Interlogix ATS1831 Instrucciones de montaje

ATS1831/32 IUM Modules Installation Sheet

Figure 1: ATS1832 8 MB IUM module

Description

The intelligent user memory (IUM) module is an optional

memory expansion component that works with the Advisor

Master system. Two models are available: ATS1831 (4 MB)

and ATS1832 (8 MB).

Table 1: Advisor Master system capacities with IUM modules

User records (cards)

ATS1831

ATS1832

17,873/15,000

65,535/55,000

Users with PIN code (4 to 10 digits)

All users

Users names (max. 16 characters)

Users 1 to 200

Card data formats

Up to 48-bit

Programmable alarm groups

128

Door groups

128

Floor groups

Time zones

Alarm events buffer

1,000

Access events buffer

1,000/5,000/10,000*

* Applies to a control panel where ATS1831 can support 5,000 and

ATS1832 can support 10,000 access events. In all other cases 1,000

access events are supported.

Installation

WARNING: A qualified service person, complying with all

applicable codes, should perform all required hardware

installation.

IUM modules are plugged into a control panel PCB and any of

the panel’s intelligent four-door/four-lift controller PCBs to

increase system capacity. The control panel and any intelligent

four-door/four-lift controller must use memory expansion

modules of the same capacity.

Cautions

•When installing an IUM module onto a control panel, the

existing records for users, door groups, and floor groups

are erased from the control panel’s memory. You must

back up these records (if required) and reprogram them

into the control panel after installing the module.

•Take static preventative measures during installation.

A conductive wrist strap should be worn and connected to

a 0 V terminal (e.g. “Batt−” or “Aux Pwr−”). If a wrist strap

is unavailable, touch the 0 V terminal before installing, and

then avoid touching the pins of the chip.

Note the alignment notch on one end of the module.

To install the IUM module:

1. Disconnect the plug pack and battery from the control

panel or intelligent four-door/four-lift controller.

2. Carefully remove the module from its packaging, taking

extreme care that none of the pins are bent.

3. Note the orientation of the module. The module has a

notch, which corresponds with a notch on the IC socket.

If the IC socket is already fitted with a memory expansion

module, you must remove the module so that you can

insert the IUM module in its place.

4. With the notch on the module aligned with the notch on

the IC socket, carefully insert the module into the socket

marked “RAM/IUM” making sure that no pins are bent

under.

5. Gently press the module into the socket until all of the pins

sit firmly in the socket.

6. Clear the panel’s memory by shorting the KILL jumper for

a minimum of 30 seconds (refer to installation guides for

details).

7. Reapply power to the control panel or intelligent four-

door/four-lift controller.

Regulatory information

Manufacturer

PLACED ON THE MARKET BY:

UTC Fire & Security Americas Corporation, Inc.

3211 Progress Drive, Lincolnton, NC, 28092, USA

AUTHORIZED EU REPRESENTATIVE:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert, Netherlands

2 / 2 P/N 146489999-1 • REV C • ISS 09JUL19

Product warnings

and disclaimers

THESE PRODUCTS ARE INTENDED FOR SALE

TO AND INSTALLATION BY QUALIFIED

PROFESSIONALS. UTC FIRE & SECURITY

CANNOT PROVIDE ANY ASSURANCE THAT

ANY PERSON OR ENTITY BUYING ITS

PRODUCTS, INCLUDING ANY “AUTHORIZED

DEALER” OR “AUTHORIZED RESELLER”, IS

PROPERLY TRAINED OR EXPERIENCED TO

CORRECTLY INSTALL FIRE AND SECURITY

RELATED PRODUCTS.

For more information on warranty disclaimers and

product safety information, please check

https://firesecurityproducts.com/policy/product-

warning/ or scan the QR code.

Certification

UTC Fire & Security hereby declares that this

device is in compliance with the applicable

requirements and provisions of the Directive

2014/30/EU and/or 2014/35/EU. For more

information see www.utcfireandsecurity.com or

www.interlogix.com.

2012/19/EU (WEEE directive): Products marked

with this symbol cannot be disposed of as

unsorted municipal waste in the European Union.

For proper recycling, return this product to your

local supplier upon the purchase of equivalent

new equipment, or dispose of it at designated

collection points. For more information see:

www.recyclethis.info

Contact information

www.utcfireandsecurity.com or www.interlogix.com

For customer support, see www.utcfssecurityproducts.eu

Este manual sirve para los siguientes modelos

Otros manuales de Unidad de control de Interlogix

Interlogix

Interlogix SuperBus 2000 Manual de usuario

Interlogix

Interlogix ATS1201 8 Instrucciones de montaje

Interlogix

Interlogix ATS7340 Instrucciones de montaje

Interlogix

Interlogix VR1101M Instrucciones de instalación

Interlogix

Interlogix ATS7200N Instrucciones de montaje

Interlogix

Interlogix SuperBus 2000 PIV Manual de usuario

Interlogix

Interlogix VT1101M-AC Instrucciones de instalación

Interlogix

Interlogix ATS 500A Series Manual de usuario

Interlogix

Interlogix NX-595E Manual de usuario

Interlogix

Interlogix Simon XT Manual de usuario

Interlogix

Interlogix UM-ZW Manual de usuario

Interlogix

Interlogix TruPortal TP-ADD-2D-BRD Manual de usuario

Interlogix

Interlogix ATS7200E Instrucciones de montaje

Interlogix

Interlogix NX-586E Manual de usuario

Interlogix

Interlogix UltraSync UM-W7 Instrucciones de montaje

Interlogix

Interlogix UltraSync UM-Z8 Instrucciones de montaje

Interlogix

Interlogix 60-677 Manual de usuario

Interlogix

Interlogix ATS1520 Instrucciones de montaje

Interlogix

Interlogix DTIM Instrucciones de montaje

Interlogix

Interlogix TX-E121 Manual de usuario

Interlogix

Interlogix TruPortal TP-ADD-2D Series Manual de usuario

Interlogix

Interlogix UltraSync UM-C-H1 Instrucciones de montaje

Interlogix

Interlogix NXG-7002 Instrucciones de montaje

Interlogix

Interlogix 600-1046-95 Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario