IBASE Technology MB997 Manual de usuario

MB997

Intel®9th Gen. Xeon®-E /

Core™DT Processor Based

ATX Motherboard

User’s Manual

Version 1.0

(November 2020)

MB997 User’s Manual

No part of this publication may be reproduced, copied, stored in a retrieval

system, translated into any language or transmitted in any form or by any

means, electronic, mechanical, photocopying, or otherwise, without the

prior written consent of IBASE Technology, Inc. (hereinafter referred to as

“IBASE”).

Disclaimer

IBASE reserves the right to make changes and improvements to the

products described in this document without prior notice. Every effort has

been made to ensure the information in the document is correct; however,

IBASE does not guarantee this document is error-free.

IBASE assumes no liability for incidental or consequential damages arising

from misapplication or inability to use the product or the information

contained herein, nor for any infringements of rights of third parties, which

may result from its use.

Trademarks

All the trademarks, registrations and brands mentioned herein are used for

identification purposes only and may be trademarks and/or registered

trademarks of their respective owners.

MB997 User’s Manual

iii

Compliance

In a domestic environment, this product may cause radio interference in

which case users may be required to take adequate measures.

This product has been tested and found to comply with the limits for a Class

B device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

manufacturer’s instructions, may cause harmful interference to radio

communications.

WEEE

This product must not be disposed of as normal

household waste, in accordance with the EU directive of

for waste electrical and electronic equipment (WEEE -

2012/19/EU). Instead, it should be disposed of by

returning it to a municipal recycling collection point. Check

local regulations for disposal of electronic products.

Green IBASE

This product is compliant with the current RoHS

restrictions and prohibits use of the following substances

in concentrations exceeding 0.1% by weight (1000 ppm)

except for cadmium, limited to 0.01% by weight (100

ppm).

•Lead (Pb)

•Mercury (Hg)

•Cadmium (Cd)

•Hexavalent chromium (Cr6+)

•Polybrominated biphenyls (PBB)

•Polybrominated diphenyl ether (PBDE)

MB997 User’s Manual

Important Safety Information

Carefully read the precautions before using the board.

Environmental conditions:

•Use this product in environments with ambient temperatures between

0˚C and 60˚C.

•Do not leave this product in an environment where the storage

temperature may be below -20°C or above 80°C. To prevent from

damages, the product must be used in a controlled environment.

Care for your IBASE products:

•Before cleaning the PCB, unplug all cables and remove the battery.

•Clean the PCB with a circuit board cleaner, degreaser, or use cotton

swabs and alcohol.

•Vacuum the dust with a computer vacuum cleaner to prevent the fan

from being clogged.

WARNING

Attention during use:

•Do not use this product near water.

•Do not spill water or any other liquids on this product.

•Do not place heavy objects on the top of this product.

Anti-static precautions

•Wear an anti-static wrist strap to avoid electrostatic discharge.

•Place the PCB on an anti-static kit or mat.

•Hold the edges of PCB when handling.

•Touch the edges of non-metallic components of the product instead of

the surface of the PCB.

•Ground yourself by touching a grounded conductor or a grounded bit

of metal frequently to discharge any static.

CAUTION

Replace only with the same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer’s

instructions or recycle them at a local recycling facility or battery collection

point.

MB997 User’s Manual

Warranty Policy

•IBASE standard products:

24-month (2-year) warranty from the date of shipment. If the date of

shipment cannot be ascertained, the product serial numbers can be

used to determine the approximate shipping date.

•3rd-party parts:

12-month (1-year) warranty from delivery for the 3rd-party parts that

are not manufactured by IBASE, such as CPU, CPU cooler, memory,

storage devices, power adapter, panel and touchscreen.

＊PRODUCTS, HOWEVER, THAT FAIL DUE TO MISUSE, ACCIDENT,

IMPROPER INSTALLATION OR UNAUTHORIZED REPAIR SHALL

BE TREATED AS OUT OF WARRANTY AND CUSTOMERS SHALL

BE BILLED FOR REPAIR AND SHIPPING CHARGES.

Technical Support & Services

1. Visit the IBASE website at www.ibase.com.tw to find the latest

information about the product.

2. If you need any further assistance from your distributor or sales

representative concerning problems that you may have encountered,

please prepare the following information:

•Product model name

•Product serial number

•Detailed description of the problem

•The error messages in text or in screenshots if there is any

•The arrangement of the peripherals

•Software in use (such as OS and application software, including

the version numbers)

3. If repair service is required, you can download the RMA form at

http://www.ibase.com.tw/english/Supports/RMAService/.

Fill out the form and contact your distributor or sales representative.

 
 
 
vi 
MB997 User’s Manual 
 
Table of Contents 
Chapter 1 General Information .....................................................1 
1 Introduction .........................................................................................2 
2 Features..............................................................................................2 
3 Packing List.........................................................................................3 
4 Optional Accessories...........................................................................3 
5 Specifications......................................................................................4 
6 Block Diagram.....................................................................................6 
7 Product View.......................................................................................7 
8 Dimensions .........................................................................................9 
Chapter 2 Hardware Configuration........................................11 
1 Installations.......................................................................................12 
1.1 Installing the Memory...........................................................12 
2 Setting the Jumpers...........................................................................13 
3 Jumper & Connector Locations on MB997.........................................14 
4 Jumpers Quick Reference.................................................................15 
4.1 Clear CMOS Data (JP7)......................................................15 
4.2 Clear RTC (JP6)..................................................................16 
4.3 Flash Descriptor Security Override (JP5).............................17 
5 Connectors Quick Reference.............................................................18 
5.1 CN1: COM1 & COM2 Ports..................................................19 
5.2 J3: Digital I/O Connector ......................................................20 
5.3 ATX_12V_2X1: ATX 12V Power Connector .........................21 
5.4 CN7: SATA3 #2 Connector...................................................22 
5.5 CN8: SATA3 #0 Connector...................................................23 
5.6 CN9: SATA3 #3 Connector...................................................24 
5.7 CN10: SATA3 #1 Connector.................................................25 
5.8 CN12: HDMI Connector........................................................26 
5.9 J9, J8, J6, J5: COM3, COM4, COM5, COM6 RS232 ...........27 
5.10 CPU_FAN1: CPU Fan Power Connector (PWM Only).........28 
5.11 J10:PS2 Keyboard/Mouse....................................................29 
5.12 J13: USB2 Connector...........................................................30 
5.13 J14: USB3 Connector...........................................................31 
5.14 J23: Front Panel Connector..................................................32 
5.15 J25: 24-pin ATX power connector.........................................33 
5.16 SYS_FAN1, SYS_FAN2, SYS_FAN3: System Fan Power 
Connector (PWM Only)........................................................................34 
 
 

 
 
 
MB997 User’s Manual 
vii 
 
 
Chapter 3 Drivers Installation.............................................35 
1 Introduction........................................................................................36 
2 Intel®Chipset Software Installation Utility...........................................36 
3 HD Graphics Driver Installation..........................................................38 
4 HD Audio Driver Installation...............................................................39 
5 LAN Driver Installation .......................................................................40 
6 Intel®Management Engine Drivers Installation...................................41 
Chapter 4 BIOS Setup..........................................................42 
1 Introduction........................................................................................43 
2 BIOS Setup........................................................................................43 
3 Main Settings.....................................................................................44 
4 Advanced Settings.............................................................................45 
4.1 CPU Configuration................................................................46 
4.2 PCH-FW Configuration.........................................................47 
4.3 AMT Configuration................................................................48 
4.4 Trusted Computing...............................................................49 
4.5 ACPI Settings.......................................................................50 
4.6 NCT66860 Super IO Configuration.......................................51 
4.7 Hardware Monitor.................................................................52 
4.8 iSmart Controller 4.0 (eSIO)..................................................53 
4.9 F8126SEC Super IO Configuration.......................................54 
4.10 USB Configuration................................................................55 
4.11 CSM Configuration ...............................................................57 
4.12 NVMe Configuration .............................................................58 
4.13 Network Stack Configuration.................................................58 
5 Chipset Settings.................................................................................60 
6 Security Settings................................................................................63 
7 Boot Settings .....................................................................................65 
8 Save & Exit Settings ..........................................................................66 
Appendix........................................................................................67 
A. I/O Port Address Map ........................................................................68 
B. Interrupt Request Lines (IRQ)............................................................70 
C. Watchdog Timer Configuration...........................................................71 
D. On-Board Connector Types ...............................................................76 
 
 
 

viii

MB997 User’s Manual

This page is intentionally left blank.

Chapter 1

General Information

The information provided in this chapter includes:

•Features

•Packing List

•Specifications

•Block Diagram

•Product View

•Board Dimensions

MB997 User’s Manual

1.1 Introduction

MB997 is an ATX motherboard that supports Intel® Xeon® E/ Core™

i7/i5/i3 processors and four DDR4 DIMM memory sockets with a capacity of

up to 128GB. The board features high-performance graphics processing to

create media-rich content and brilliant HD entertainment with DVI-D, HDMI

(2.0a) and DisplayPort display interface. Connectivity is provided by eight

USB3.1, two USB 2.0, four SATA 3.0, and six COM ports.

Photo of MB997

1.2 Features

•Supports 9th Gen Intel® Xeon® E/ Core™ i7/i5/i3 processors

•4x DDR4 DIMM, Max.128GB

•Intel® processor integrated graphics with HDMI(2.0a), DVI-D, and

DisplayPort

•Dual Intel® Gigabit LAN

•4x USB3.1, 2x USB 2.0, 2x SATA 3.0, 6x COM

•1x PCI-E(x16), 1x PCI-E(x8)(Gen3.0), 1x PCI-E(x4), 2x PCI-E(x1),

2x PCI

•Watchdog timer, Digital I/O, iAMT (11.6), TPM(2.0), iSMART (4.0)

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Placa madre de IBASE Technology

IBASE Technology

IBASE Technology IB530F Series Manual de usuario

IBASE Technology

IBASE Technology MI945X Manual de usuario

IBASE Technology

IBASE Technology MI991 Manual de usuario

IBASE Technology

IBASE Technology IB804 Manual de usuario

IBASE Technology

IBASE Technology IB730 Manual de usuario

IBASE Technology

IBASE Technology IB945 Manual de usuario

IBASE Technology

IBASE Technology IB908F Manual de usuario

IBASE Technology

IBASE Technology MB892 Manual de usuario

IBASE Technology

IBASE Technology IB898 Manual de usuario

IBASE Technology

IBASE Technology MB950 Manual de usuario

IBASE Technology

IBASE Technology IB905 Manual de usuario

IBASE Technology

IBASE Technology IB112 Manual de usuario

IBASE Technology

IBASE Technology MBN806 Manual de usuario

IBASE Technology

IBASE Technology MB945 Manual de usuario

IBASE Technology

IBASE Technology MB880 Manual de usuario

IBASE Technology

IBASE Technology IP400 Manual de usuario

IBASE Technology

IBASE Technology MI935 Manual de usuario

IBASE Technology

IBASE Technology MB980 Manual de usuario

IBASE Technology

IBASE Technology ET980 Series Manual de usuario

IBASE Technology

IBASE Technology ARRANDALE IB957 Manual de usuario

IBASE Technology

IBASE Technology MI805 Manual de usuario

IBASE Technology

IBASE Technology MI920 Manual de usuario

IBASE Technology

IBASE Technology MI930 Manual de usuario

IBASE Technology

IBASE Technology MI889 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario