IBASE Technology IBR115 Manual de usuario

IBR115

NXP Cortex™ A9 i.MX6

Dual-Lite SoC

User’s Manual

Version 1.0

(Jan. 2018)

IBR115 User’s Manual

No part of this publication may be reproduced, copied, stored in a retrieval

system, translated into any language or transmitted in any form or by any

means, electronic, mechanical, photocopying, or otherwise, without the prior

written consent of IBASE Technology, Inc. (hereinafter referred to as

“IBASE”).

Disclaimer

IBASE reserves the right to make changes and improvements to the

products described in this document without prior notice. Every effort has

been made to ensure the information in the document is correct; however,

IBASE does not guarantee this document is error-free.

IBASE assumes no liability for incidental or consequential damages arising

from misapplication or inability to use the product or the information

contained herein, nor for any infringements of rights of third parties, which

may result from its use.

Trademarks

All the trademarks, registrations and brands mentioned herein are used for

identification purposes only and may be trademarks and/or registered

trademarks of their respective owners.

IBR115 User’s Manual

iii

Compliance

In a domestic environment, this product may cause radio interference in

which case users may be required to take adequate measures.

This product has been tested and found to comply with the limits for a Class

B device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with manufacturer’s

instructions, may cause harmful interference to radio communications.

WEEE

This product must not be disposed of as normal household

waste, in accordance with the EU directive of for waste

electrical and electronic equipment (WEEE - 2012/19/EU).

Instead, it should be disposed of by returning it to a

municipal recycling collection point. Check local

regulations for disposal of electronic products.

Green IBASE

This product is compliant with the current RoHS

restrictions and prohibits use of the following substances

in concentrations exceeding 0.1% by weight (1000 ppm)

except for cadmium, limited to 0.01% by weight (100 ppm).

•Lead (Pb)

•Mercury (Hg)

•Cadmium (Cd)

•Hexavalent chromium (Cr6+)

•Polybrominated biphenyls (PBB)

•Polybrominated diphenyl ether (PBDE)

IBR115 User’s Manual

Important Safety Information

Carefully read the precautions before using the board.

Environmental conditions:

•Use this product in environments with ambient temperatures between

0˚C and 60˚C.

•Do not leave this product in an environment where the storage

temperature may be below -40°C or above 85°C. To prevent from

damages, the product must be used in a controlled environment.

Care for your IBASE products:

•Before cleaning the PCB, unplug all cables and remove the battery.

•Clean the PCB with a circuit board cleaner or degreaser, or use cotton

swabs and alcohol.

•Vacuum the dust with a computer vacuum cleaner to prevent the fan

from being clogged.

WARNING

Attention during use:

•Do not use this product near water.

•Do not spill water or any other liquids on this product.

•Do not place heavy objects on the top of this product.

Anti-static precautions

•Wear an anti-static wrist strap to avoid electrostatic discharge.

•Place the PCB on an anti-static kit or mat.

•Hold the edges of PCB when handling.

•Touch the edges of non-metallic components of the product instead of

the surface of the PCB.

•Ground yourself by touching a grounded conductor or a grounded bit of

metal frequently to discharge any static.

CAUTION

Danger of explosion if the internal lithium-ion battery is replaced by an

incorrect type. Replace only with the same or equivalent type recommended

by the manufacturer. Dispose of used batteries according to the

manufacturer’s instructions or recycle them at a local recycling facility or

battery collection point.

IBR115 User’s Manual

Warranty Policy

•IBASE standard products:

24-month (2-year) warranty from the date of shipment. If the date of

shipment cannot be ascertained, the product serial numbers can be

used to determine the approximate shipping date.

•3rd-party parts:

12-month (1-year) warranty from delivery for the 3rd-party parts that are

not manufactured by IBASE, such as CPU, CPU cooler, memory,

storage devices, power adapter, panel and touchscreen.

＊PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,

IMPROPER INSTALLATIONOR UNAUTHORIZED REPAIR SHALL BE

TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL BE

BILLED FOR REPAIR AND SHIPPING CHARGES.

Technical Support & Services

1. Visit the IBASE website at www.ibase.com.tw to find the latest

information about the product.

2. If you need any further assistance from your distributor or sales

representative, prepare the following information of your product and

elaborate upon the problem.

•Product model name

•Product serial number

•Detailed description of the problem

•The error messages in text or in screenshots if there is any

•The arrangement of the peripherals

•Software in use (such as OS and application software, including the

version numbers)

3. If repair service is required, you can download the RMA form at

http://www.ibase.com.tw/english/Supports/RMAService/. Fill out the

form and contact your distributor or sales representative.

IBR115 User’s Manual

Table of Contents

Compliance.....................................................................................iii

Important Safety Information........................................................iv

Warranty Policy ...............................................................................v

Technical Support & Services .......................................................v

Chapter 1 General Information.............................................1

1.1 Introduction .........................................................................................2

1.2 Features..............................................................................................2

1.3 Packing List.........................................................................................3

1.4 Optional Accessories...........................................................................3

1.5 Specifications......................................................................................4

1.6 Overview.............................................................................................6

1.7 Dimensions .........................................................................................7

Chapter 2 HardwareConfiguration..........................................9

2.1 M.2 Card Installation .........................................................................10

2.2 Setting the Jumpers ..........................................................................11

2.2.1 How to Set Jumpers.............................................................11

2.3 Jumper & Connector Locations on IBR115........................................12

2.4 Jumpers Quick Reference.................................................................13

2.4.1 LVDS Power Setting (P16)..................................................13

2.4.2 LVDS Backlight Power Setting (P15)...................................14

2.5 Connectors Quick Reference.............................................................15

2.5.1 RS-232/422/485 Selection (SW3) .......................................16

2.5.2 RTC Lithium Cell Connector (P2)........................................16

2.5.3 LVDS Display Connector (P8).............................................17

2.5.4 LVDS Backlight Control Connector (P9)..............................18

2.5.5 USB Hub Connector (P13)..................................................18

2.5.6 COM RS-232/422/485 Port (P10)........................................19

2.5.7 Audio Connector (P14)........................................................20

2.5.8 2-Wire UART Connector (P17)............................................20

2.5.9 Digital (GPIO) Connector (P18)...........................................21

2.5.10 COM RS-232 Debug Connector (P19) ................................21

2.5.11 I2C Connector (P20)............................................................22

IBR115 User’s Manual

vii

Chapter 3 Software Setup...................................................23

3.1 Make a Recovery MicroSD Card........................................................24

3.1.1 Preparing the Recovery MicroSD card to Install Linux/ Android

image into eMMC.................................................................................24

3.1.2 Upgrade Firmware through the Recovery MicroSD Card ......26

3.2 Display Parameter Setting in Kernel ..................................................27

Chapter 4 BSP Source Guide..............................................28

4.1 Building BSP Source .........................................................................29

4.1.1 Preparation...........................................................................29

4.1.2 Installing Toolchain...............................................................29

4.1.3 Building U-Boot.....................................................................29

4.1.4 Building Kernel .....................................................................29

4.1.5 Building RAMdisk Image (Optional)......................................30

4.1.6 Install Linux to MicroSD Card ...............................................30

4.1.7 Booting with Your MicroSD Card ..........................................30

Appendix........................................................................................31

A. How to Use GPIO in Linux.................................................................32

B. How to Use Watchdog in Linux..........................................................32

C. eMMC Test........................................................................................33

D. USB (flash disk) Test.........................................................................34

E. MicroSD Card Test ............................................................................35

F. RS-232 Test ......................................................................................36

G. RS-485 Test ......................................................................................37

H. Audio Test .........................................................................................37

I. I2C Test .............................................................................................38

J. Ethernet Test.....................................................................................38

K. LVDS Test.........................................................................................39

L. HDMI Test .........................................................................................40

viii

IBR115 User’s Manual

This page is intentionally left blank.

Chapter 1

General Information

The information provided in this chapter includes:

•Features

•Packing List

•Specifications

•Block Diagram

•Board Overview

•Board Dimensions

IBR115 User’s Manual

1.1 Introduction

IBR115 is a 2.5" Disk-Size SBC with ARM Based NXP i.MX6 Cortex-A9

1GHz CPU. The device offers 2D, 3D graphics and multimedia accelerations

while also supporting numerous peripherals, including RS232/422/485,

COM, GPIO, USB, USB OTG, LAN and audio interfaces. For display, it

supports one HDMI for a full HD display and one LVDS. For wireless

connectivity, itsupports M.2 Key-E, Type 2230 for the M.2 module expansion

that are well suited for industrial applications.

Photo of IBR115

1.2 Features

•NXP ARM Cortex™A9 i.MX6 Dual-Lite 1 GHz processor

•Video output through HDMI and single-channel LVDS

•1 GB DDR3, 4 GB eMMC and MicroSD socket for expansion

•Rich I/O interface with COM, GPIO, USB, USB-OTG, audio and

Ethernet

•M.2 Key-E (2230) for wireless connectivity

•2 x UART headers

•OpenGL ES 2.0 for 3D BitBlt for 2D and OPENVG1.1 hardware

accelerators

Tabla de contenidos

Otros manuales de Placa madre de IBASE Technology

IBASE Technology

IBASE Technology AFW-3000 Manual de usuario

IBASE Technology

IBASE Technology MB930-R Manual de usuario

IBASE Technology

IBASE Technology IB804 Manual de usuario

IBASE Technology

IBASE Technology IB915F Manual de usuario

IBASE Technology

IBASE Technology MI963F Manual de usuario

IBASE Technology

IBASE Technology MI930 Manual de usuario

IBASE Technology

IBASE Technology MB898 Manual de usuario

IBASE Technology

IBASE Technology MI958 Manual de usuario

IBASE Technology

IBASE Technology MI910 Manual de usuario

IBASE Technology

IBASE Technology ET980 Series Manual de usuario

IBASE Technology

IBASE Technology MI945X Manual de usuario

IBASE Technology

IBASE Technology MB835 Manual de usuario

IBASE Technology

IBASE Technology RM-F6 Series Manual de usuario

IBASE Technology

IBASE Technology MI990 Manual de usuario

IBASE Technology

IBASE Technology MB997 Manual de usuario

IBASE Technology

IBASE Technology MI996 Manual de usuario

IBASE Technology

IBASE Technology MI945PA Manual de usuario

IBASE Technology

IBASE Technology MI805 Manual de usuario

IBASE Technology

IBASE Technology MI836F Manual de usuario

IBASE Technology

IBASE Technology IB530F Series Manual de usuario

IBASE Technology

IBASE Technology MI945 Manual de usuario

IBASE Technology

IBASE Technology LV-67H Manual de usuario

IBASE Technology

IBASE Technology IB100 Manual de usuario

IBASE Technology

IBASE Technology MI985 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario