Kutai electronics ADVR-083 Manual de usuario

KUTAI ELECTRONICS INDUSTRY CO., LTD.

TEL : +886-7-8121771 FAX : +886-7-8121775 Website : www.kutai.com.tw

Headquarters : No.3, Ln. 201, Qianfu St., Qianzhen Dist., Kaohsiung City 80664, Taiwan

ADVR-083

Universal Hybrid Analog-Digital

Voltage Regulator Operation Manual

Analog / Digital AVR, Single-phase / Three-phase Voltage detection, 8 Amp,

Voltage Regulator for use with Auxiliary Winding, PMG, and self-excited

(SHUNT) brushless generators.

Can be used together with KUTAI Auxiliary Excitation Booster module to

increase motor starting capacity of shunt generators.

___________________________________________________________________________________________

2ADVR-083

SECTION 1 : SPECIFICATION

Sensing Input (E1, E2, E3) Average Reading

Soft Start Ramp Time

Voltage and Frequency DIP switch settings

4 seconds +/- 10%

1 phase (E1, E2) / 3 phase (E1, E2, E3)

90 130 Vac @ 110 Vac

Voltage Regulation

180 260 Vac @ 220 Vac

Less than +/- 0.5% (with 4% engine governing)

340 520 Vac @ 440 Vac

Frequency 50/60 Hz

Typical System Response

Less than 20 milliseconds

Power Input (X1, X2, Z2)

Voltage 60 300 Vac, 1 phase / 3 phase

EMI

1 phase ( X1, X2 ) / 3 phase ( X1, X2, Z2 )

Built-in Harmonic suppression

Frequency 40 500 Hz

Static Power Dissipation

Auxiliary Input (Z1, Z2)

Max. 6 watts

Voltage 60 300 Vac, 1 phase 2 wire

Frequency 40 500 Hz

Under Frequency Protection (Factory Preset)

50 Hz system preset knee point at 45 Hz

Excitation Output (F+, F-)

60 Hz system preset knee point at 55 Hz

110V 1 phase Continuous 63 Vdc 8A

Max. 90 Vdc 10A for 10 secs.

Over Excitation Protection

220V 1 phase Continuous 125 Vdc 8A

25 105% of Input Power (adjust with EXC pot.)

Max. 180 Vdc 10A for 10 secs.

O/E acts after 10 sec. delay. The OE function can be

220V 3 phase Continuous 150 Vdc 8A

turned OFF by adjusting EXC. clockwise to max.

Max. 215 Vdc 10A for 10 secs.

Resistance Min.15 ohms, Max.100 ohms @ 220V

Voltage Thermal Drift

Fuse Spec. Slow blow 5 x 20 mm 10A

Less than 3% from -40 to +70 ˚C

External Voltage Adjustment (VR1, VR2)

Under-Frequency Knee Point Thermal Drift

Max. +/- 10% @ 1K ohm 1 watt potentiometer

Less than +/- 0.1 Hz from -40 to +70 ˚C

Quadrature Droop Input (S1, S2)

Environment

CT N:5A or N:1A (DIP switch setting)

Operation Temperature -40 to +60 ˚C

Burden : greater than 5VA

Storage Temperature -40 to +85 ˚C

Sensitivity +/- 7% @ PF +/- 0.5

Relative Humidity Max. 95%

(Can be adjusted through Droop setting)

Vibration 5.5Gs @ 60 Hz

Analogue Voltage Input (A1, A2)

Dimensions

Input resistance greater than 2K ohms

150.0 (L) x 135.0 (W) x 61.0 (H) mm

Input Range +/- 5 Vdc or 0 10 Vdc

5.91 (L) x 5.31 (W) x 2.40 (H) inch

Sensitivity Max.1 Vdc = 5% change in output voltage

(Can be adjusted through Trim setting)

Weight

750 g +/- 2%

Build Up Voltage

1.654 lb +/- 2%

Greater than 5 Vac, 25 Hz residual volts input power

ATTENTION

In order to avoid permanent damage to the AVR confirm that the voltage sensing input setting matches

the generator before use (DIP switches SW5 and SW6)

___________________________________________________________________________________________

ADVR-0833

SECTION 2 : OUTLINE / SIZE / INSTALLATION REFERENCE

130.0 [5.12"]

150.0 [5.91"]

21.5 [0.85"]

61.0 [2.40"]

135.0 [5.31"]

115.0 [4.53"]

5.5 [0.22"]

Figure 1 Outline Drawing

___________________________________________________________________________________________

4ADVR-083

SECTION 3 : DIP SWITCH PROGRAMMING & VR ADJUSTMENTS

VOLT：Voltage Adjustment

Sensing input voltage range set by DIP

switches SW5 and SW6

X1, X2：Single Phase Power Input

Z1, Z2：Auxiliary Power Input

X1, X2, Z2：Three Phase Power Input

Remark : X1 and Z1 are the same point

(internally shorted)

S1, S2：Quadrature Droop Input

Sensitivity +/- 7% @ PF +/- 0.5

CT N : 5A or N : 1A set by DIP

switches SW3

VR1, VR2：External VR Input

Must be shorted when not in use

A1, A2：Analog Voltage Input

Max. Input +/- 5 Vdc or 0 –10 Vdc

DROOP：DROOP Adjustment

(Parallel operation)

Droop Adjustment

Used only during parallel operation

F+, F-：Excitation Output

Connects to generator excitation field

E1, E2：Single Phase Sensing Input

E1, E2, E3：Three Phase Sensing Input

Single Phase / Three Phase sensing set by DIP

switch SW7

EXC.：Over Excitation Protection Adjustment

25 105% of Rated Excitation (Adjustable)

Adjust EXC. potentiometer clockwise to

Max. to turn OFF O/E protection

STAB：Stability Adjustment

Stability range set by DIP

switches SW1 and SW2

U/F：Under-Frequency LED

Under-Frequency Protection status

(ON = Activated)

DIP：U/F Protection Voltage Slope

Adjustment

When U/F protection is activated the voltage

drop ratio can be adjusted by DIP switch.

Adjustment range 3 to 6 V/Hz

UF：UnderFrequencyAdjustment

Under frequency knee point setting

50 Hz system：40 to 50 Hz adjustable

60 Hz system：50 to 60 Hz adjustable

O/E：Over Excitation LED

Over Excitation Protection status

(ON = Activated) Excitation Output

will be reduced after a 10 sec delay

TRIM：Analogue Voltage Input Adjustment

Max. Input +/- 5 Vdc or + 10 Vdc

Sensitivity 1 Vdc for 5% (adjustable)

5140 (61)(50)

F S

ADVR-083

ON OFF

3CT 5A CT 1A

450 Hz 60 Hz

71Φ SENSING 3Φ SENSING

1. OFF 2. OFF <90KW

1. OFF 2. ON 90-500KW

1. ON 2. ON >500KW

5. OFF 6. OFF 110V

5. ON 6. OFF 220V

5. OFF 6. ON 440V

___________________________________________________________________________________________

ADVR-0835

SECTION 4 : WIRING CONNECTIONS

Dotted lines represent a three-phase input. Do not connect if installed in single-phase system

ADVR-083

Field

potentiometer

1k /1W

External

ADVR-083

Field

potentiometer

1k /1W

External

Figure 3 Self-Excited (SHUNT) 110/220 Vac

Single phase / Three phase

Figure 4 Self-Excited (SHUNT) 440 Vac

Single phase / Three phase

ADVR-083

Field

AUX. wires

potentiometer

1k /1W

External

ADVR-083

Field

potentiometer

1k /1W

External

Figure 5 Auxiliary Winding 110/220/440 Vac

Single phase / Three phase

Figure 6 PMG 110/220/440 Vac

Single phase / Three phase

___________________________________________________________________________________________

6ADVR-083

ADVR-083

Field

OUT1

OUT2

B B

IVT

Fuse

Time

Test

Output

Ready

Test

Batt-Volt

OVLD

Droop

1260

2460

potentiometer

1k /1W

External

Figure 7 ADVR-083 & IVT-1260 / IVT-2460 Wiring Connection

Self-Excited (SHUNT) 110/220 Vac Single phase / Three phase

ADVR-083

potentiometer

1k /1W

External

Field

OUT-

OUT+

B B

Fuse

Test

Output

Ready

Test

Batt-Volt

OVLD

Droop

Gain

IVT

1270

2470

F+ F-

Figure 8 ADVR-083 & IVT-1270 / IVT-2470 Wiring Connection

Self-Excited (SHUNT) 110/220 Vac Single phase / Three phase

ATTENTION

1. Before using a Megger or a Withstand Voltage Tester remove the wires connecting to the AVR to

prevent high voltage damage to the regulator.

2. Improper setting of under-frequency protection could cause the output voltage of the unit to drop or

become unstable under with changes in load. Avoid making any changes to the U/F setting unless

necessary.

3. Turn off O/E in AVR when paralleling.

※Use only the replacement fuses specified in this user manual.

※Appearance and specifications of products are subject to change for improvement without prior notice.

Tabla de contenidos

Otros manuales de Controladores de Kutai electronics

Kutai electronics

Kutai electronics EA63-2.5 Manual de usuario

Kutai electronics

Kutai electronics EA448B Manual de usuario

Kutai electronics

Kutai electronics ADVR-073 Manual de usuario

Kutai electronics

Kutai electronics EA200A Manual de usuario

Kutai electronics

Kutai electronics EG3002F Manual de usuario

Kutai electronics

Kutai electronics EA05A Manual de usuario

Kutai electronics

Kutai electronics EA350 Manual de usuario

Kutai electronics

Kutai electronics EA45A220 Series Manual de usuario

Kutai electronics

Kutai electronics EA04C Manual de usuario

Kutai electronics

Kutai electronics ADVR-16 Manual de usuario

Kutai electronics

Kutai electronics ADVR-2300M Manual de usuario

Kutai electronics

Kutai electronics ADVR-12 Manual de usuario

Kutai electronics

Kutai electronics EA42-7 Manual de usuario

Kutai electronics

Kutai electronics EG3002 Manual de usuario

Kutai electronics

Kutai electronics ADVR-073 Manual de usuario

Kutai electronics

Kutai electronics EB-9V Manual de usuario

Kutai electronics

Kutai electronics EA125-8 Manual de usuario

Kutai electronics

Kutai electronics ADVR-083-400HZ Manual de usuario

Kutai electronics

Kutai electronics EA440 Manual de usuario

Kutai electronics

Kutai electronics EA321 Manual de usuario

Kutai electronics

Kutai electronics ADVR-054 Manual de usuario

Kutai electronics

Kutai electronics ATS-34 Ver1.0 Manual de usuario

Kutai electronics

Kutai electronics ADVR-16-400HZ Manual de usuario

Kutai electronics

Kutai electronics ADVR-2200M Manual de usuario

Manuales populares de Controladores de otras marcas

Digiplex

Digiplex DGP-848 Instrucciones de funcionamiento

YASKAWA

YASKAWA SGM series Manual de usuario

Sinope

Sinope Calypso RM3500ZB Manual de usuario

Isimet

Isimet DLA Series Style 2 Manual de instalación

LSIS

LSIS sv-ip5a Manual de usuario

Rockwell Automation

Rockwell Automation 1769-L31 Manual de usuario

Airflow

Airflow Uno hab Manual de usuario

ABB

ABB ACS580-01 drives Manual de usuario

Panasonic

Panasonic GM1 Series Manual de usuario

Emerson

Emerson SW93 Manual de usuario

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manual de usuario

Panasonic

Panasonic FP? Positioning Unit RTEX Manual de usuario

Samson

Samson Type 5824 Manual de servicio

Alpha IP

Alpha IP MIOB 21001 Manual de usuario

Siemens

Siemens OpenAir GMA 1 Series Manual de usuario

Surecom

Surecom SR-629 Manual de usuario

Fishman

Fishman TriplePlay Manual de usuario

Regulus

Regulus SRS1 T Manual de usuario