Interlogix RF-7220-07-1 Instrucciones de montaje

RF-7220-07-1 Wireless Outdoor Siren

Installation Sheet

78910123456

2 / 3 P/N 466-2912 • REV A • ISS 05JAN17

EN: Installation Sheet

Wiring diagram

Figure 2 legend

(1) Siren PCB

(2) Speaker

(3) Beacon

(4) 4X lithium battery pack (not included)

(5) IO module power cable (black)

(6) Tamper

(7) Tamper

(8) Beacon + (red)

(9) Beacon- (black)

(10) Siren driver + (red)

(11) Siren driver −(black)

(12) IO module PCB

Learning-in an outdoor siren

You have to learn-in the siren before mounting it to the desired

position. In order to add a wireless siren to the system perform

the following steps:

1. Enter the programming mode on the panel

2. Enter your username and password and then click Sign In.

3. Click Settings.

4. Click Zones.

5. The outdoor siren will occupy maximum 4 zone numbers.

Click “Select Zone to Configure” to set the first zone

number of the outdoor siren.

6. Click Learn.

7. Power up the outdoor siren with the tamper switch open.

8. Wait for module LEDs to blink on, then off.

9. Close tamper switch for 2 seconds, then reopen within 5

seconds.

10. The screen will indicate the outdoor siren has been

learnt-in and a serial number will appear. Read the pop up

messages.

11. Select Outdoor Siren as the application.

12. Click Save when done.

Mounting the siren

For mounting instructions, see Figure 3. Pay attention to the

precise placement of the tamper switch against the wall. To

comply with an EN50131-4 grade 2 installation, please take

special care of positioning the tamper switch lever to the wall,

and insert a screw in the wall opposite to the tamper switch

lever. This screw has to be adjusted in height in order to press

adequately on the tamper switch lever so that the microswitch

is in a “closed” position and resting on the screw’s head

instead of the wall (see Figure 4, position 1). The siren needs

to signal a tamper alarm when the unit is taken more than

5 mm from its mounting surface (see Figure 4).

Siren configuration

To allow the IO module to control the output on the outdoor

siren, you need to cut jumper 3 and then optionally 1 and/or 2.

Jumper 3 is a start-up protection. Jumpers 1 and 2 are

responsible for timer settings, and you can cut one of them or

both, according to the table below.

P/N 466-2912 • REV A • ISS 05JAN17 3 / 3

Timer setting

Time J1 J2

3 minutes (ex-factory)

5 minutes

10 minutes

20 minutes

Safety instructions

WARNING: Do not open the flash housing. Risk of high

voltage.

Battery replacement and removal

Caution: Batteries can explode or cause burns when

recharged, incorrectly (dis)assembled, or exposed to fire or

high temperatures.

Dispose of used battery according to battery directive

instructions and/or as required by local laws. Keep away from

children.

To remove the batteries from the outdoor siren, please pull the

black plastic strap that holds the battery pack. Only replace the

batteries with the standard lithium battery pack BS7201-N. Do

not use a different type of lithium batteries.

Note: The lithium battery pack BS7201-N is not included with

the siren, and must be purchased separately.

Specifications

Power supply specifications

Number and type of

batteries

BS7201-N, 4-cell custom battery pack,

lithium (purchased separately)

Battery capacity 12.5 Ah

Electronics, board

operating voltage

3.0 VDC

Siren/flash light part

operating voltage

12.0 VDC

Battery lifetime (typical) 3 years *

Current consumption –

IO module (typical)

140 µA at 3.0 VDC ± 10%

Current consumption –

siren (typical)

340 mA at 12.0 VDC ± 10%

Current consumption –

beacon (typical)

74 mA at 12.0 VDC ± 10%

Environmental

Operating temperature −25°C to +50°C

Humidity max 95%, non condensing

Shipping weight 2.3 kg

Enclosure dimensions 310 x 222 x 91 mm

EN 50131 grade and

class

Security Grade 2, Environmental

Class III

* Assumption: maximum 20 siren activations of 3 minutes and

beacon activations of 15 minutes per year.

Regulatory information

Manufacturer UTC Fire & Security Americas Corporation, Inc.

1275 Red Fox Rd., Arden Hills, MN 55112-6943,

USA

Authorized EU manufacturing representative:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert, Netherlands

EU compliance

Certification EN 50131-5-3:2005

EN 50131-5-3/A1:2008

EN 50131-4:2009

Tested and certified by Telefication B.V.

2012/19/EU (WEEE directive): Products marked with

this symbol cannot be disposed of as unsorted

municipal waste in the European Union. For proper

recycling, return this product to your local supplier

upon the purchase of equivalent new equipment, or

dispose of it at designated collection points. For

more information see: www.recyclethis.info.

2006/66/EC (battery directive): This product contains

a battery that cannot be disposed of as unsorted

municipal waste in the European Union. See the

product documentation for specific battery

information. The battery is marked with this symbol,

which may include lettering to indicate cadmium

(Cd), lead (Pb), or mercury (Hg). For proper

recycling, return the battery to your supplier or to a

designated collection point. For more information

see: www.recyclethis.info.

UTC Fire & Security hereby declares that this device

is in compliance with the applicable requirements

and provisions of one or more of the Directives

1999/5/EC, 2014/30/EU and 2014/35/EU. For more

information see: www.utcfireandsecurity.com.

Contact information

www.utcfireandsecurity.com or www.interlogix.com

Customer support

For customer support, see www.utcfssecurityproducts.eu

Otros manuales de Sistema de seguridad de Interlogix

Interlogix

Interlogix ATS125 Instrucciones de funcionamiento

Interlogix

Interlogix NX-595E Manual de usuario

Interlogix

Interlogix AS272 Instrucciones de montaje

Interlogix

Interlogix ACL805SUW-BS Manual de usuario

Interlogix

Interlogix ZeroWire Manual de usuario

Interlogix

Interlogix DC108 Series Instrucciones de montaje

Interlogix

Interlogix Simon XTi-5 Version 2 Manual de usuario

Interlogix

Interlogix ITI Simon Manual de usuario

Interlogix

Interlogix ATS111xA-N Series Instrucciones de montaje

Interlogix

Interlogix Simon 3 Manual de usuario

Interlogix

Interlogix Learn Mode Water Resistant Pendant Panic... Manual de usuario

Interlogix

Interlogix ZeroWire Manual de usuario

Interlogix

Interlogix ATS1235 Instrucciones de montaje

Interlogix

Interlogix ZeroWire Manual de instrucciones

Interlogix

Interlogix ATS111 A Series Instrucciones de montaje

Interlogix

Interlogix Simon XT Manual de usuario

Interlogix

Interlogix Simon XTi-5 Version 2 Manual de usuario

Interlogix

Interlogix Caddx Manual de usuario

Interlogix

Interlogix ATS125 Instrucciones de montaje

Interlogix

Interlogix ZeroWire Manual de usuario

Interlogix

Interlogix RF-7120-07-1 Instrucciones de montaje

Interlogix

Interlogix ZEROWIRE ZW-6404 Manual de usuario

Interlogix

Interlogix advisorone Manual de usuario

Interlogix

Interlogix Simon XT Manual de usuario

Manuales populares de Sistema de seguridad de otras marcas

Inner Range

Inner Range Concept 2000 Manual de usuario

Climax

Climax Mobile Lite R32 Instrucciones de montaje

CADDX

CADDX NX-6 Manual de usuario

FBII

FBII XL-31 Series Manual de usuario

Johnson Controls

Johnson Controls PENN Connected PC10 Manual de usuario

Aeotec

Aeotec Siren Gen5 Manual de usuario

Blaupunkt

Blaupunkt SA 2700 Manual de usuario

IDEAL

IDEAL Accenta Manual del propietario

AJAX

AJAX DoubleButton Manual de usuario

Swann

Swann SW-P-MC2 Manual de usuario

Ecolink

Ecolink Siren+Chime Manual de usuario

Digital Monitoring Products

Digital Monitoring Products XR150 Manual de usuario

EDM

EDM Solution 6+6 Wireless-AE Manual de usuario

Highway Safety Group

Highway Safety Group EA401 Manual de usuario

Siren

Siren LED GSM Manual de usuario

Detection Systems

Detection Systems 7090i Instrucciones de montaje

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manual de usuario

Siemens

Siemens FDM273 Manual de usuario