Impex MARCY MWB-544 Manual de usuario

MARCY

MWB-544 BENCH

IMPEX INC.

14777 Don Julian Rd., City of Industry, CA 91746

Tel: (800) 999-8899 Fax (626) 961-9966

www.impex-fitness.com

[email protected]

NOTE:

Please read all instructions

carefully before using this

product

Table of Contents

Safety Notice

Hardware Identifier

Assembly Instruction

Exploded Diagram

Parts List

Warranty

Ordering Parts

Model

MWB-544

Retain This

Manual for

Reference

March 5, 2005

OWNER'S

MANUAL

TABLE OF CONTENTS

BEFORE YOU BEGIN................................................................................................ 1

IMPORTANT SAFETY NOTICE................................................................................. 2

HARDWARE IDENTIFIER.......................................................................................... 3

ASSEMBLY INSTRUCTIONS.................................................................................... 4

EXPLODED DIAGRAM.............................................................................................. 8

PARTS LIST............................................................................................................... 9

WARRANTY............................................................................................................... 10

ORDERING PARTS................................................................................................... 10

BEFORE YOU BEGIN

Thank you for selecting the MARCY MWB-544 BENCH by IMPEX INC.

For your safety and benefit, read this manual carefully before using the

machine. As a manufacturer, we are committed to provide you

complete customer satisfaction. If you have any questions, or find

there are missing or damaged parts, we guarantee you complete

satisfaction through direct assistance from our factory. To avoid

unnecessary delays, please call our TOLL-FREE customer service

number. Our Customer Service Agents will provide immediate

assistance to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire manual

before you assemble or operate your machine. In particular, note the following safety

precautions:

1. Keep children and pets away from the machine at all times. DO NOT leave

children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine near

water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or

other clothing that could become caught in the machine. Running or aerobic shoes

are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO NOT use

attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or physician in

attendance.

10. Before using the machine to exercise, always do stretching exercises to properly

warm up.

11. Never operate the machine if the machine is not functioning properly.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE

OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.

ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY

DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

ASSEMBLY INSTRUCTION

Tools required to assembly the machine:

Two Adjustable Wrenches

STEP 1 (SEE Diagram 1)

A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#25) in the Mid-span.

Fasten them by two M10x 2 3/8” Bolts (#14), four ∅7/8” Washers (#13), one Bracket

(#12), and two M10 Aircraft Nuts (#15) on each side of the Cross Brace. DO NOT

tighten the nuts and bolts yet.

B.) Insert the Backrest Adjustment Bar (#10) through a selected hole to obtain desired

incline of Backrest.

C.) Insert two Bar Catches (#2) & (#6) into the selected hole on the Rear Upright Beams

(#1) to obtain the desired height to hold the weight bar. DIAGRAM 1

STEP 2 (SEE DIAGRAM 2)

A.) Connect the Front Stabilizer (#49) to the Main Seat Support (#32) and secure them

with two M10 x 1” Bolts (#42), four ∅7/8” Washers (#13), and two M10 Aircraft Nuts

(#15). DO NOT tighten the nuts and bolts yet.

B.) Connect the Main Seat Support (#32) to the Cross Brace (#25) and secure it with two

M10 x 2 3/8”Bolts (#14), four ∅7/8” Washers (#13),one Bracket (#12), and two M10

Aircraft Nuts (#15).

C.) Connect one end of Diagonal Support (#40) to the Main Seat Support (#32). Secure

it with one M8 x 2 1/8” Bolt (#38), two ∅¾” Washers (#37) and one M8 Aircraft Nut

(#36). Connect the other end to the Front Stabilizer. Secure it with one M8 x 5/8” Bolt

(#27) and ∅¾” Washer (#37).

D.) Securely tighten all nuts and bolts previously installed.

E.) Insert Lock Pin (#26) into the hole on the Main Seat Support (32). Only use the pin

when changing the backrest board to a vertical position. DIAGRAM 2

STEP 3 (SEE DIAGRAM 3)

A.) Attach a ∅7/8” Washer (#13) onto a M10 x4 ½” Bolt (#24). Insert the Bolt through the

Butterfly (#22). Place a M10 Regular Nut onto the Bolt. Then insert the Bolt through

the hole on the Rear Upright Beam (#1). Secure the Bolt with a Knob (#11) behind

the Upright Beam. Repeat the same step to install the other Butterfly.

B.) Attach the Left Butterfly Handle (#19) to the Left Butterfly (#22). Secure it with a M10

x 2 ¼” Bolt (#18), ∅7/8” Washer (#13), and M10 Aircraft Nut (#15). Repeat the same

step to install the Right Butterfly Handle (#21).

C.) Attach the Leg Developer (#47) onto the bracket on the Front Stabilizer (#49).

Secure it with a Hex Socket Axle (#43) and Hex Socket Screw (#46).

D.) Insert two Foam Roll Tubes (#48) halfway through the holes on the Leg Developer

(#47). Push four Foam Rolls (#39) onto the tubes from both sides.

E.) Place a Spring Clip (#4) onto the weight holder on the Leg Developer.

DIAGRAM 3

STEP 4 (SEE DIAGRAM 4)

A.) Attach the hole-side of the Backrest Supports (#28) onto both ends of the Pivot on the

Main Seat Support (#32). The other side rest against the Backrest Adjustment Bar

(#10).

B.) Place the Backrest Board (#33) onto the Backrest Support (#28). Fasten it with four M6

x 1 3/8” Bolts (#31) and ∅½” Washers (#30).

C.) Place Seat Cushion (#34) onto the bracket on the Main Seat Support (#32). Align the

holes and fasten the Seat with four M6 x 1 3/8” Bolts (#31) and ∅½” Washers (#30).

D.) Insert the Arm Curl Stand (#44) into the opening on the top of the Front Stabilizer (#49).

Secure it with a Knob Bolt (#41).

E.) Attach the Arm Curl Pad (#35) to the Arm Curl Stand (#44). Secure itwith two M8 x 5/8”

Bolts (#27) and ∅¾” Washers (#37).

DIAGRAM 4

PARTS LIST

KEY NO. DESCRIPTION QUANTITY

1 Rear Upright Beam 2

2 Right Bar Catch 1

3 Curl Bar 1

4 Spring Clip 5

5 1” Round End Cap 16

6 Left Bar Catch 1

7 Bar Catch Panel 2

8 3/4” Flat End Cap 4

9 1 ½” Square End Cap 12

10 Backrest Adjustment Bar 1

11 Knob 2

12 Bracket 3

13 ∅7/8” Washer 20

14 M10 x 2 3/8” Bolt 6

15 M10 Aircraft Nut 10

16 1 1/8” Plastic Stopper 2

17 3/8” Bushing 10

18 M10 x 2 ½” Carriage Bolt 2

19 Left Butterfly Handle 1

20 Grip 2

21 Right Butterfly Handle 1

22 Butterfly 2

23 M10 Regular Nut 2

24 M10 x 4 ½” Bolt 2

25 Cross Brace 1

26 Lock Pin 1

27 M8 X 5/8” Bolt 3

28 Backrest Support 2

29 1” Flat End Cap 2

30 ∅½” Washer 8

31 M6 x 1 3/8” Bolt 8

32 Main Seat Support 1

33 Backrest Board 1

34 Seat Cushion 1

35 Arm Curl Pad 1

36 M8 Aircraft Nut 1

37 ∅3/4” Washer 5

38 M8 x 2 1/8” Bolt 1

39 Foam Roll 4

40 Diagonal Support 1

41 Knob Bolt 1

42 M10 X 1” Bolt 2

43 Hex Socket Axle 1

44 Arm Curl Stand 1

45 1 ¾” Square Sleeve 1

46 Hex Socket Screw 1

47 Leg Developer 1

48 Foam Roll Tube 2

49 Front Stabilizer 1

50 1 3/4” Square End Cap 2

51 Weight Plate 10# 2

52 Weight Plate 15# 2

53 Weight Plate 25# 2

54 Weight Bar 1

Tabla de contenidos

Otros manuales de Gimnasio en casa de Impex

Impex

Impex MARCY DIAMOND ELITE SM-1050 Manual de usuario

Impex

Impex Powerhouse Club PHC 750 Manual de usuario

Impex

Impex MARCY SM 2000 Manual de usuario

Impex

Impex ADI-10250-I Manual de usuario

Impex

Impex Iron Grip Strength IGS-705 Manual de usuario

Impex

Impex SB 650W Manual de usuario

Impex

Impex MWB-50100 Manual de usuario

Impex

Impex MARCY AB4050 Manual de usuario

Impex

Impex Marcy MCB-999 Manual de usuario

Impex

Impex COMPETITOR WM-354 Manual de usuario

Impex

Impex Iron Grip Strength IGS-412 Manual de usuario

Impex

Impex MARCY MKB-733 Manual de usuario

Impex

Impex MARCY MWM-1860 Manual de usuario

Impex

Impex MARCY MWM 800 Manual de usuario

Impex

Impex MARCY SM-6001 Manual de usuario

Impex

Impex POWERHOUSE JD 1 Manual de usuario

Impex

Impex MWM-981 Manual de usuario

Impex

Impex MARCY SM-4231 Manual de usuario

Impex

Impex Iron Grip Strength IGS-6900 Manual de usuario

Impex

Impex MARCY MWM-1558 Manual de usuario

Impex

Impex MARCY MWB-9000 Manual de usuario

Impex

Impex Marcy MWM-7119 Manual de usuario

Impex

Impex Marcy Diamond MD-805 Manual de usuario

Impex

Impex MARCY MWM-980 Manual de usuario

Manuales populares de Gimnasio en casa de otras marcas

Horizon Fitness

Horizon Fitness OXFORD 6 Manual de usuario

Energetics

Energetics Multi Trainer 5.1 Manual de usuario

Matrix

Matrix MG-PL Series Manual de usuario

Reebok

Reebok Tbr2i Manual de operación y mantenimiento

Weider

Weider 8300 Hard Drive Manual de usuario

Pure Fitness

Pure Fitness 8526HE Manual de usuario

Weider

Weider 8700 I Guía de inicio rápido

Bowflex

Bowflex Sport 001-6961 Manual de usuario

NordicTrack

NordicTrack E8200 Competition Bench Guía de inicio rápido

Weider

Weider WEMC10161 Manual de usuario

Body Solid

Body Solid GHYP-345 Manual de usuario

Evo

Evo TAHOE 5105 Manual de usuario

cardiobull

cardiobull RA17 Manual de usuario

ParaBody

ParaBody 40 Manual de usuario

JLL

JLL Ventus Pro Air Power Manual de usuario

Trojan

Trojan Colorado 370 Manual de usuario

Octane Fitness

Octane Fitness xRide xR650 Manual de usuario

Precor

Precor Discovery Series Manual de usuario