Larson Electronics LED10W-1X2LT Manual de usuario

Larson Electronics LLC www.Magnalight.com

9419 E US HWY 75, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364 - E: [email protected]m

LED10W-1X2LT Instructions

BATTERY SPECIFICATIONS

12 volt output

33 Amp hour AGM sealed lead acid

Built-in automatic charger rated for continuous duty

Voltage indicator gauge with push-to-test button

External charge cord receptacle, U.S. or foreign power cord supplied

Battery rated for 300+ full discharge cycles

3-5 year estimated service life

1 year warranty

SET-UP

1. Charge unit for 24 hours when new and every three months thereafter to maintain a full charge

(Charge monthly in hot weather)

2. Do not charge or use this light in hazardous location

3. Extend retractable legs if necessary for uneven terrain

4. Extend aluminum pole to desired height and tighten each pole section into position

OPERATION

1. Single head light will operate over 40 hours on a full charge

2. Dual head light will operate over 20 hours on a full charge

3. The power port provided can be used to operate a cell phone, a laptop computer, or any of

Larson Electronics’ handheld light with cigarette plug. The power port can be used a quick

charge inlet for the light from an automobile’s 12-volt power port.

4. Order Larson Electronics’ power port duel end cable for connection from vehicle to light.

SAFETY AND USAGE INFORMATION

1. Read these instructions completely before using the products and save them for future

reference.

2. Do not use unit to recharge dry cell batteries

3. Do not jump-start or attempt to recharge a frozen battery.

4. Charge unit in a well-ventilated area.

5. All batteries are affected by temperature changes, and the unit’s small, lightweight battery is

more sensitive to storage temperature than a standard automotive battery. Temperatures

above 68F degrees (20degrees C) decrease amperage output. The ideal storage environment

for emergency use is at room temperature.

Larson Electronics LLC www.Magnalight.com

9419 E US HWY 75, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364 - E: [email protected]m

BATTERY STATUS GAUGE

1. Press the RED push button momentarily to turn the gauge on:

2. The GREEN shaded indicator bar indicates the unit is capable of normal operation.

3. The YELLOW shaded indicator bar indicates the unit needs to be recharged.

4. The RED shaded indicator bar indicates the unit must be recharged before use.

RECHARGING

1. Plug the unit into 115 VAC and note the lighted gauge indicator for battery status.

2. The unit may be recharged by using an optional accessory power port cord with two male ends.

3. Plug one end into the unit’s 12V outlet and the other end into the vehicle’s 12V power port

socket. The vehicle must be running to charge with this method.

STORAGE

Unit may be stored virtually anywhere, and in any position.

BATTERY REPLACEMENT

This unit contains a sealed non-spill able lead acid battery. The battery must be recycled.

Contact Larson Electronics’for replacing battery.

Tabla de contenidos

Otros manuales de Luz de trabajo de Larson Electronics

Larson Electronics

Larson Electronics WAL-DL-60LED-M-GCR50-SP0002 Manual de usuario

Larson Electronics

Larson Electronics GNM-LEDWL-25W Manual

Larson Electronics

Larson Electronics WAL-QP8-WP60PM-GRC50 Manual de usuario

Larson Electronics

Larson Electronics WAL-SBDL-WP60E-XX-1227 Manual de usuario

Larson Electronics

Larson Electronics EHL-LED-120X12V-XGFI Series Manual de usuario

Larson Electronics

Larson Electronics RL-85-LED-36W-CPR Manual de usuario

Larson Electronics

Larson Electronics LEDWP-600E-OS Manual

Larson Electronics

Larson Electronics EHL-LED-15W-50-HR Manual de usuario

Larson Electronics

Larson Electronics EPL-BS-25WRE Manual

Larson Electronics

Larson Electronics EPL-FL-26 Manual de usuario

Larson Electronics

Larson Electronics EXPRL-98 Manual de usuario

Larson Electronics

Larson Electronics WL-LED-12-M Manual de usuario

Larson Electronics

Larson Electronics WAL-TP.S-RL16-LED Manual de usuario

Larson Electronics

Larson Electronics WAL-BP-3XLED-CPR Manual de usuario

Larson Electronics

Larson Electronics WDL-12-IPS-LED-1227 Manual de usuario

Larson Electronics

Larson Electronics WAL-TP-2X50E-1224 Manual de usuario

Larson Electronics

Larson Electronics WAL-WBC-500LTL-LED-100 Manual de usuario

Larson Electronics

Larson Electronics EPL-QC-16C-2X50LED-RT-X24V-C1D1-12.3-100-EPP Manual de usuario

Larson Electronics

Larson Electronics EPL-PM-150LED-X24I-100 Manual

Larson Electronics

Larson Electronics EPL-BS-70LED-6XMB-150X12 Manual

Larson Electronics

Larson Electronics GL-9900 Manual

Larson Electronics

Larson Electronics EPL-QC-16C-2X50LED-RT-100 Manual de usuario

Larson Electronics

Larson Electronics EPL-BS-150HPS Series Manual

Larson Electronics

Larson Electronics LEDWP-250E-DLC-5000K Manual

Manuales populares de Luz de trabajo de otras marcas

ANSMANN

ANSMANN POWERLIGHT 5.1 Manual de usuario

RTRMAX

RTRMAX RTX1868 Manual de usuario

FeinTech

FeinTech LAL00220 Manual de usuario

Bunker Hill Security

Bunker Hill Security 64735 Manual de usuario

Goobay

Goobay 30450 Manual de usuario

REV Ritter

REV Ritter SPOT Manual de usuario

Ignition

Ignition Stagepix Line 100 IP Manual de usuario

SCANGRIP

SCANGRIP DUO CONNECT Manual de usuario

Bosch

Bosch GLI 18 V Manual de usuario

Bayco

Bayco SL-1514 Manual de usuario

EUFAB

EUFAB SMD LED 8+1 Manual de usuario

DeWalt

DeWalt DCL510 Manual de usuario

PowerSmith

PowerSmith PWLD080T Manual de usuario

MaxLite

MaxLite 73683 Manual de usuario

Heitronic

Heitronic Trend 27867 Manual de usuario

Monzana

Monzana Gore MZCL10 Manual de usuario

EINHELL

EINHELL TE-CL 18/2000 LiAC Manual de usuario

Bayco

Bayco NIGHTSTICK Dual-Light Xtreme Lumens... Manual de usuario