Larson Electronics EPL-QC-16C-2X50LED-RT-100 Manual de usuario

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com

1of 3

100W EXP LED Light - 14,000 Lm - Cart Mount - Quick Change

Mount - C1D1 - 100' 16/3 SOOW - GEN Plug

Instruction Manual

This explosion proof wheelbarrow light is designed for illumination of industrial locations. It uses the latest in

solid state lighting technology for long life, low maintenance and high efficiency.

The unique design focuses the light where it is needed, giving improved efficiency over a conventional HID

luminaire.

An internal, universal input, power-factor-corrected switch-mode supplyallowsit to be used from any

nominal120-277V AC 50/60Hz, stepped down to 12V DC, power supplywithout any variation in light

output.

WARNING

To avoidthe riskof fire,explosion or electric shock, this product should be installed, inspected and

maintained by a qualified electricianonly, in accordance with all applicableelectrical codes.

To avoidelectric shock:

Be certain electrical power is OFF before and during installation and maintenance.

Luminaire must be connected to a wiring system with an equipment-grounding conductor.

To avoid explosion:

Make sure the supply voltage is within the luminaires’ voltage rating.

Ensure the marked T rating is less than the ignition temperature of the Hazardous Atmosphere.

Do not operate in ambient temperatures above those indicated on the luminaire nameplate.

Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

The light fixture on this wheelbarrow cart is factory sealed.

CART OPERATION

The wheelbarrow cart assembly consists of 2 parts:

1. Light head

2. Wheelbarrow cart base

To assemble cart, insert light head over center hole of wheelbarrow cart and tighten hand screw. The

wheelbarrow cart is now ready for use.

Tilt cart using both handles and maneuver like a wheelbarrow. Simply roll entire assembly to a new location

once assembled. Make sure light head is secure prior to maneuvering cart.

WARNING: Be sure all hand screws are tight before transporting! Use caution when maneuvering near

inclines or drop offs.

Run power cord to a nearby compatible receptacle outputting voltage listed on product label.

WARNING: check nameplate for proper voltage. Damage from improper voltage may void warranty.

To adjust light head vertically, loosen hand screws on either side. Once desired angle is achieved, tighten

both hand screws to secure light in its place. Loosen the single hand screw holding light head to rotate

horizontally. Be sure all hand screws are tight before transporting!

EPL-QC-16C-2X50LED-RT-100

(877) 348-9680

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com

2of 3

MOUNTING

The quick change mounting system allows for quick mount and dismount from the mounting base. To remove,

loosen the center collar towards the base of the mount to free the base in order to remove it from the cart.

Twist counter-clockwise until loose, lift collar and slide light head away from the base. Follow these steps in

reverse order for attaching light head.

WIRING (see attached wiring diagram)

This unit comes preconfigured with selected cord cap, color temperature, and beam angle. Once deployed,

plug cord cap into compatible receptacle.

Voltage: This explosion proof LED light is universal voltage capable and can be operated with

100-277V AC, 50/60 Hz without modifications to the fixture. A low voltage version of this LED

fixture that operates on AC/DC voltages from 11-25 volts is also available. 18-48V AC/DC voltage

models are available for network systems and marine vessels. We also offer an additional

347-480V high voltage, 125-250V DC, and 0-10V dimmable versions of this explosion proof LED

light fixture.

Follow all applicable local, state, and National Electrical Code for the hazardous area!

WARNING: CHECK NAMEPLATE

FOR PROPER VOLTAGE. DAMAGE

FROM IMPROPER VOLTAGE WILL

VOID WARRANTY.

EPL-QC-16C-2X50LED-RT-100

(877) 348-9680

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before

performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void

the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine

checks to be made on a yearly basis. Frequency of use and environment should determine this. It is

recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:

Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric performance.

Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid

cleaner.

3. Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions or

contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

EPL-QC-16C-2X50LED-RT-100

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER

INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT

1- FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com 3of 3

(877) 348-9680

877-348-9680

Tabla de contenidos

Otros manuales de Luz de trabajo de Larson Electronics

Larson Electronics

Larson Electronics EPL-16C-1MLED Manual de usuario

Larson Electronics

Larson Electronics WAL-DL-60LED-M-GCR50-SP0002 Manual de usuario

Larson Electronics

Larson Electronics EXPRL-98 Manual de usuario

Larson Electronics

Larson Electronics LEDWP-250E-DLC-5000K Manual

Larson Electronics

Larson Electronics EPL-BS-25WRE Manual

Larson Electronics

Larson Electronics WAL-QP8-WP60PM-GRC50 Manual de usuario

Larson Electronics

Larson Electronics EPL-BS-70LED-6XMB-150X12 Manual

Larson Electronics

Larson Electronics LED10W-1X2LT Manual de usuario

Larson Electronics

Larson Electronics WAL-TP.S-2XRL16-LED Manual de usuario

Larson Electronics

Larson Electronics L810 Manual de usuario

Larson Electronics

Larson Electronics AML-LED-WP40-M-22C Manual

Larson Electronics

Larson Electronics EHL-LED-120X12V-XGFI Series Manual de usuario

Larson Electronics

Larson Electronics GL-9900 Manual

Larson Electronics

Larson Electronics LEDWP-600E-DLC-5000K Manual de usuario

Larson Electronics

Larson Electronics WL-LED-12-M Manual de usuario

Larson Electronics

Larson Electronics WAL-QP-2X500LTL-LED-100 Manual de usuario

Larson Electronics

Larson Electronics WAL-TP.S-RL16-LED Manual de usuario

Larson Electronics

Larson Electronics EPL-PM-150LED-X24I-100 Manual

Larson Electronics

Larson Electronics WDL-12-IPS-LED-1227 Manual de usuario

Larson Electronics

Larson Electronics EHL-LED-15W-50-HR Manual de usuario

Larson Electronics

Larson Electronics RSLED Manual de usuario

Larson Electronics

Larson Electronics LEDWP-600E-OS Manual

Larson Electronics

Larson Electronics EPL-QC-16C-2X50LED-RT-X24V-C1D1-12.3-100-EPP Manual de usuario

Larson Electronics

Larson Electronics EPLC2-MB-100LED-100 Manual de usuario

Manuales populares de Luz de trabajo de otras marcas

ANSMANN

ANSMANN POWERLIGHT 5.1 Manual de usuario

RTRMAX

RTRMAX RTX1868 Manual de usuario

FeinTech

FeinTech LAL00220 Manual de usuario

Bunker Hill Security

Bunker Hill Security 64735 Manual de usuario

Goobay

Goobay 30450 Manual de usuario

REV Ritter

REV Ritter SPOT Manual de usuario

Ignition

Ignition Stagepix Line 100 IP Manual de usuario

SCANGRIP

SCANGRIP DUO CONNECT Manual de usuario

Bosch

Bosch GLI 18 V Manual de usuario

Bayco

Bayco SL-1514 Manual de usuario

EUFAB

EUFAB SMD LED 8+1 Manual de usuario

DeWalt

DeWalt DCL510 Manual de usuario

PowerSmith

PowerSmith PWLD080T Manual de usuario

MaxLite

MaxLite 73683 Manual de usuario

Heitronic

Heitronic Trend 27867 Manual de usuario

Monzana

Monzana Gore MZCL10 Manual de usuario

EINHELL

EINHELL TE-CL 18/2000 LiAC Manual de usuario

Bayco

Bayco NIGHTSTICK Dual-Light Xtreme Lumens... Manual de usuario