Jacuzzi 67416-3D04Y Manual de usuario

Questions, problems, missing parts? Before

returning to your retailer, call our customer service

department at 1-800-288-4002, 6 a.m. - 5 p.m.,PT

and 9 a.m. - 8 p.m.,ET, Monday - Friday.

TWO HANDLE ROMAN TUB FAUCET

Jacuzzi Item # MX 22826 / MX 22827 /MX 22817 / MX22845

MODEL # 67416-3D04Y / 67416-3D01Y / 67416-7001Y

ATTACH YOUR RECEIPT HERE

Serial Number___________________

Purchase Date___________________

2022/06/01 V2

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

WARNING:

•Follow the installation instructions carefully. Proper installation is the installer’s responsibility.

•Failure to follow correct installation procedures can result in the faucet being loose, which can result in serious injury.

CAUTION:

•Check local building codes before beginning installation to ensure compliance.

PREPARATION

Before beginning the assembly of this product, make sure all parts are present. Compare parts with the package

contents and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 90 minutes (including removal of old faucet)

Tools Required for Assembly (not included): Adjustable Wrench, (2) Supply lines

/ 67416-2708Y

QD86000

ASSEMBLY INSTRUCTIONS

From underneath the deck, insert the middle body

with the rubber washer (1), metal washer (2) and

mounting nut (3) through hole. From above, thread

the connector (4) onto middle body. Tighten the

mounting nut (3), so that the connector (4) sits flush

to the surface of working area. Note: The middle body

must turn to the direction as shown in the diagram.

Drill holes in FINISHED DECK per diagram.

NOTE: This kit is intended for installation up to

1-1/4 in. thick.

Place the spout assembly (1) onto the connector (2).

Be sure the spout assembly (1) is resting firmly on

the deck. Push down on spout assembly (1) and

tighten set screw (3) with Allen wrench

(Hex: 3.2mm, 4). Insert the cap (5).

Unscrew the set screws (1) from the handle

assemblies (2)with Allen wrench(Hex:2.5mm,6) and

remove the handle assemblies (2) from the valve

bodies. Loosen the flanges (3) from the valve bodies.

Adjust the washers (4) and mounting nuts (5) to the

bottom of valve bodies.

From underneath the deck, insert the valve body with

the rubber washer (1), metal washer (2) and mounting

nut (3) through hole on the right (cold) side. From

above, thread the flange (4) onto valve body. Tighten

the mounting nut (3), so that the flange (4) sits flush

to the surface of working area. Then insert the other

valve body through holes on the left (hot) side and

install in the same way. Note: Hot side end valve is

labeled.

5 in. min.

8~16 in.

3 in. min.

1-1/4 in. MAX. DECK THICKNESS

1-1/8 in. dia.

1-3/8 in. dia.

Remove connector (1) from the middle body. Adjust

the washers (2) and mounting nut (3) to the bottom

of middle body.

12,7 cm min.

7,62 cm

min.

Diam. de 3,49 cm

~ de 20,32 à 40,64 cm

Diam. de 2,85 cm

1-3/8 in. dia.

Diam. de 3,49 cm

ÉPAISSEUR MAXIMALE DU COMPTOIR DE 3,17 CM

345

QD86000

ASSEMBLY INSTRUCTIONS

Place the handle assembly (1) onto the right (cold)

valve (2). Then thread the handle seat (3) onto the

flange (4). Place the set screw (5) into handle

assembly (1) and tighten set screw (5) with Allen

wrench (Hex: 2.5mm, 6), Place the other handle

assembly onto the left (hot) valve and install the

same way.

Turn on hot and cold water supplies and flush water

lines for one minute. After flushing,turn the handles

all the way off to shut off the water.

Connect a 1/2 in. IPS faucet connector (not included)

to the water supplies underneath the sink using

wrenches (not included).

NOTE: Refer to the local plumbing codes for

permissible types of water supply connectors.

Connect the flexible water supply hose (1) to the

bottom of valve bodies (2) as show. Align middle

body (3) in a position which will allow maximum

clearance to connect hoses. Carefully bend the

hoses to fit available space. Carefully thread the hose

couplings to the sides of the middle body (3). Tighten

nut (4) securely with wrench.

QD86000

ASSEMBLY INSTRUCTIONS

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

There is a leak from under the handle

or there is a leak from the spout when

the faucet is off.

There is a leak from the spout base

when the faucet is on.

1. The bonnet nut is not tight enough.

2. The cartridge is damaged.

The o-ring which is on the connector

under the spout is worn.

1. Remove the handle and retighten

the bonnet nut.

2. If the problem occurs after

retightening the bonnet nut, call

customer service for a new cartridge

and replace it after you receive the

new cartridge.

Call customer service for a new o-ring

and replace it after you receive the

new o-ring.

The manufacturer warrants this faucet to be free from defects in workmanship and material present at time of shipment

from the factory for a limited lifetime from the date of purchase. This warranty applies only to the original purchaser. The

manufacturer agrees to correct such defects at no charge or, at our option, replace the faucet with a comparable or

superior model. To obtain warranty service, call our customer service department at 1-800-288-4002 for return

authorization and shipping instructions. You may be required to present a copy of your sales receipt as proof of purchase.

All cost of removal and reinstallation are the expressed responsibility of the purchaser. Any damage to the faucet by ac-

, are the purchaser’s

responsibility. The manufacturer assumes no responsibility whatsoever for faucet installation during the warranty period.

There is no further expressed warranty. The manufacturer disclaims any and all implied warranties. The manufacturer shall

not be liable for incidental, consequential or special damages arising at or in connection with product use or performance

rights which vary from state to state. This warranty supersedes all prior warranties.

WARRANTY

CARE AND MAINTENANCE

•

and void your warranty.

QD86000

For replacement parts, call our customer service department at

1-800-288-4002, 6 a.m. - 5 p.m., PT and 9 a.m. - 8 p.m.,ET, Monday - Friday

REPLACEMENT PARTS LIST

PART DESCRIPTION PART#

Printed in China

Handle assembly RQ84817/RQ84826/RQ84827/RQ84845

Cartridge H RQ86000

Cartridge C RQ87000

QD86000

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Producto de plomería de Jacuzzi

Jacuzzi

Jacuzzi sasha mi Manual de lista de piezas

Jacuzzi

Jacuzzi SANCTUARY 1 Manual de usuario

Jacuzzi

Jacuzzi 3636S Manual de usuario

Jacuzzi

Jacuzzi FP4A0068CP Manual de usuario

Jacuzzi

Jacuzzi Lenire Manual de usuario

Jacuzzi

Jacuzzi Verona Manual de usuario

Jacuzzi

Jacuzzi 73-BRT2-J Manual de usuario

Jacuzzi

Jacuzzi ERA Manual de usuario

Jacuzzi

Jacuzzi Steam Generator SteamPro 120 Manual de usuario

Jacuzzi

Jacuzzi JS-1i Manual de usuario

Jacuzzi

Jacuzzi Personal Hygiene System EV77959 Manual de usuario

Jacuzzi

Jacuzzi J-DREAM 90 Manual de usuario

Jacuzzi

Jacuzzi MAYA ML-20502 Manual de usuario

Jacuzzi

Jacuzzi sasha mi Manual de usuario

Jacuzzi

Jacuzzi sasha Manual de usuario

Jacuzzi

Jacuzzi 67662-X5104 Manual de usuario

Jacuzzi

Jacuzzi Ristorre Metallo EC33 Manual de usuario

Jacuzzi

Jacuzzi 67693W-6004 Manual de usuario

Jacuzzi

Jacuzzi Shower Base Bonaire 4848 Manual de usuario

Jacuzzi

Jacuzzi LLUSION 6636 Manual de usuario

Jacuzzi

Jacuzzi Ristorre Ovale EC31 Manual de usuario

Jacuzzi

Jacuzzi OPTICA 300 Manual de usuario

Jacuzzi

Jacuzzi XYZ+ 100x70 Manual de usuario

Jacuzzi

Jacuzzi BM43000 Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario