Lanzar Vector VCT2020 Manual de usuario

36Watts2ChannelHighPowerMOSFETAmplifier

with Protection LED Indicator

www.Lanzar.com

You have purchased a quality product designed and engineered to give you many years of uncompromised

musical service. Lanzar Vector ampliers are designed with the lates technology available, which provides

headroom for even the most demanding peaks and dynamic ranges found on modern CD's and recordings.

TABLE OF CONTENTS

Features and Specications

Electrical Connections

Stereo/Mono Input Connections

System Wiring Speaker Connections

Mounting and Installation

Protection Circuitry and Troubleshooting

Precautions

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY

AND KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE.

www.Lanzar.com

Features and Specications

Crossover Mode Selector: When used with neutral, full range system, set this switch to "FULL". lf you wish to use the

internal crossover to power a driver or specic frequency range, use the "LPF" or "HPF' for the "L0WPASS" or "HIGH-

PASS" settings.

Input Level Controls: Enables the matching of input levels to the output levels from head unit (or other signal source).

The input sensitivity of adjustment ranges from 6V to 200mV.

Crossover Frequency Control: When crossover mode selector is in HIGHPASS mode, this cantrol sets the lower

frequency limit for audio program sent to the speakers. When crossover mode selector is in LOWPASS mode, this

control sets the upper frequency limit for audio program sent to the speakers. The crossover is continously variable

adjustment from 40 to 250Hz.

Bass Boost Selector: This selector switch permits the bass level an increase of 18dB.

Low Level Input: This amp features RCA type jacks for high impedance input. Use these with car stereo input which

uses RCA type connector cables.

High Level Input: If your car stereo jacks are not RCA type output, use the high-low level input adaptor to connect the

speaker output leads of car stereo and the RCA input jacks of amp.

AUX Line Outputs: This amp features RCA jacks for AUX line outputs. Use these for unlimited system expansion to the

next amplier.

www.Lanzar.com

Power LED: This indicator is illuminated in Green when power is applied.

Protection LED: This indicator is illuminated in Red when the built-in protection circuitry is activated.

Power Fuse: The fuse protects the amplier and your car's electrical system from short circuit conditions.

Power Terminals: Use these connectors to deliver power, ground, and remote turn-ON control to the amplier.

Speaker Connectors: These terminals are guarantee high conductivity and minimum signal loss.

Features:

• Slim Size Amplier Design For Easy Installation

• Thermal / Overload / Short Circuit Protection

• Soft Turn On/O

• Power & Protection LED Indicator

• Low-Level RCA Input: 20K Ohms

• Line Level RCA Output

• MOSFET Power Supply

What's in the Box:

• 2-Channel High Power Amplier

Technical Specs:

• Construction Material: Aluminum Badge, Aluminum Heatsink

Iron End Panels

• Variable Hi-Pass: 40 Hz-250 Hz

• Variable Low-Pass: 40 Hz-250 Hz

• Variable Input Level (Gain) Control: 6V-200mV

• Bass Boost Switch:0-18dB

• 36W x 2 @ 4 Ohms, 14.4V

• 2 Ohm Stable

• Frequency Response: 15 Hz-30K Hz

• Signal to Noise Ratio: >95dB

• THD:0.1 %

• 2x20 Amp Maxi Type Fuse

• Dimensions: 10.63''W x 1.78''H x 7.48''

www.Lanzar.com

Controls

Low level inputs

AUX line inputs

Input level control Bass boost selector

Crossover mode selector

Crossover frequency control

Power/protection LED

Power fuse

Speaker connections

Power Terminals

www.Lanzar.com

Electrical Connections

Stereo/Mono Input Connections

Using LOW Level Inputs

12V battery

To remote turn-ON

+12V

Head unit

L/R Audio

Outputs

www.Lanzar.com

Using HIGH Level Inputs

Mono Input Connections

Using LOW Level Inputs

Head unit

High Level

Input Adaptor

LL RR

Another

Amplier

From speaker terminals

Head unit

Y Adaptors

to a second

amplier

www.Lanzar.com

Using HIGH Level Inputs

System Wiring Speaker Connections

Stereo Output Mode

Head unit

LL RR

Another

Amplier

From speaker terminals

High Level

Input Adaptor

High Level

Input Adaptor

LEFT Speaker

2-4 OHMS

RIGHT Speaker

2-4 OHMS

www.Lanzar.com

Bridged Mono Output Mode

Mounting and Installation

Your new Lanzar Vector Amplier comes complete with all required mounting hardware. When determining a suitable

location in your vehicle for the amp, please remember that it is a high-power electronic device capable of generating

high heat.

For this reason, always choose a location in your vehicle which has low vibration, adequate ventilation,

a minimum of dust, and no moisture. Be sure to mount the amp in such a manner as to allow reasonable air ow

over the cooling ns.

Speaker

MINIMUM SPEAKER

IMPEDANGE 4 0HMS!

www.Lanzar.com

Mark the location for the mounting screw holes by positioning the amp where you wish to install it and use a scribe

(or one of the mounting screws) inserted in each of the mounting holes to mark the mounting surface.

If the mounting surface is carpeted, measure the hole centers and mark with a felt tip pen.

Before attempting to drill the mounting holes, take note of any wires, lines or other devices in your vehicle

which may be Iocated behind the mounting surface! Then drill pilot holes in the mounting surface for the mounting

screws and insert them. Tighten the screws securely.

When making electrical connections to your amplier, please observe the following:

• Use at least 8 gauge wire for power and ground connections.

• Wire the amplier directly to the car battery.

• For the ground connection, use the shortest possible wire to a good chassis ground point.

• Wire the remote connection to the auto start lead of your head unit, equalizer or power antenna.

About Power Fuses:

Lanzar Vector ampliers feature built-in fuse systems. These fuses protect both the amplier and electrical system in

your vehicle from fault conditions. If you ever need to replace the fuse in your amplier, use a fuse of exactly the same

type and rating. A dierent type or rating may result in damage or re.

Tabla de contenidos

Otros manuales de Amplificador de Lanzar

Lanzar

Lanzar OPTI Class-D Manual de usuario

Lanzar

Lanzar MAXP 2760N Manual de usuario

Lanzar

Lanzar HERITAGE HTG 214 Manual de usuario

Lanzar

Lanzar HTG 888 Manual de usuario

Lanzar

Lanzar MXA224 Manual de usuario

Lanzar

Lanzar LANZAR MAX MXA214 Manual de usuario

Lanzar

Lanzar vibe4000D Manual de usuario

Lanzar

Lanzar Heritage HTGBD1 Manual de usuario

Lanzar

Lanzar Distinct DCT202 Manual de usuario

Lanzar

Lanzar MXA214 Manual de usuario

Lanzar

Lanzar OPTI 1200HC Manual de usuario

Lanzar

Lanzar MNX260 Manual de usuario

Lanzar

Lanzar HTG889 Manual de usuario

Lanzar

Lanzar Distinct DCT202 Manual de usuario

Lanzar

Lanzar OPTI Class-D Manual de usuario

Lanzar

Lanzar LANZAR MAX MXA1600 Manual de usuario

Lanzar

Lanzar HTG137 Manual de usuario

Lanzar

Lanzar LANZAR MAX MXA214 Manual de usuario

Lanzar

Lanzar Vibe Manual de usuario

Lanzar

Lanzar Vector VCT-2110 Manual de usuario

Lanzar

Lanzar VIBE211 Manual de usuario

Lanzar

Lanzar Opti 1000D Manual de usuario

Lanzar

Lanzar MXA214 Manual de usuario

Lanzar

Lanzar LANZAR VIBE X6 Manual del propietario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario