.

Tighten up the nuts with a wrench, socket or impact

driver.

Cut any excess threaded rod off from each of the four

holes.

Use a broom or a brush to remove any debris from

inside the dado grooves.

Luna Sauna

Assembly Instructions

Repeat for the top of the wall.

Continue sliding the rod through the staves until you

reach the other side of the wall.

Sauna Assembly

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Once both walls are centered into the grooves, use a

stave to temporarily brace the walls to prevent them

from falling.

This will provide support while you build the side

walls.

Gather the remaining wall staves.

The wider staves are for the flat and the thinner

staves are for the corners.

Luna Sauna

Assembly Instructions

Repeat the process for the back wall.

With a helper, stand up front wall and place in groove

at the front of the sauna.

Ensure it is centered on either side.

Sauna Assembly

tel: 888-923-9813 | info@leisurecraft.com| web: www.leisurecraft.com

Manufactured by:

Install 11 of the full size 2” x 6” staves on the side wall

and then build the top corners with 6 of 2” x 4” corner

staves in the same manner as the bottom corners.

Repeat on opposite side.

Once the top corners are installed, start installing the

2” x 6” staves on the roof starting from one side.

Do not use screws for the top staves at this point.

Luna Sauna

Assembly Instructions

Once you have the 6 corner 2” x 4” pieces in place to

make the corner, start adding the larger 2” x6” staves

to build up each wall.

Secure staves to the bottom corners of the sauna

wall with 3 ½” (89mm) screws.

The staves on the corners use 3 ½” (89mm) screws

while the staves on the flat wall use 2 ½” (64mm)

screws.

Tabla de contenidos

Otros manuales de Producto de plomería de leisurecraft

leisurecraft

leisurecraft pure cube Orion Outdoor Pure Cube Manual de usuario

leisurecraft

leisurecraft Canadian Timber Luna Manual de usuario

leisurecraft

leisurecraft pure cube Neptune Manual de usuario

leisurecraft

leisurecraft Cedar Panoramic Barrel Sauna Manual de usuario

leisurecraft

leisurecraft Canadian Timber Granby Manual de usuario

leisurecraft

leisurecraft Outdoor Cabin Sauna Manual de usuario

leisurecraft

leisurecraft Canadian Timber Tranquility Manual de usuario

leisurecraft

leisurecraft CTC88CW Manual de usuario

leisurecraft

leisurecraft Canadian Timber Mini Pod Manual de usuario

leisurecraft

leisurecraft Mini Pod Manual de usuario

leisurecraft

leisurecraft Cedar Barrel Sauna with Half Moon Windows Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario

leisurecraft Luna Manual de usuario

Manuales populares de Producto de plomería de otras marcas