Intel NUC6i3SYK Manual de usuario
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
1
Intel®
NUC Kit
NUC6i3SYK
Intel®
NUC Kit
NUC6i5SYK
User
Guide
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
2
Before You Begin
CAUTIONS
The procedures in this user guide assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications link or network before
performing any of the procedures described in this guide. Failure to disconnect power,
telecommunications links, or networks before you open the computer or perform any procedures can
result in personal injury or equipment damage. Some circuitry on the board can continue to operate
even though the front panel power button is off.
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
Electrostatic discharge (ESD) can damage components. Perform the procedures described in
this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
Installation Precautions
When you install and test the Intel NUC, observe all warnings and cautions in the installation
instructions.
To avoid injury, be careful of:
Sharp pins on connectors
Sharp pins on circuit boards
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, and heat sinks)
Damage to wires that could cause a short circuit
Observe all warnings and cautions that instruct you to refer computer servicing to qualified
technical personnel.
Observe Safety and Regulatory Requirements
If you do not follow these instructions, you increase your safety risk and the possibility of
noncompliance with regional laws and regulations.
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
3
This guide tells you how to:
•
Install and remove memory
•
Install an M.2 SSD
•
Install a VESA mount bracket
•
Connect power
•
Install an operating system
•
Install the latest device drivers and software
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.
Installing and Removing Memory
Intel NUC Kits NUC6i3SYK and NUC6i5SYK have two 260-pin DDR4 SO-DIMM sockets. Memory
requirements:
1.2V low voltage memory
2133 MHz SO-DIMMs
Non-ECC
For a list of tested memory, go to the System Memory page on the Support site:
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
4
Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
Removing SO-DIMMs
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer’s cover.
5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of
the socket.
6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-static
package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets.
8. Replace the computer’s cover and reconnect the AC power cord.
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
5
Install an M.2 SSD
Intel NUC Kits NUC6i3SYK and NUC6i5SYK support 80mm and 42mm SSDs. For a list of tested M.2 SSDs,
go to the Tested Peripherals page on the Support site.
If you are installing an 80mm M.2 SSD:
1. Remove the small silver screw from the 80mm metal standoff on the motherboard (A).
2. Align the small notch at the bottom edge of the M.2 card with the key in the connector.
3. Insert the bottom edge of the M.2 card into the connector (B).
4. Secure the card to the standoff with the small silver screw (C).
If you are installing a 42mm M.2 SSD:
1. Remove the small silver screw from the metal standoff on the motherboard (A).
2. Move the standoff (B) from the 80mm position to the 42mm position (C).
3. Align the small notch at the bottom edge of the M.2 card with the key in the connector.
4. Insert the bottom edge of the M.2 card into the connector (D).
5. Secure the card to the standoff with the small silver screw (E).
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
6
Close the Chassis
After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by
hand with a screwdriver to avoid over-tightening and possibly damaging the screws.
Attach and Use the VESA Bracket (Optional)
Follow these instructions to attach and use the VESA mount bracket:
1. Using the four small black screws that were included in the box, attach the VESA bracket to the
back of the monitor or TV.
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
7
2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.
3. Slide the Intel NUC onto the VESA mount bracket.
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
8
Connect Power
Country-specific power plug attachments are included in the Intel NUC Kit box.
1. Choose the attachment for your region.
SKU
(Product
codes)
Attachments in the box
NUC6i5SYK
NUC6i5SYKR
NUC6i3SYK
NUC6i3SYKR
US –United
States
UK –United
Kingdom
EU –European
Union
AUS - Australia
NUC6i5SYKL
NUC6i3SYKL
ARG - Argentina
CHN - China
BRA - Brazil
IND - India
KOR –South Korea
2. Slide the attachment (B) onto the power plug, locking it into place (A).
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
9
3. Connect AC power.
Install an Operating System
Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems, as well
as versions of Linux that have been reported as compatible by Intel NUC owners.
Refer to Operating System Installation for system requirements and installation steps.
Install the Latest Device Drivers and Software
Here are the options for keeping device drivers current:
Allow the Intel® Driver & Support Assistant (Intel® DSA) to detect out-of-date drivers
Manually download drivers, BIOS, and software from Download Center:
oNUC6i3SYK
oNUC6i5SYK
The following device drivers and software are available.
Intel® Chipset Device Software
Intel® HD Graphics
Intel® Management Engine
Intel® Gigabit Ethernet
Intel® Wireless
Intel® Bluetooth
Intel® USB 3.0 (needed for Windows 7* only)
Intel® Serial IO
Realtek* High Definition Audio
ITE Tech* Consumer Infrared
Near Field Communication (NFC)
Intel® Rapid Storage Technology
Intel NUC Kit NUC6i3SYK & NUC6i5SYK User Guide
10
Intel® Software Guard Extensions
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de De oficina de Intel
Intel
Intel NUC Kit NUC7i7DNHE Manual de usuario
Intel
Intel Compute Stick STCK1A8LFC Manual de usuario
Intel
Intel SR2520SAXSR - Server System - 0 MB RAM Manual de usuario
Intel
Intel NUC DN2820FYKH Manual de usuario
Intel
Intel TIGW1U - Carrier Grade Server Manual de usuario
Intel
Intel NUC 8 Enthusiast Manual de usuario
Intel
Intel NUC 7 Manual de usuario
Intel
Intel NUC6i5SYH Manual de usuario
Intel
Intel NUC 8 Mainstream-G NUC8i7INH Manual de usuario
Intel
Intel NUC7CJYSAL Manual de usuario
Intel
Intel NUC6i3SYH Manual de usuario
Intel
Intel NUC 8 Pro NUC8v7PN Manual de usuario
Intel
Intel NUC 8 Mainstream-G NUC8i5INH Guía de configuración
Intel
Intel NUC8i7BEK Manual de usuario
Intel
Intel SR4850HW4 - Server Platform - 0 MB RAM Manual de usuario
Intel
Intel LP300 Manual de usuario
Intel
Intel NUC8i7HVKVAW Manual de usuario
Intel
Intel NUC 9 Manual de usuario
Intel
Intel NUC6CAY Instrucciones de montaje
Intel
Intel SC5650SCWS Manual de usuario
