Larson Electronics EXP-LED-RL-FX5R Manual de usuario

Larson Electronics LLC WWW.MAGNALIGHT.COM

9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E: [email protected]

EXP-LED-RL-FX5R

Thank you for choosing the EXP-LED-RL-FX5R rechargeable lantern. Welcome to the next generation of rechargeable

portable hand lanterns.

Please read this instruction manual before using your EXP-LED-RL-FX5R lantern. It includes important operating and

safety instructions. NOTE: Charge the EXP-LED-RL-FX5R Lantern overnight before first use.

The EXP-LED-RL-FX5R lanterns come in 4 basic systems:

GX1 Class 1 Division 1 INDUCTION rechargeable AC 100-240 volt and DC-12 volt cigarette lighter power cord, and an

induction charge rack and a nickel metal hydride battery pack.

GX1 Class 1 Division 1 Power Failure INDUCTION rechargeable AC 100-240 volt and DC 12 volt cigarette lighter power

cord and an induction charge rack and a nickel metal hydride battery pack.

GX2 rechargeable AC 100-240 volt and DC 12 volt cigarette lighter power cord, and a standard contact charge rack and a

6 volt 6 amp hour sealed lead acid battery.

GX2 Power Failure rechargeable AC 100-240 volt and DC 12 volt cigarette lighter power cord, and a standard contact

charge rack and a 6 volt 6 amp hour sealed lead acid battery.

The Power Failure units provide emergency lighting automatically when the power fails.

SAFETY NOTICES

CAUTION: To reduce the risk of explosion, fire, and electrical shock or injury, DO NOT charge your EXP-LED-RL-

FX5R lantern in a hazardous environment. ONLY CHARGE THE EXP-LED-RL-FX5R LANTERN IN NON-HAZARDOUS

ENVIRONMENTS.

DO NOT attempt to recharge your EXP-LED-RL-FX5R Lantern in any charger other than the one supplied.

DO NOT attempt to charge any other product with your with the EXP-LED-RL-FX5R Charge Rack

NEVER leave your EXP-LED-RL-FX5R Lantern on with its lamp face against any surface, including skin, while the

lantern is turned on. The heat buildup may cause burns and or fire.

Careful observation of the charge rack LEDs serves as an important warning of possible malfunction which may

cause battery overcharging. The red LED should be on while the lantern is in the Charge Rack and charging.

When fully charged, the red LED turns off and the green LED turns on. The Lantern is ready for operation. If the

red LED blinks, remove the Lantern from service.

In extremely rare circumstances, an overcharged battery may produce a flammable hydrogen gas. In the

unlikely event that this gas should ignite, personal injury could result.

The EXP-LED-RL-FX5R should note be turned on and off in the Charge Rack.

PLEASE recycle the battery.

DO NOT INCINERATE THE BATTERY. IT CAN EXPLODE IN A FIRE.

Larson Electronics LLC WWW.MAGNALIGHT.COM

9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E: [email protected]

Handle the battery carefully. Never allow it to short circuit. It can deliver hundreds of Amperes of current and

cause a fire.

CHARGE RACK AND CHARGING

To release the Lantern from the rack, squeeze the on-off switch of the Lantern and lift the Lantern up

and out of the Charge Rack.

To charge the Lantern, simply place the Lantern into the Charge Rack. It automatically locks in place and

starts charging.

CHARGE RACK MOUNTING

The charge rack is mounted by removing the 2 mounting screws at the top of the charge rack and sliding the metal

mounting bracket off the charge rack, then using 4 screws or bolts, attach the metal rack to the desired surface, then

slide the charge rack on to the metal mounting bracket and replace the 2 mounting screws in the top of the charge rack.

POWER SUPPLY

1. Never directly wire any Charge Rack directly to any 120 volt AC power source. It is intended for 12-15 volt DC

only.

