Kogan MX10 PRO Manual de usuario
MX10 PRO CORDLESS 22.2V MOP AND
STICK VACUUM CLEANER
KAVACSTM10X
When using an electrical appliance basic safety precautions should always be followed
including the following:
Kogan.com is not liable for damage caused by failure to comply with the use requirements,
negligent use, etc.
• Children aged 8 years and above or persons with reduced physical, sensory or
mental capabilities should only use this appliance while under supervision or
instruction from an adult or carer.
• Children aged 8 and above should not clean or perform user maintenance on this
appliance unless under supervision or instruction from an adult or carer.
• Do not operate any appliance with a damaged or abnormal cord or plug. If the
main cord is damaged, it must be replaced by Kogan.com or a service agent on
Kogan.com's behalf.
• Recharge the battery using only with the charger supplied with the appliance.
• This appliance is intended for domestic use only.
• Do not use on wet or greasy surfaces.
• Before use, remove any objects that could entangle the brushes (long hair, plastic
bags, rope, wire, etc.).
• Never immerse any part of the plug or vacuum cleaner in water or other liquids.
• Never leave the vacuum unattended while the power is one.
• Please be careful when your pet is near the vacuum cleaner.
• Do not hang the power cord over the edge of the desk or counter, or touch any
sources of heat.
• It is not recommended to use any accessories other than those supplied.
• In the event of a malfunction, stop using it immediately and contact Kogan.com.
SAFETY & WARNINGS
1
Speed control button
6
Metal tube release button
2
Power indicator
7
Metal tube
3
Battery
8
Brush release button
4
Dust tank release button
9
Charging port
5
Display
10
Dust tank
OVERVIEW
Display
Battery Level
Brush Blockage Indicator
Air-duct Blockage Indicator
Failure Indicator
Eco Speed
High Speed
Speed Control
1. Insert the metal tube into the nozzle and make sure it is secure (Figure 1).
2. Press the metal tube release button and remove the metal tube (Figure 2).
Use the different accessories according to your cleaning requirements.
1. Insert the metal aluminium tube first, then install the floor brush. Ensure the brush
is secure (Figure 1).
2. The floor brush can be removed by pressing the metal tube lock (Figure 2).
OPERATION
Figure 1
Figure 2
Figure 1
Figure 2
1. Press the power button (Figure 1), the vacuum turns on in eco speed mode.
2. Press the speed control button (Figure 2) to cycle through the different speeds.
Note: When using, do not exceed the “maximum” dust collection capacity of the
dust cup.
Charging
1. Tu r n o f f t h e v a c u u m a n d i n s e r t t h e c h a r g e r i n t o t h e c h a r g i n g p o r t .
2. Plug the charger into the power outlet.
3. When charging, the blue light will flash; when the charging is finished, the light will
remain on.
4. Unplug the charger, press the power switch, and the vacuum cleaner will power on.
Figure 1
Figure 2
Note:
Please keep the air intake open during use to avoid clogging. Failure to do so, will
cause the motor to overheat causing danger.
WARNING: Only use the original charger to avoid damage to the vacuum
cleaner.
CHARGING
1. In addition to the main unit, other parts can be washed with warm soapy water.
After cleaning, it must be thoroughly dried before being returned for use. Never
immerse the main unit in water or any liquid.
2. Clean the outer casing of the vacuum cleaner only with a soft, slightly damp cloth.
Never let any liquids enter the vacuum cleaner.
3. Never use any corrosive chemicals or abrasives.
4. When the filter is damaged or worn out, it should be replaced.
5. This product contains non-removable parts and must not be disassembled or
repaired by yourself.
For the best use, empty the dust bucket and clean the filter after each use.
1. Press the dust tank release button to remove the dust tank.
2. Press and hold the dust tank bottom cover button below to empty the dust.
CLEANING & CARE
3. Separate the upper part of the dust tank from the dust tank body. Remove the
filters and wash it in warm water. Ensure the filters are completely dry before
reassembling.
4. Return the filters and reassemble the dust tank. The mark on the upper part of the
dust tank corresponds to the “unlock” position, ensure that the “3 small and 1 large”
feet are properly inserted into the dust tank and are screwed back to the "Lock"
position.
5. Put the dust tank back on the vacuum main body.
It is recommended to replace the filter every three months (depending on the use) to ensure
the best performance
Voltage supply
22.2V (Li-ion 2000mAh)
Power
250W
Battery
Charging time: Approx. 4 Hours
Operating time: Max 30-35mins (when the battery is full charged)
Power adapter
Input
100-240V~, 50/60Hz 0,5A MAX
Output
DC 26.5V, 0.5A
Protection Class
II
Disposal
This marking indicates that this appliance should not be disposed with other
house-hold wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.
SPECIFICATIONS
Otros manuales para MX10 PRO
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Aspiradora de Kogan
Kogan
Kogan T10 Pro Manual de usuario
Kogan
Kogan KAHHCOVAWCA Manual de usuario
Kogan
Kogan KA22CYTBVCA Manual de usuario
Kogan
Kogan MX9 Manual de usuario
Kogan
Kogan KA14CYCVACA Manual de usuario
Kogan
Kogan Z10 PRO Manual de usuario
Kogan
Kogan V10 Manual de usuario
Kogan
Kogan KA22BLDSVCA Manual de usuario
Kogan
Kogan SMARTERHOME LS16 Manual de usuario
Kogan
Kogan SmarterHome G50 Manual de usuario
Kogan
Kogan SMARTERHOME LX8 Manual de usuario
Kogan
Kogan M8 PRO CORDLESS 22.2V STICK VACUUM CLEANER AND... Manual de usuario
Kogan
Kogan KAVAC21RECA Manual de usuario
Kogan
Kogan SmarterHome LX10 Manual de usuario
Kogan
Kogan X6 Manual de usuario
Kogan
Kogan MX12 Manual de usuario
Kogan
Kogan SMARTERHOME LX12 Manual de usuario
Kogan
Kogan KAVACST296B Manual de usuario
Kogan
Kogan KAVAC20TRBA Manual de usuario
Kogan
Kogan C7 Series Manual de usuario
