Larson Electronics EPL-PM-150LED-X24I-100 Manual

EPL-PM-150LED-X24I-100

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

EPL-PM-150LED-X24I-100 Instruction Guide

150W Portable Explosion Proof LED Work Light

Thank you for your purchase of the Larson Electronics EPL-PM-150LED-X24I-100 Portable Explosion Proof

LED Light. Please follow the steps below in order to operate and maintain this product.

IMPORTANT

READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE EPL-PM-150LED-X24I-100 MUST BE OPERATED IN ACCORDANCE WITH NATIONAL

ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY

HAZARDOUS LOCATION WHERE THE LIGHT IS TO BE USED.

WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE

DISCONNECTED WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.

WARNING: WHEN INSTALLING THIS LIGHT IN HAZARDOUS LOCATIONS, CHECK THE OPERATING

TEMPERATURE LIMITS PRIOR TO INSTALLATION TO BE SURE IT CONFIRMS TO THE ENVIRONMENTAL

TEMPERATURE RESTRICTIONS AND NEC CLASSIFICATIONS. CHECK THE FIXTURE’S METAL NAMEPLATE FOR

TEMPERATURE (T) RATINGS.

WARNING: DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POWER OFF BEFORE STARTING

INSTALLATION OR REPAIR.

WARNING: OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE

TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.

WARNING: SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.

OPERATING

Before operation, confirm that the power source will provide the correct voltage indicated on the product

nameplate. Ensure the receptacle will accept the cord cap attached to the light.

Check product nameplate for Ratings and Approvals.

Place the light in the desired location and run its power cord and transformer to a power source OUTSIDE

HAZARDOUS AREA! Ensure all safety requirements are followed for the hazardous area.

WARNING: Transformer and standard plug may only be used OUTSIDE

HAZARDOUS AREA! Only the cable, stand, and light head are rated for

HAZARDOUS AREAS.

The light head can be adjusted by loosening the hand screws on each side,

positioning the light head and tightening the hand screws to hold the light in place.

This light is “instant-on” once plugged in to a live circuit.

AVOID DIRECT EYE EXPOSURE Do not look at the face of or directly into the light when plugging in or when

illuminated.

HAND SCREW

EPL-PM-150LED-X24I-100

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

MAINTENANCE

It is recommended that you implement a standard monthly or more frequent preventive maintenance schedule.

Safety requires a thorough visual examination of the unit for physical damage that might cause a spark or

result in the ignition of hazardous atmospheres.

Maintenance includes a careful examination to ensure at least:

A. The Light Body is not cracked, broken or breeched.

B. The Lens is not cracked or chipped.

C. The Cable is not frayed and is gripping tightly in all points of cable contact.

D. The Cable Jacket is completely intact and that no internal conductors or conductor insulation

is exposed.

E. The Connection Box is not cracked, broken or breeched.

F. The Cord Plug is not cracked or damaged and the Ground Post is intact.

For your safety and to maximize the life of the light, avoid rough usage such as:

G. Pulling the Light by the Cable, which could weaken or damage the cable.

H. Impacting the lens with hard, sharp or heavy objects, which could cause the lens to scratch,

chip, crack, or shatter.

I. Disconnecting the Cord Plug from the receptacle by pulling on the Cable.

Keeping the light clean and free of material splatter, overspray, and debris during usage will ensure the

maximum life and luminosity of the light.

TROUBLESHOOTING

Refer to the guide below or contact the manufacturer if the fixture does not function properly.

Is the correct line voltage being supplied to the fixture?

Is the fixture properly grounded?

Make sure installed power switch is functioning properly (if applicable).

These instructions may not cover all details or variations of this product for your equipment or installation

requirements. Should further information not covered by these instructions be required, please contact Larson

Electronics at 1-800-369-6671 for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

Tabla de contenidos

Otros manuales de Luz de trabajo de Larson Electronics

Larson Electronics

Larson Electronics EHL-LED-240X12V-50 Manual de usuario

Larson Electronics

Larson Electronics WAL-TP.S-2XRL16-LED Manual de usuario

Larson Electronics

Larson Electronics LEDP5W-12LT Manual de usuario

Larson Electronics

Larson Electronics GNM-LEDWL-25W Manual

Larson Electronics

Larson Electronics EPL-16C-1MLED-300 Manual de usuario

Larson Electronics

Larson Electronics WAL-BP-3XLED-CPR Manual de usuario

Larson Electronics

Larson Electronics WAL-WBC-500LTL-LED-100 Manual de usuario

Larson Electronics

Larson Electronics WAL-TP-2X50E-1224 Manual de usuario

Larson Electronics

Larson Electronics L810 Manual de usuario

Larson Electronics

Larson Electronics RL-85-LED-36W-CPR Manual de usuario

Larson Electronics

Larson Electronics WAL-TP.S-RL16-LED Manual de usuario

Larson Electronics

Larson Electronics LEDWP-600E-OS Manual

Larson Electronics

Larson Electronics EXPRL-98 Manual de usuario

Larson Electronics

Larson Electronics WAL-QP-2X500LTL-LED-100 Manual de usuario

Larson Electronics

Larson Electronics LEDWP-600E-DLC-5000K Manual de usuario

Larson Electronics

Larson Electronics EPL-FL-26 Manual de usuario

Larson Electronics

Larson Electronics WL-LED-12-M Manual de usuario

Larson Electronics

Larson Electronics WAL-QP8-WP60PM-GRC50 Manual de usuario

Larson Electronics

Larson Electronics LEDWP-250E-DLC-5000K Manual

Larson Electronics

Larson Electronics WAL-SBDL-WP60E-XX-1227 Manual de usuario

Larson Electronics

Larson Electronics EPL-QC-16C-2X50LED-RT-X12V-C1D1-12.3-100-EPP Manual de usuario

Larson Electronics

Larson Electronics RSLED Manual de usuario

Larson Electronics

Larson Electronics EPL-BS-25WRE Manual

Larson Electronics

Larson Electronics EPL-QC-16C-2X50LED-RT-100 Manual de usuario

Manuales populares de Luz de trabajo de otras marcas

ANSMANN

ANSMANN POWERLIGHT 5.1 Manual de usuario

RTRMAX

RTRMAX RTX1868 Manual de usuario

FeinTech

FeinTech LAL00220 Manual de usuario

Bunker Hill Security

Bunker Hill Security 64735 Manual de usuario

Goobay

Goobay 30450 Manual de usuario

REV Ritter

REV Ritter SPOT Manual de usuario

Ignition

Ignition Stagepix Line 100 IP Manual de usuario

SCANGRIP

SCANGRIP DUO CONNECT Manual de usuario

Bosch

Bosch GLI 18 V Manual de usuario

Bayco

Bayco SL-1514 Manual de usuario

EUFAB

EUFAB SMD LED 8+1 Manual de usuario

DeWalt

DeWalt DCL510 Manual de usuario

PowerSmith

PowerSmith PWLD080T Manual de usuario

MaxLite

MaxLite 73683 Manual de usuario

Heitronic

Heitronic Trend 27867 Manual de usuario

Monzana

Monzana Gore MZCL10 Manual de usuario

EINHELL

EINHELL TE-CL 18/2000 LiAC Manual de usuario

Bayco

Bayco NIGHTSTICK Dual-Light Xtreme Lumens... Manual de usuario