2. Make sure that the installation is fused. 2 amps per unit are recommended.

LAMP REPLACEMENT (FOR GX2 Model Only)

Before replacing the halogen bulb, make sure it is cool before touching. Use of gloves and safety glasses are

recommended while changing the bulb.

To remove the lamp, unscrew the lamp ring by rotating the ring counter clockwise.

Then pull the reflector assembly out of the lantern and unscrew the lamp socket from the reflector.

Pull the bulb straight out of the lamp socket.

Repeat the procedure in reverse to replace the bulb.

VEHICLE POWER REQUIREMENTS

Maximum ampere draw from a completely discharged lantern is 2 Amps for the first 10 hours and 35 Amps from then

on. Nominal charging current is 1 Amp.

USAGE TEMPERATURE

-24°C (-11.2°F) to +44°C (+111.2°F)

Tabla de contenidos

Otros manuales de Flash de Larson Electronics

Larson Electronics

Larson Electronics EPL-UV-20W-G2 Manual de usuario

Larson Electronics

Larson Electronics EXP-LED-RL-FX5R-199 Manual de usuario

Larson Electronics

Larson Electronics HIDH-3550 Manual de usuario

Larson Electronics

Larson Electronics ATX-20-SA Manual de usuario

Larson Electronics

Larson Electronics LE-224 Manual de usuario

Larson Electronics

Larson Electronics ASX-25 Manual de usuario

Larson Electronics

Larson Electronics EXP-LED-F4W-R2 Manual de usuario

Larson Electronics

Larson Electronics EXP-LED-FX2-2M Guía

Larson Electronics

Larson Electronics NSR-9850 Manual de usuario

Larson Electronics

Larson Electronics EXPRL-91 Manual de usuario

Larson Electronics

Larson Electronics ATX-20-SE Manual de usuario

Larson Electronics

Larson Electronics RL-11-LED Manual de usuario

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR-NC Manual de usuario

Larson Electronics

Larson Electronics SLEDB-110V-M Manual de usuario

Larson Electronics

Larson Electronics ATX-20-S Manual de usuario

Larson Electronics

Larson Electronics FL-15-HID Manual de usuario

Larson Electronics

Larson Electronics EPL-UV-20W Manual de usuario

Larson Electronics

Larson Electronics FL-LED-STR-51 Manual de usuario

Larson Electronics

Larson Electronics EXP-TP-RL-1XFX5R Manual de usuario

Larson Electronics

Larson Electronics EXP-LED-51 Manual de usuario

Larson Electronics

Larson Electronics LE-2317C Manual de usuario

Larson Electronics

Larson Electronics AEX-20-LED-SA Manual de usuario

Larson Electronics

Larson Electronics LE-2206-LED Manual de usuario

Larson Electronics

Larson Electronics EXPFL-31 Manual de usuario

Manuales populares de Flash de otras marcas

StreamLight

StreamLight PROPOLYMER 2AA Manual de usuario

StreamLight

StreamLight Stinger Manual de usuario

Silverline

Silverline 994024 Manual de usuario

Gama Sonic

Gama Sonic 23i60065 Manual de usuario

Olympia

Olympia RG580 CREE XM-L2 Manual de usuario

EUFAB

EUFAB 13495 Manual de usuario

OLIGHT

OLIGHT S35 BATON Manual de usuario

Kopp

Kopp Emergency Sensor Light Manual de usuario

YLP

YLP PROFESSIONAL Series Manual de usuario

Light motion

Light motion GoBe Manual de usuario

MOB

MOB MO8622 Manual de usuario

EuroLite

EuroLite KKS-3 Manual de usuario

Carson

Carson 500907010 Manual de usuario

Duracell

Duracell 550 Manual de usuario

Mactronic

Mactronic Black Eye 1300 Manual de usuario

Eurotops

Eurotops 29780 Manual de usuario

MOB

MOB MO8690 Manual de usuario

Pelican

Pelican L1 1930 LED Manual de usuario