Kozy heat KOMFORT ZONE KIT Manual de usuario

HUSSONG MANUFACTURING CO., INC.

READ ALL THESE STEPS

BEFORE STARTING INSTALLATION.

LEAVE THESE INSTRUCTIONS WITH THE

APPLIANCE.

This kit must be installed by a qualied installer,

service agency, or gas supplier at the time of

the heater installation. These instructions must

be used in conjunction with the installation and

operation manual provided with the appliance.

Please read the appliance owner’s manual

completely before performing any procedures in

these instructions.

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

KOMFORT ZONE KIT

#KZK-1510A

For use with the #BHM-44 and #CLW-50 (Starting

Serial Number: 19 501780 50)

This optional convection duct kit redistributes the

warm air ow away from the replace opening to

a more desirable location using natural convection

without the use of a fan. The warm air ow may be

relocated to a position higher up the wall, out the

sidewalls, or even to an adjacent room. The result

is much cooler wall temperatures above the re-

place opening for locating televisions, artwork, etc.

English and French installation manuals are available through your

local dealer. Visit our website www.kozyheat.com.

Les manuels d’installation en français et en anglais sont disponibles

chez votre détaillant local. Visitez

www.kozyheat.com

Hussong Manufacturing Co., Inc.

P.O. Box 577, 204 Industrial Park Drive

Lakeeld, MN 56150-0577, USA Rev. 4, 8/20

1.0 INTRODUCTION.......................................................................3

1.1 Kit Contents..........................................................................................3

1.4 Fireplace Preparation........................................................................ 3

1.2 Suggested Congurations.............................................................. 4

1.3 Dimensions and Overview .............................................................6

1.5 Air Duct Pipe Run............................................................................... 8

2.0 FRAMING AND CLEARANCES................................................9

2.1 Clearance to Sprinkler......................................................................9

2.2 Framing................................................................................................10

2.3 Shelf Requirements.........................................................................12

3.0 FACING AND FINISHING.......................................................14

3.1 Non-combustible Requirements................................................14

3.2 Combustible Finish..........................................................................16

3.3 Hearth and Mantel Clearances....................................................19

4.0 INSTALLATION .......................................................................21

Komfort Zone Kit #KZK-1510A R.4 Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces INTRODUCTION 3

1.1 Kit Contents

ALL kit contents must be installed.

• (2) 15" plenum kit: #KZK-1510A

• (2) air grilles

• (8) 6" collars - (4) to attach to the bottom of the plenum; (4) to

attach to the unit where the cover plates are removed.

(1) KZK-410-6 is used for a 10' vent run. If you are mounting the

plenum above the replace 10' (3m) or less, use (1) #KZK-410-6 kit.

KZK-CPL6 is (6) 6" couplers that connect (2) KZK-410-6. You will only

need (4) 6" couplers for installation. If you are mounting the plenum

above the replace between 10' to 20', you will need (2) KZK-410-6 kit

and (1) #KZK-CPL6 coupler kit.

1.0 INTRODUCTION

15¾”

(400mm)

11¾”

(298mm)

(4) take o collars included

#KZK-1510A

Figure 1.1, #KZK-1510A

Figure 1.2, #KZK-410-6

(4) - 10’x 6” (aluminum ex) listed to UL-181Class 0 Air Duct

#KZK-410-6

Figure 1.3, Stand-o Assembly Installation

Discard header heat shield

Stand-o

assembly

1.2 Fireplace Preparation

1.2.1 BHM-44 Requirements

For ease of installation, the header heat shield may be removed.

The stand-o assembly still must be installed. To install stand-o

assembly,

1. Locate the stand-o assembly and header heat shield on top of

the replace, as shipped.

2. Discard header heat shield.

3. Attach the stand-o assembly pieces as shown below and secure

with (4) screws.

4 INTRODUCTION Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-1510A R.4

1.3 Suggested Congurations

When installing the #KZK-1510A, take in consideration the replace

venting and the plenum tube conguration.

The (2) plenums and the (2) air grilles in this kit are required and both

must be installed.

Figure 1.4, #KZK-1510A Suggested Congurations for CLW-50

#KZK-1510A side wall outlet

#KZK-1510A rear wall outlet

CLW-50

Komfort Zone Kit #KZK-1510A R.4 Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces INTRODUCTION 5

Figure 1.5, #KZK-1510A Suggested Congurations for BHM-44

#KZK-1510A side wall outlet

#KZK-1510A rear wall outlet

BHM-44

For side wall outlet installations, it is easier to keep the 1/2”(12mm) clearance if

the center tubes are assembled to the backside of the KZK

6 INTRODUCTION Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-1510A R.4

1.4 Dimensions and Overview

Figure 1.6, #KZK-1510A Dimensions

7⁄”

(198mm)

13½”

(342mm) 3”

(76mm)

12”

(304mm)

5⁄”

(149mm) 8⁄”

(220mm)

4”

(102mm)

6”

(152mm)

1½”

(38mm)

(19mm)

stando

#KZK-1510A

Komfort Zone Kit #KZK-1510A R.4 Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces INTRODUCTION 7

1.5 Air Duct Pipe Run

IMPORTANT: The air duct pipe cannot run horizontally without a

vertical rise.

IMPORTANT: The 1/2" clearance around the air duct pipes must be

maintained.

Use #KZK-410-6 UL181 Class 0 Air Duct piping to connect the plenum(s)

to the unit.

Hussong Mfg. requires pipes to be listed as UL181 Class 0 Air Duct to

connect the plenum(s) to the unit.

• Maximum vent run: 20' (6m)

Figure 1.7, Minimum Vent Pipe Run - only (1) plenum shown

WHEN INSTALLING AIR DUCT PIPE MAINTAIN A MINIMUM 4" VERTICAL RISE FOR EVERY 12" HORIZONTAL RUN

12”

(304mm)

4” (102mm)

Minimum bend radius=5” (127mm)

12”

(304mm)

4” (102mm)

Minimum bend radius=6” (152mm)

CLW-50 BHM-44

8 FRAMING AND CLEARANCES Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-1510A R.4

2.0 FRAMING AND CLEARANCES

Figure 2.1, KZK Clearance to Sprinkler

2.1 Clearance to Sprinkler

• In a situation where a sprinkler head is installed within the

proximity to a #KZK discharge opening, the diagram below

MUST be followed.

• The distance between a sprinkler head and discharge opening

cannot be less than 60" (1524mm) in length at every point from

the origin of the discharge opening. You must also verify the

sprinkler head sensor is set to the proper heat setting so it does

not activate when the room heats up from the replace being

operated normally.

• Please follow local building codes to determine what

temperature setting is relevant for your installation.

60”

(1524mm) MIN

3½”

(89mm) MIN

3”

(76mm) MIN

60”

(1524mm) MIN

Ceiling

sprinkler head

Ceiling

sprinkler head

CLW-50

BHM-44

Komfort Zone Kit #KZK-1510A R.4 Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces FRAMING AND CLEARANCES 9

2.2 Framing

Shown in this section are rough opening dimensions and clearances

for the plenums, unit installation, and unit installation with a TV

recess construction.

Rough opening framing dimensions should allow for wall covering

thickness and facing materials.

Figure 2.2, Minimum Clearances for Plenum Air Discharge to Ceiling

3½”

(89mm)

1½”

(38mm)

½”

(12mm)

½”

(12mm)

½”

(12mm)

½”

(12mm)

3”

(76mm)

1½”

(38mm)

Ceiling

CLW-50 BHM-44

10 FRAMING AND CLEARANCES Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-1510A R.4

8¼”

(209mm)

18”

(457mm)

74½”

(1892mm)

66¼”

(1683mm)

76”

(1930mm)

22”

(558mm)

STEEL

FRAMING

Plenum rough opening

Height and Width Unit and plenum

side view

CLW-50

Dimensions reect minimum replace enclosure height

Figure 2.3, Rough Opening and Framing

Figure 2.4,CLW-50 Unit Wall Enclosure Rough Opening

76”

(1930mm)

48”

(1219mm) 64½”

(1638mm)

22”

(559mm)

44½”

(1130mm)

4¼”

(108mm)

76”

(1930mm)

64½”

(1638mm)

22”

(559mm)

44½”

(1130mm)

4¼”

(108mm)

Steel Framing Required

CLW-50

Otros manuales para KOMFORT ZONE KIT

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Accesorios para chimeneas de kozy heat

kozy heat

kozy heat NK41-500 Manual de usuario

kozy heat

kozy heat OCK-S50A Manual de usuario

kozy heat

kozy heat KZK-036 Manual de usuario

kozy heat

kozy heat LCK-NK34-S Manual de usuario

kozy heat

kozy heat OCK-S35A Manual de usuario

kozy heat

kozy heat CALLAWAY 50 Manual de usuario

kozy heat

kozy heat KZK-038 Manual de usuario

kozy heat

kozy heat LCK-SF36-D Manual de usuario

kozy heat

kozy heat NCK-SL42-D Manual de usuario

kozy heat

kozy heat NCK-OP18L-S30 Manual de usuario

kozy heat

kozy heat KOMFORT ZONE KIT KZK-050 Manual de usuario

kozy heat

kozy heat NCK-SP41L-D Manual de usuario

kozy heat

kozy heat LCK-NK41-S Manual de usuario

kozy heat

kozy heat KZK-1510 Manual de usuario

kozy heat

kozy heat KZK-1510A Manual de usuario

kozy heat

kozy heat CHASKA 34 GLA Manual de usuario

kozy heat

kozy heat LCK-SP34L-D Manual de usuario

kozy heat

kozy heat NCK-NK36-S Manual de usuario

kozy heat

kozy heat CW50-501 Manual de usuario

kozy heat

kozy heat NCK-SF36-D Manual de usuario

kozy heat

kozy heat KOMFORT 8K Instrucciones de montaje

kozy heat

kozy heat KZK-1510A Manual de usuario

kozy heat

kozy heat KZK-038 Manual de usuario

kozy heat

kozy heat LCK-SP41L-D Manual de usuario

Manuales populares de Accesorios para chimeneas de otras marcas

Valor

Valor L2 1700K Manual de usuario

Exodraft

Exodraft Xzense Manual de usuario

Whalen

Whalen Ruso MNFP62BF23-6 Manual de usuario

Lopi

Lopi Hearthview 864 Manual de usuario

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Manual de usuario

EdilKamin

EdilKamin SERBATOIO 250 Guía de inicio rápido

Bronpi

Bronpi KIT-1 Manual de usuario

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Manual de usuario

Travis Industries

Travis Industries 33 DVI Manual de usuario

Superior

Superior ASD3628-TI Manual de usuario

pleasant hearth

pleasant hearth OFP28WG Manual de usuario

IHP

IHP Astria Series Manual de usuario

Firegear

Firegear FG-H-2110SS Manual de usuario

Nibe

Nibe Contura C i31 Manual de usuario

SimpliFire

SimpliFire SF-WM36 Manual de usuario

Bluegrass Living

Bluegrass Living BC18NR Guía de inicio rápido

pleasant hearth

pleasant hearth IRIS SCROLL Manual de usuario

Cooke

Cooke Glass Wind Guard Manual de usuario

kozy heat KOMFORT ZONE KIT Manual de usuario

Manuales populares de Accesorios para chimeneas de otras marcas