LEGRAND HKRL10 Manual de usuario

installation guide

Smart Switch

Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HKRL10

with HomeKit Technology

table of contents

before you start..................................3

what you need ...................................4

getting to know your switch ..........6-7

installation and setup ................ 8–23

speciﬁcations.............................24-25

faqs ....................................... 25–29

regulatory information ......... 30–33

warranty.......................................34

support ........................................35

before you start

Review this guide in its entirety before beginning device installation. Consult an

electrician with any questions or if you are unsure of your abilities.

DWarning: Incorrect installation could

result in death, serious injury, and/or

damage to your home or devices.

DCaution: To reduce the risk of injury

and/or overheating and damage to other

equipment:

• For dry, indoor use only.

• Do not use to power medical equipment.

• Not suitable as a disconnecting means.

• Do not use with loads exceeding the

device load rating (see page 24).

• Connect the smart switch to a

120 VAC, 60 Hz power source ONLY.

• Always use copper wire to install the

smart switch and follow all applicable

local and national electrical codes.

• Install in a non-metallic electrical box

to protect wireless signal strength.

Visit the Legrand website at www.legrand.us/radiant/homekit.aspx to learn more about

your smart device.

what you need

REQUIRED:

Phillips-head screwdriver

Flat blade screwdriver

YOU MAY ALSO NEED:

Non-contact voltage tester, pliers, wire cutter, wire stripper, electrical tape,

ﬂashlight, radiant®screwless wallplate (included), wiring leads (included), and

wire nuts (included)

NOTE: Exercise caution when using power tools. Overtightening the screws can

damage the device.

getting to know your switch

Item Name Description

1 Paddle Switch

• Press the top of the paddle to turn the light on

and the bottom to turn the light off.

• To return the switch to factory default, press and

hold the top of the paddle for 15 seconds. Then,

remove the device from the Legrand Home app

(or Apple Home app).

2 LED Locator Light Indicates the current state of the device. Refer to

“LED Locator Light Explanations” for detail.

NOTE: For in-wall control of this switch in a three-way application, refer to the installation

instructions for the HomeKit Remote Switch (HKRL20).

LED LOCATOR LIGHT EXPLANATIONS

LED

Color State of Light Explanation

Slowly Flashing

Amber

Device is attempting to connect to

the network

Solid White Connected to Wi-Fi and turned off

No Light Device is on

Rapidly Flashing

Amber

N-Way Pairing mode: device is

ready to pair with the remote(s)

installation & setup

step one

turn off the power for your device at the

circuit breaker

Flip the existing light switch multiple times to conﬁrm the power is off.

NOTES:

• If there are multiple devices next to your existing light switch, make sure power is

off at the circuit breaker for all of those devices.

• For multi-way installations using a remote switch, follow the instructions for the

remote device (HKRL20).

OFF

installation & setup

step two

remove the existing device

Check for the following wires:

1HOT or LINE: Receives power from the circuit box. Referred to as “hot” for the

purposes of this guide. Do not touch or let “hot” wires contact other wires.

2LOAD: Directs power to your light(s).

3NEUTRAL: Creates a path to return current to the power source when the

device is off. Required for your switch installation.

4GROUND: Provides a safe path for electricity in the event of a short circuit.

NOTE: Refer to the “faqs” on page25 if you are unsure of your wiring.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de LEGRAND

LEGRAND

LEGRAND XMS-1208P Manual de usuario

LEGRAND

LEGRAND DMX Manual de usuario

LEGRAND

LEGRAND Valena Allure 7 525 90 Manual de usuario

LEGRAND

LEGRAND Niloe 7 64X 71 Manual de usuario

LEGRAND

LEGRAND Celiane 670 85 Manual de usuario

LEGRAND

LEGRAND Pro 21 7756 44 Manual de usuario

LEGRAND

LEGRAND Plexo 0 698 50L Manual de usuario

LEGRAND

LEGRAND LEXIC 037 23 Manual de usuario

LEGRAND

LEGRAND 3 109 53 Manual de usuario

LEGRAND

LEGRAND Wattstopper LMDM-101-R Manual de usuario

LEGRAND

LEGRAND 841 01 Manual de usuario

LEGRAND

LEGRAND 0 676 94 Manual de usuario

LEGRAND

LEGRAND Watt Stopper RS-250 Manual de usuario

LEGRAND

LEGRAND DRD3 v2 Manual de usuario

LEGRAND

LEGRAND Celiane 670 51 Manual de usuario

LEGRAND

LEGRAND Valena Life 7 521 84 Manual de usuario

LEGRAND

LEGRAND Whad 5-6 kVA Manual de usuario

LEGRAND

LEGRAND 4771 Manual de usuario

LEGRAND

LEGRAND Qmotion QIS Manual de instalación

LEGRAND

LEGRAND Celiane CB9050 Manual de usuario

LEGRAND

LEGRAND radiant LC2201 Manual de usuario

LEGRAND

LEGRAND Galion K8/31D20AN-HK Manual de usuario

LEGRAND

LEGRAND In One Celiane 672 56 Manual de usuario

LEGRAND

LEGRAND LUXUL SW-505-8P-F Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario