Leica Viva TS16 Manual de usuario

Athletics ACT

Leica TS16 EDM

Operating Instructions

2

Background

The Leica TS16 EDM was purchased new from CR Kennedy, Sydney in May 2022. Its purchase was

enabled by a grant received from ACT Sport and Recreation. It came with the Leica Captivate

software and the Athletics module (v.7) software.

Author

These operating instructions were produced by Lyle Dahms, Athletics ACT, who arranged the grant

and purchase of the EDM.

Key information

To modify the TS16 settings and open up the hidden modules, you need the password to

‘TS16-athletic’: crk

The original certificate of calibration is below.

3

IMPORTANT SAFETY INFORMATION

4

5

LEICA TS16 EDM AND EQUIPMENT

The following equipment is used to operate the EDM:

•The EDM case contains: the EDM, 2 x batteries, 17.5mm prism and spike

•The ancillaries box contains: prism pole, golf tees for check mark, spirit level, base plates for

tripod feet, steel tape, rag for drying steel tape

•The battery charger is located in the AIS tech shed.

6

7

8

MEASURING THROWS

This section explains how to set up the EDM for measuring throws.

Positioning the EDM

Choose a position that has clear lines of

sight to the centre of the circle (8m mark

for jav), the rim of the circle (foul line for

jav) and the landing sector. The EDM

must not be in a position that could be hit

by an implement thrown out of sector.

The EDM operator must be able to

communicate clearly with the recorder.

The EDM can be set up on the track

surface using the three metal base plates

for the tripod legs. The diagram below

illustrates potential EDM locations. Note

the position of the EDM that can be used

for both javelin and shot put.

Set up the tripod

Extend and spread the legs of the tripod. Adjust the legs so that the height of the tripod is level with

the sternum of the operator. This could be in a standing or sitting position. The legs should be

orientated so that operator is between two legs of the tripod when facing the landing sector (see

cover picture). This alignment is modified when the EDM is being set up to measure throws in

adjacent event sites (see diagram below).

The top of the EDM should be roughly level. If the EDM is being set up on grass, press the feet into

the ground. If the EDM is being set up on a track surface, place the base plates beneath the feet.

9

Check and adjust the level

of the EDM using the spirit

level. The level should be

placed front-back and then

side-side.

Adjust the leg length (or

press on the tripod feet) to

level the EDM.

Mount the EDM

Remove the cover from the top of the EDM and

mount the EDM on the tripod. It should be

orientated so that the focusing eye ring is facing

the operator and the base is aligned to the shape of

the EDM top. Secure the EDM to the top of the

tripod using the screw knob beneath the top of the

tripod.

10

Insert battery

Insert the battery as shown in the diagram below. Make sure the electrodes are at the top and

pointing in.

Level the EDM

Level the EDM using the three tribrach foot screws on the base of the EDM. Ideally, the foot screws

should be in the mid point of their range and minimal adjustment should be required to level the

EDM. The EDM is level when the bubble in the circular level is in the middle ring.

Turn on the EDM

Press and hold on/off button for 2 seconds. Wait for EDM to boot. This will take about a minute.

If you receive a warning about the SD card or CCP contract, press F4 [ok] to continue.

Digital level

At the digital level page, level the EDM using the tribach (ie EDM base) foot screws. The EDM will

indicate the direction to turn the footscrews. Once the EDM is level, press F6 [next] to continue.

Otros manuales para Viva TS16

2

Tabla de contenidos

Otros manuales de Instrumento de medición de Leica

Leica

Leica Rangemaster CRF 1600 Manual de usuario

Leica

Leica Rugby 640G Manual de usuario

Leica

Leica DNA03 Manual de usuario

Leica

Leica RANGEMASTER CRF 1200 Manual de usuario

Leica

Leica 3D Disto Manual de usuario

Leica

Leica Builder Series Manual de usuario

Leica

Leica Lino ML90 Manual de usuario

Leica

Leica PIPER 100 Manual de usuario

Leica

Leica LASER ALIGNMENT DIGICAT 100 Manual de usuario

Leica

Leica DISTO S910 Manual de instrucciones

Leica

Leica Rugby 840 Manual de usuario

Leica

Leica iCON gps 60 Manual de usuario

Leica

Leica FlexLine plus Manual de usuario

Leica

Leica 3D Disto Manual de usuario

Leica

Leica GS09 Manual de usuario

Leica

Leica APO-SUMMICRON-SL Manual de usuario

Leica

Leica TS01 Manual de usuario

Leica

Leica PIPER 100 Manual de usuario

Leica

Leica Nova MS60 Manual de usuario

Leica

Leica HDS7000 Manual de usuario

Leica

Leica TC605 Manual de usuario

Leica

Leica iCON iCR70 Manual de usuario

Leica

Leica 3D Disto Manual de usuario

Leica

Leica DISTO D110 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario