Hunter 44273 Manual de usuario
Owner’s Manual
Models
44273
44279
Form# 44129-01
20120723
©2012 Hunter Fan Co.
English
5-1-1Programmable
Weekdays-Saturday-Sunday
INSTALLATION
5 MINUTE
44129-01 • 07/23/2012
2
At A Glance
Know Your ermostat � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 3
Setup
Setting Day and Time ��������������������������������������������������10
Scheduling
Scheduling Introduction � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 12
Personal Scheduling Charts � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 14
Setting Your Schedule� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 14
Temporary Temperature Change� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 18
Turning Off Scheduling � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 20
Save Away��������������������������������������������������������������22
Features
Alerts ������������������������������������������������������������������24
Menu Options ���������������������������������������������������������28
Additional Features ����������������������������������������������������32
ermostat Assistance
Troubleshooting and Support� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 33
Technical Support������������������������������������������������������35
Warranty
1 Year Guarantee �������������������������������������������������������36
Table Of Contents
©2012 Hunter Fan Company 3
Your thermostat has been pre-programmed from the factory with no
programming necessary. We recommend using these pre-programmed settings
for a few days before altering them as they offer maximum energy saving
benets. If you do decide to alter your programs, use the charts on page 13
to write out your scheduled times and temperatures. After you have recorded
your preferences, follow the instructions on page 14 to alter your temperature
settings.
There is no need to program the thermostat at the wall where it is mounted!
Remove the thermostat from the backplate by gripping the sides rmly and
pulling it straight off. This allows you to program the thermostat in comfort.
After you have programmed your thermostat, no other setting changes are
necessary unless you wish to browse through the menu to see how you may
further adjust the independent settings of your thermostat to meet your lifestyle.
The features section starting on page 28 of this manual will describe these
settings. Most settings have been preset for optimal performance.
If you need any assistance with installion or setup of your new
Hunter Thermostat, please call us, our technical support staff is
ready to help!
USA: 1-888-830-1326
Canada: 1-866-268-1936
Hours of operation are from 7:00 am to 7:00 pm Monday - Friday and 8:00
am to 5:00 pm on Saturday, Central Time. You may also contact us over the
Internet at:
www.HunterFan.com
Know Your ermostat
44129-01 • 07/23/2012
4
1. Allows Schedule Setup for altering scheduled programs.
2. Sets the Save Away feature for when you will not be home during a regularly
programmed time.
3. Conrms completion of an action or returns you to the Home screen.
4. Allows access to the advanced features of the thermostat.
5. Moves you forward or backward while setting up features or schedules.
6. Adjusts time and temperature settings as well as moving up or down
menu lists.
7. Indicates whether the system is set to Heat, Cool, or Off.
8. Shows if the fan is set to Auto or On modes.
9. Allows you to switch between Heat, Cool, and Off modes.
10. Allows you to switch between fan Auto and On mode.
Know Your ermostat
©2012 Hunter Fan Company 5
Save
Away
Schedule
Back Done/
Home Menu Next
1
8
5
43
2
7
6
5
910
Know Your ermostat
44129-01 • 07/23/2012
6
1. Holds 2 “AA” Batteries.
2. HE/HG Switch - allows you to set your furnace to Gas/Oil or Electric, based
on the type of system you have.
3. Allows your thermostat to operate your HVAC system* properly by indicating
the system type that you have.
*Conventional System: Uses a condensing unit for cooling and a
separate furnace system for heating.
*Heat Pump System: Uses the condensing unit for both heating
and cooling.
NOTE: If you are unsure of your system type it may be necessary
to contact our technical support department at 1-888-830-1326, your
HVAC manufacturer, or a local HVAC technician to determine this.
Improper selection of your system type could cause the thermostat to not
operate your system properly.
Know Your ermostat
©2012 Hunter Fan Company 7
1
3
2
Know Your ermostat
44129-01 • 07/23/2012
8
1. Shows the current day of the week or weekend.
2. Indicates the thermostat is running in schedule mode.
3. Will show when your heat pump or system is reporting a problem to the
thermostat.
4. Indicates the current room temperature.
5. C will display when in Celsius mode. Nothing will display when set to
Fahrenheit.
6. Flashes when the furnace lter should be checked for replacement.
7. On when the current schedule period is running.
8. Indicates the current active schedule period.
9. Low battery warning, replace the batteries in the thermostat.
10. Indicates the fan is running when displayed.
11. Shows the current mode of the fan, Auto or On.
12. Indicates the current time in AM (A) or PM (P).
13. On when the current operating mode, heat or cool, is running.
14. Current operating mode, heat or cool.
15. Indicates the thermostat is running in save away mode.
16. Current Set temperature the thermostat is scheduled to run.
Know Your ermostat
©2012 Hunter Fan Company 9
70
o
Wed
Auto
Filter
10:05
P
o
72
At Home
Heat to
C
2
1
3
4
56
7
8
9
10
11
12
13
14
15
16
Know Your ermostat
44129-01 • 07/23/2012
10
Setting Day and Time
Once you install the batteries, the thermostat will prompt you to set the
current day and time.
1. You will notice that “Mon” will be ashing at the top left of your
screen. Use the or buttons to move to your current day of the
week and press the Next button to advance to the next step.
2. Use the or button to change between am(A) and pm(P). Choose
Next to advance.
3. Next you will select your current hour by using the or buttons.
The Next button advances you to the next step.
4. Set your minutes using the or and press Done/
Home to nish or Back if
you need to make a correction to a previous step.
5. When nished, the thermostat will show “Updated!” to conrm your
settings are saved.
6. Your thermostat will next prompt you to set your programming, see
page 14 step 2 if you wish to alter your programs at this time.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Termostato de Hunter
Hunter
Hunter 44260 Manual de usuario
Hunter
Hunter 44050 Manual de usuario
Hunter
Hunter 44277W Manual de usuario
Hunter
Hunter 42227 Manual de usuario
Hunter
Hunter 44272 Manual de instrucciones
Hunter
Hunter 44905 Instrucciones de montaje
Hunter
Hunter 44033-01 44272 Manual de usuario
Hunter
Hunter Set & Save 47110A Manual de usuario
Hunter
Hunter 44110 Manual de usuario
Hunter
Hunter Energy Monitor 44408 Manual de usuario
Hunter
Hunter SET & SAVE 47110A Manual de usuario
Hunter
Hunter Set & Save 47350A Manual de usuario
Hunter
Hunter 40120 Guía de configuración
Hunter
Hunter 42177 Manual de usuario
Hunter
Hunter 44459 Manual de usuario
Hunter
Hunter 44008-01 Manual de usuario
Hunter
Hunter Enermy Monitor IIPlus 44407 Manual de usuario
Hunter
Hunter 42122 Guía del usuario
Hunter
Hunter 44360 Manual de usuario
Hunter
Hunter 44377 Instrucciones de montaje
Manuales populares de Termostato de otras marcas
EWELLY
EWELLY EW-181 Manual de usuario
Prolon
Prolon T1100 Instrucciones de instalación
Computherm
Computherm Q20 Manual de usuario
Heatmiser
Heatmiser neoStat Manual de usuario
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario
