Kelty MANTRA 6 Manual de usuario

YOUR KELTY TENT SHOULD INCLUDE:

1 TENT BODY

1 TENT FLY

2 LONG PRECURVED

DAC DA17 POLES 1 SMALL STAKE SACK CONT

AINING:

• 19 ALUMINUM TENT STAKES

• 4 GUYLINES WITH ADJUSTERS

• 1 SET OF INSTRUCTIONS

WARNINGS

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC.

• This tent is made with flame resistant fabric which meets CPAI-84

specifications. IT IS NOT FIREPROOF.The

fabric will burn if left

in continuous contact with any flame source. The application of any

foreign substance to the tent fabric may render the flame-resistant

properties ineffective.

ADDITIONAL WARNINGS

•

This tent must be properly ventilated in all weather conditions. In extr

eme

weather conditions, snow could obstruct airflow and cause asphyxiation

unless cleared frequently.

• Never use fuel-burning, oxygen consuming devices (i.e. heaters, lanterns,

cooking stoves or other flame sources) inside your tent.

• Never leave children unattended inside a tent.

• Anchor your tent securely to provide additional security from changing

climatic conditions. Snow pegs, skis and/or heavy rocks may be

necessary to supplement tent stakes and guy cords

1 SHORT PRECURVED DAC DA17

POLE

1 SILVER FLY POLE

Before you Start 2

Pitching your Tent 3-7

Designer’s Notes 7

Notes and Warranty 8

INSTRUCTION INDEX

DA17 SERIES

MANTRA 6 & 7

Floor saving

Foot print available

5. Using one of the GOLD poles, follow the seam

directly under the pole to a corner (figure 4A).

Figure 5A Figure 5CFigure 5B

7. Repeat steps 5 and 6 on opposite side of the tent.

The gold poles should cross over each other twice. The tent will

start taking shape at this point.

8. Using the BLACK pole, follow the seam directly

under the pole to the center of either the front or

back of the tent (figure 6).

Figure 4A

6. Insert the spring pins on the black webbing

located by the floor seams at each corner of the

tent into the end of the pole (figures 5A, 5B and

5C). Repeat for the other gold pole on the SAME side.

Figure 6

SETTING UP YOUR TENT

2. Spread the tent body on the ground.

3. Slide a long GOLD pole through a long pole sleeve

that parallels the long side of the tent (figures 2A

and 2B). Repeat for the other long pole and other long pole

sleeve.

Figure 1A Figure 1B Figure 1C

1. Assemble the poles (figures 1A, 1B and 1C).

Avoid having the shockcord snap the pole sections together,

this can damage the poles.

Figure 2A Figure 2B

4. Slide short BLACK pole through the short pole sleeve

that crosses over the center of the tent (figure 3A).

Make sure the black pole lays over the two gold poles.

Figure 3A

ATTACHING THE FLY

12. Find the zippers in the fly. This will be the vestibule

over the entrances at the front of the tent. Drape

the fly over the tent body with the zippers over the

doors (figure 9).

Figure 9

13. Slide the silver pole through the sleeve on the

underside of the fly just above the door/vestibule

area (figure 10A).

14. Insert spring pins at the front corners of the tent

into the ends of the silver poles (figure 10B).

Figure 10B

Figure 10A

11. Stake the tent down (figures 8A and 8B)!

Figure 8A Figure 8B

Figure 7A Figure 7B

• IF YOU’RE HAVING A HARD TIME

STAKING INTO THE GROUND, USE

ROCKS TO ANCHOR DOWN YOUR

TENT. (SEE ILLUSTRATION)

• TO GET THE TAUTEST PITCH, START AT

ANY CORNER, THEN MOVE TO THE

DIAGONAL CORNER FOR EACH STAKE.

STAKING TIPS

9. Insert the spring pins on the black webbing located

by the floor seams at the center of the tent into the

end of the BLACK pole. Repeat for the other side of the

black pole.

10. Attach clips located at the seams of the tent to the

corresponding poles above each (figures 7A and

7B). NOTE: Clips are color coded for each pole.

NOTES & TIPS

6235 LOOKOUT ROAD, BOULDER CO 80301

800.423.2320 • FAX 800.504.2745 • WWW.KELTY.COM

WARRANTY

•Fire near your tent is a NO-NO. Your tent can burn. Never

cook in your tent or use candles for light inside.

• To minimize UV damage from the sun, don’t keep tent set up for

long periods of time or when not in use.

• The fly is equipped with closable vents. Opening these vents

increases flow-through ventilation.

• If you pitch the tent in a wind, anchor the tent before you put the

poles in. Gear alone probably won’t hold down your tent even in

winds as light as 25mph. Many tents have been destroyed by

unexpected winds rolling them away with gear inside! In strong

winds you will want to anchor every stake loop and guyout.

• The best way to use rocks for staking and guying out in rocky ter-

rain is to find one large and one small rock. Tie a piece of cord

from your stake or guy-out point around the small rock, set the

large rock on top of the cord right next to the small rock, pull

back until it’s tight. (See p. 4)

• Leaving the fly on the tent when you take it down is sometimes

handy. Packing the tent and fly as a single connected unit speeds

setup and the tent will be immediately protected from rain when

you pull it out next time.

Before packing you should dry out the tent and fly. This way you

won’t have to carry water rolled into the tent and it will help

keep the tent from mildewing.

Kelty takes pride in its workmanship and undertakes to manufacture the best possible

products. Therefore, we warranty all Kelty products against defects in materials or work-

manship during your lifetime. Since no Kelty product is indestructible, it does not cover

defects attributable to or resulting from normal wear and tear, natural hazard damage

(ie: weather, animals), abuse or alteration (ie: ultra violet (u.v.) damage on tents, exhaust-

ed zippers). Service under our warranty is available to the original purchaser by returning

the product to any authorized Kelty dealer or by contacting our customer service depart-

ment at 1-866-349-7225 (1-866-FIX-PACK) for return authorization. We require that all

products returned for warranty and repair be properly cleaned.

If after inspection we

determine that the product was defective, we will repair or replace it free of

charge. If your Kelty product needs service or repair that is not covered under

warranty we will provide the necessary service at a reasonable charge. This

warranty gives you, the original purchaser, specific legal rights. You may also

have other rights, which vary from state to state.

13. Clip the buckles on the fly to the buckles at each

corner of the tent body (figures 11A and 11B).

14. Stake out the vestibule at the front of the tent so

that it is taut.

15. Cinch the webbing on the fly buckles at each

corner of the tent.

Figure 11A Figure 11B

DESIGNER’S NOTES

STAKE YOUR TENT DOWN! REALLY!

Este manual sirve para los siguientes modelos

Otros manuales de Carpa de Kelty

Kelty

Kelty Gunnison Manual de usuario

Manuales populares de Carpa de otras marcas

OZTENT

OZTENT JV SIGNATURE EDITION Manual de usuario

GigaTent

GigaTent Summer Chalet Mini Tent Manual de usuario

Coleman

Coleman 2000007827 Manual

ShelterLogic

ShelterLogic 107153 Manual de usuario

Outsunny

Outsunny 84C-230 Manual de usuario

Napier

Napier SPORTZ COVE 61 Series Manual de usuario

EuroTrail

EuroTrail ATLANTIS PRO Manual de usuario

Reimo

Reimo Marina Manual de usuario

TiiTENT

TiiTENT TB300 Manual de usuario

Coleman

Coleman 2000033134 Guía de instalación

Ozark Trail

Ozark Trail W784.1 Guía de inicio rápido

SlingFin

SlingFin CrossBow 2 Manual de usuario

Coleman

Coleman 9600-141 Manual de usuario

Palram

Palram Arizona 5000 Wave - WINGS Manual de usuario

COVERPRO

COVERPRO 56184 Instrucciones de montaje

Vango

Vango Zenith 100 Manual de usuario

Costway

Costway PATIOJOY OP70818 Manual de usuario

Clarke

Clarke PUC 88 Manual de usuario