iHome iH110 Manual de usuario
Model iH110
Alarm Clock FM Radio
for your iPod ®
Questions? Visit www.ihomeaudio.com
Model:iH110
InstructionManual
Date:June25,08
Printcolor:Blacktextonwhitepaper
Size:178Wx140Hmm
1
2
3
3
4
4
5
5
5
6
7
7
8
9
10
11
Quick Start
Controls and Indicators
iH110 Display
Install Clock Backup Battery
Setting Up the iH110
Charging your iPod
Listening to your iPod
Listenng to FM Radio
Listening to non-docking iPod or other portable audio device
Alarm Operation
Sleep Operation
Snooze/Dimmer Operation
A Consumer Guide to Product Safety
Trouble Shooting
Solución De Problemas
Warranty Information
Table of Contents
• Place the unit on a level surface away from sources of direct sunlight or excessive heat.
• Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material
should be placed between it and the furniture.
• Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner
or similar materials can damage the surface of the unit.
Maintenance
FCC Information
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These
limits provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate
interference you can try one or more of the following corrective measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the radio or TV.
• Use outlets on different electrical circuits for the equipment and the radio or TV.
Consult your dealer or an experienced radio/television technician if the problem still exists.
Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate
the system’s warranty and void your FCC authorization to operate it.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
RESET
RESET
TEST
TEST
1
Quick Start
2:inserts
Select the dock insert for your
iPod model from the table below
and place insert in dock.
Never dock an iPod without
an insert in place.
3:iPod
Insert iPod into dock with proper
insert (iPod must not be in a skin or
case). iPod will charge while docked.
Press iPod Button on iH110 to play
iPod.
4:time • Move the DST switch on the back of the unit to +1 or -1 (adds or
subtracts an hour to account for daylight saving time).
• Press & Hold the Clock adj. button on the back of the unit until
the display flashes.
• Press the UP or DOWN buttons to set current time.
• Press the Clock Adj. button again to confirm time setting.
NOTE: If the insert for your iPod isn’t listed, please visit an Apple store or www.ihomeaudio.com
to purchase the proper insert.
iPod Touch
thin iPod with video (30 GB)
Insert 9
3rd Gen nano
insert 13
3rd Gen nano
iPod with video (60,80 GB)
Insert 10
thin (30 GB) iPod with video
thin (80GB) iPod classic
thick (60, 80 GB) iPod with video
thick (160 GB) iPod classic
iPod Touch
insert 14
For this iPod
Use this insert
1:power
Attach AC adaptor cable to jack on
back of the iH110 and plug the
other end into a wall socket.
DC 10Vline in clock adj.
dst
-1 +1 on o
Controls and Indicators
Front Panel
Power/
Alarm Reset Button
Volume + Button
iPod Dock
Mode/Wake-to Button
Volume - Button
DST Switch
Snooze/Dimmer Button
Back Panel
2
DC Jack
Alarm Set /
Alarm On/Off Button
Clock Adj. Button
Sleep Set Button
EXB Expanded Bass Switch
Line-in Jack
DC 10Vline in clock adj.
dst
-1 +1 on o
FM Tune / Set /
Adjust Up/Down Button
Installing Backup Battery
3
Install Clock Backup Battery
iH110 Display
PM Indicator
FM Indicator
Wake to Indicator
Battery Low Indicator
Daylight Saving Time
Indicator
iPod Indicator Radio Indicator
Buzzer Indicator
Sleep Indicator
Alarm Indicator
Time Display
The iH110 uses a CR2032 button cell backup battery system to provide
continuous alarm operation and clock settings in the event of a power
failure. If the Backup Battery has been installed and a power failure
occurs or the AC adaptor is accidentally disconnected, the display backlight
will not remain lit, but current time and alarm time settings will be temporarily
maintained. Otherwise, you must reset the time and alarm settings.
1. Please make sure the AC adaptor is connected. Otherwise all settings may
be lost during battery replacement.
2. Open backup battery compartment door located on the backside of the unit.
3. Insert one CR2032 button cell battery, checking that the polarity (+ and
– sides of the battery) matches the drawing in the battery compartment.
Close the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
Setting the Clock Time
Note: Press the Clock Adj. Button once during normal operation to view the current time display format (12 hour or 24 hour
format). 12 hour is the default format.
1. Press and hold the Clock Adj. Button for 2 seconds until the display flashes. Press the UP or DOWN Button until the
current time is displayed.
2. For 12 hour or 24 hour time format setting: Press the Alarm Set Button during time setting to set 12-hour or 24-hour
display format. Remember to set the correct AM or PM time (an icon to the right of the time display is the PM indicator;
there is no AM indicator). Note that the PM indicator will not appear when using 24 hour display mode.
3. Press the Clock Adj. Button again to confirm the clock setting. You should hear 2 beeps indicating the clock time is set.
4. During daylight saving time, set the DST Switch located on the back of the unit to +1 to advance the time one hour. The
DST Icon will appear on the display to indicate DST is on. Set the switch to -1 to set the time back one hour at the end
of daylight saving time.
4
Setting Up the iH110
Note: Please make sure you are using the correct insert for your iPod (see page 1) and that it is properly docked into the
iH110. Failure to do so may damage your iPod.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). The iH110
will not overcharge your iPod. Note that other non-docking iPods will NOT charge.
Charging your iPod
1. Dock the already playing iPod. The iH110 will automatically turn on and you will hear the music playing from your iPod.
The will appear at the left lower corner the display, indicating iPod playing mode.
For enhanced bass, slide the EXB Expanded Bass Switch located on the back of the unit to the ON position.
Note: If the playing song/music loudness is too low on the iPod, the iH110 may not detect that the iPod is in play mode.
Press the on the iPod to play it.
2. Press the and Buttons to adjust the system volume.
3. Press the UP or DOWN Button to go to the next or previous track. Press and hold while a track is playing for high speed
forward or reverse music search of the current track.
4. To turn the iH110 OFF, press the Power Button. Your iPod will continue charging while in the dock.
For best reception, extend the FM antenna away from unit and adjust as needed. Do not alter antenna.
1. Press the Power Button to turn on the unit. Press the Mode Button until the radio icon appears.
2. Press the UP or DOWN Button to tune in the desired FM station. Press and hold to seek the next clear FM stattion.
3. Press the and Buttons to adjust the volume.
4. To turn the iH110 OFF, press the Power Button.
5
Listening to your iPod
Listening to FM Radio
You can play an iPod without a docking port or other MP3 player or portable audio device through the iH110 via the
Line-in Jack.
1. Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on
your device and the other end of the patch cord into the iH110 Line-in Jack, located on the back of the unit.
2. Press the Power Button to turn the iH110 on. Press the Mode Button until the icon appears at the lower left
corner the display, indicating Line-in playing mode.
3. Turn on and play your device.
4. Press the and Buttons to adjust the system volume. You may need to adjust your device volume, too.
5. To turn othe iH110 OFF, press the Power Button. Please remember to turn off your device, too.
Listening to a non-docking iPod or other portable audio device
The iH110 Home System for iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally
disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery).
This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set.
NOTE: TO WAKE TO iPod, YOUR iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO
ALARM WILL SOUND. You CANNOT wake to Line in audio devices.
Setting the Alarm
1. Press and hold the Alarm Set Button until the display flashes. Press the UP or DOWN Button until the desired alarm
time is displayed. Remember to set the correct AM or PM time, indicated by PM on the display; there is no AM indicator.
2. Press the Mode Button as needed to select radio, buzzer or iPod as your wake to source. The icon for the selected
wake source will flash.
3. Press the Alarm Set Button again to exit the setting mode. You should hear 2 beeps indicating the alarm is set.
Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the icon. To disarm the alarm,
press the Alarm Set Button. The Alarm Icon will disappear and the alarm will not sound at the set time.
Note: Make sure to adjust volume level for a comfortable wake up volume.
4. When the alarm is sounding, the Alarm Icon will flash.
• To snooze during the alarm, press the Snooze/Dimmer Button. The alarm will be silenced for 9 minutes, then come
on again.
• To turn the alarm off, press the Alarm Reset/Power Button. The alarm will come on again the next day at the same
time.
5. If the alarm is not turned off after it sounds, it will play for approximately one hour then turn off automatically. This cycle
will repeat every 24 hours unless the controls are changed.
Note: Please make sure your iPod has enough songs to play for one hour, otherwise please set the iPod repeat mode to ON.
Note: If there is no iPod present or there is no music detected on the iPod at alarm time, the iH110 will automatically switch
to buzzer alarm.
6
Alarm Operation
1. When the iH110 is off or while listening to your iPod, press the Sleep/Minute Set Button to enter sleep mode. The
Sleep Icon will appear on the display to indicate it is in sleep mode. Sleep mode has a Gentle Sleep feature which
gradually lowers the volume before it shuts off.
2. You can adjust the sleep timer from 90, 60, 30 or 15 minutes by pressing the Sleep/Minute Set Button again.The unit
will automatically turn off after the selected time.
3. When the display changes back to show the real time, pressing the Sleep/Minute Set Button once will show the sleep
time remaining. Pressing it again will change the sleep time to the next lowest increment.
4. The iH110 has an independent volume setting for sleep mode so you can adjust the sleeping volume without affecting
the alarm volume. Press the and Buttons to adjust the sleep volume. The sleep volume will remain at that level
the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Alarm Reset/Power Button to turn unit off.
1. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will go off and will come on again in about 9
minutes. You may repeat this cycle several times during the one hour alarm cycle.
2. During normal operation, press the Snooze/Dimmer Button to control the brightness (high, medium, low and off) of the
LCD display and side accent lights.
7
Sleep Operation
Snooze/Dimmer Operation
Tabla de contenidos
Otros manuales de Radio reloj de iHome
iHome
iHome iBT280 Manual de usuario
iHome
iHome iP44 Manual de usuario
iHome
iHome iD83 Manual de usuario
iHome
iHome iBT29 Manual de usuario
iHome
iHome iBT233 Manual
iHome
iHome iDL100 Manual de usuario
iHome
iHome HiP50 Manual de usuario
iHome
iHome iP47 Manual de usuario
iHome
iHome iHC5 Manual de usuario
iHome
iHome iDL46 Manual de usuario
iHome
iHome iDL100 Manual de usuario
iHome
iHome iBN43 Manual de usuario
iHome
iHome iHM50R Manual de usuario
iHome
iHome iH5 Manual de usuario
iHome
iHome HBH34 Manual de usuario
iHome
iHome iBT234 Manual de usuario
iHome
iHome iPL8XH Manual de usuario
iHome
iHome HiH60 Manual de usuario
iHome
iHome iBT230 Manual de usuario
iHome
iHome iBT97 Manual de usuario
