IBM EXN4000 Manual

IBM System Storage

EXN4000 Storage Expansion Unit

Installation and Setup Instructions

GC27-2079-02



IBM System Storage

EXN4000 Storage Expansion Unit

Installation and Setup Instructions

GC27-2079-02



Notices

Mail comments to:

IBM Corporation

Attention Department GZW

9000 South Rita Road

Tucson, AZ 85744-0001

www.ibm.com/storage/support/nseries/

References in this publication to IBM products or services do not imply that IBM intends to make them available in

every country or region.

IBM, the IBM logo, and ibm.com®are trademarks or registered trademarks of International Business Machines

Corporation in the United States, other countries, or both. A complete and current list of other IBM trademarks is

available on the web at www.ibm.com/legal/copytrade.shtml.

Data ONTAP, NetApp, and Network Appliance are trademarks and/or registered trademarks of NetApp, Inc in the

United States and other countries.

Other company, product, and service names may be trademarks or service marks of others.

US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract

with IBM Corp.

Contents

Before you begin ...........v

Overview of the EXN4000 storage expansion unit. . vi

Installation and setup instructions . . . 1

Unpacking the EXN4000 ..........1

Installing the rails in an IBM 19-inch rack ....1

Installing the EXN4000 in the rack .......3

Setting the speed switch ..........4

Grounding expansion units .........5

Installing the power cables .........6

Connecting power to the EXN4000 .......6

Setting the storage expansion unit shelf IDs ....7

Cabling the EXN4000 ...........8

Booting the system ............8

Before you begin

This document provides installation and setup instructions for the IBM®System

Storage®EXN4000 storage expansion unit, sometimes referred to as a shelf in this

and other documents.

Additional information about the EXN4000, including a comparison of the

EXN4000 with other N series storage expansion units, can be found in the IBM

System Storage EXN4000 Storage Expansion Unit Hardware and Service Guide.

For additional information about the EXN4000 and related topics, refer to the

following resources:

vIBM System Storage N series Introduction and Planning Guide

vIBM Environmental Notices and User Guide

vIBM System Storage N series support website at www.ibm.com/storage/

support/nseries/

Read the safety notices

Before continuing, make sure that you have reviewed the safety notices in the

documentation that came with this system. Do not plug any cables into the system,

adapters, or any electrical outlets until you have reviewed the safety information

and followed the procedures in this document.

Need help?

If you encounter any difficulties while setting up your system, contact IBM service

and support for assistance. More information can also be found on the IBM System

Storage N series support website:

www.ibm.com/storage/support/nseries/

About the IBM N series support website

The IBM System Storage N series support website requires users to register in

order to obtain access to N series support content on the web. To understand how

the N series support web content is organized and navigated, and to access the N

series support website, go to the following publicly accessible web page:

www.ibm.com/storage/support/nseries/

This web page also provides links to AutoSupport information as well as other

important N series product resources.

Software requirements

Verify that your storage system meets the following software requirements:

vN3220 and N3240 Data ONTAP 8.1RC2 or later.

vFor Data ONTAP 7.xreleases, the minimum software requirement to support the

EXN4000 is Data ONTAP 7.3.3P2 or later, except for N3400 and N3600 systems,

which require Data ONTAP 7.3.4 or later.

vFor Data ONTAP 8.x7-Mode releases, the minimum software requirement to

support the EXN4000 is Data ONTAP 8.0P1 or later, except for N3400 and N3600

systems, which require Data ONTAP 8.0.1 or later.

Customer-supplied items for installation

vConsole (for example, a PC or laptop) with a serial port

v#2 Phillips screwdriver

vFlat-bladed screwdriver

v7-mm nut driver (for setting ID switches)

vAntistatic electrostatic discharge (ESD) wrist strap and grounding leash

Hot-adding EXN4000s

You can hot-add an EXN4000 to any supported storage system. For hot-adding

instructions, see the IBM System Storage N series EXN4000 Hardware and Service

Guide.

Overview of the EXN4000 storage expansion unit

Refer to the following figures to familiarize yourself with the EXN4000 storage

expansion unit.

8910111213 3 2 1 0

Drive Bays

Shelf 1

013

Loop ID

29 - 16

Figure 1. Shelf ID label

Power

Fault

Loop A

Loop B

System

Disk shelf ID display

Figure 2. EXN4000 front panel LEDs

Installation and setup instructions

Use these instructions to install and set up your EXN4000 storage expansion unit.

Unpacking the EXN4000

Use these instructions to unpack the EXN4000.

About this task

Important: If your system was shipped already assembled and cabled in a rack, go

directly to the Installation and Setup Instructions for your N series storage system.

Note: The contents of the box might differ based on the model you purchased.

Procedure

1. Verify that the EXN4000 (2863-004) shipping packages include the following

items:

v1 EXN4000 storage expansion unit

v1 Enclosure shelf IDs label

vSmall Form Factor Pluggable (SFP) module (optional)

v1 IBM rail kit

v1 electrostatic discharge (ESD) wrist strap

v1 set of publications

v2 power cords

vMiscellaneous data cables, as ordered

CAUTION:

Use safe practices when lifting.

svc00168

32-55 kg (70.5-121.2 lbs)

CAUTION:

The weight of this part or unit is between 32 and 55 kg (70.5 and 121.2

lb). It takes three persons to safely lift this part or unit. (C010) To

make the unit lighter and easier to move, remove the power supplies

and Input/Output modules (IOMs), noting the location of each

component for reinstallation. Do not remove the disk drives or drive

blank covers to reduce the weight. After the unit is installed in the

rack, reinsert the power supplies and IOMs.

2. Remove the expansion unit and its tray using the handles built into the

cardboard tray. Place the expansion unit and tray on a table.

3. Remove the top portion of the plastic surrounding the expansion unit.

Installing the rails in an IBM 19-inch rack

Use these instructions to install the rails on which you will mount the EXN4000.

About this task

Note: Read this document in its entirety before proceeding.

Procedure

1. Loosen (but do not remove) the four rail adjustment screws on each rail, as

shown in Figure 3.

2. Refer to Figure 4 on page 3. At the front of the rack, position the right-hand rail

in the rack at the appropriate EIA location. Make sure that the two locating

pins seat properly. The bottom of the rail should line up with the bottom EIA

boundary.

Note: When installed, each EXN4000 will occupy a 3U space.

Right rail

Left rail

Front of rack

Rear of rack

Rail adjustment

screws

Locating pins

exn40002

Figure 3. Installing the rails in the rack

Tabla de contenidos

Otros manuales de Almacenamiento de IBM

IBM

IBM DTCA-23240 - Travelstar 3.2 GB Hard Drive Manual de usuario

IBM

IBM DCS3860 Instrucciones de funcionamiento

IBM

IBM TotalStorage DS5100 Instrucciones de funcionamiento

IBM

IBM eserver p Series Manual de usuario

IBM

IBM 7131-105 Manual de usuario

IBM

IBM N6000 Series Manual de usuario

IBM

IBM DS4700 EXPRESS Instrucciones de funcionamiento

IBM

IBM TS4300 3555 Manual de usuario

IBM

IBM SAN42B-R Manual

IBM

IBM 4mm DDS-2 Tape Autoloader Manual de usuario

IBM

IBM 3340 Manual de usuario

IBM

IBM DDS Generation 6 USB Manual de usuario

IBM

IBM SAN32B-E4 Manual

IBM

IBM TotalStorage DS4800 Instrucciones de funcionamiento

IBM

IBM SAN768B-2 Manual de usuario

IBM

IBM 7331 Manual de usuario

IBM

IBM 7208 Manual

IBM

IBM Storwize V3700 Manual de usuario

IBM

IBM DS8882F Manual técnico

IBM

IBM System x3755Types 7163 Manual de usuario

IBM

IBM Storwize V7000 Manual de usuario

IBM

IBM Deskstar 40GV Manual de usuario

IBM

IBM DS4700 EXPRESS Manual de usuario

IBM

IBM 2498-B40 Instrucciones de funcionamiento e instalación

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

HP StorageWorks MSL2024 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

HP P9000 Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario