Huawei 5G CPE MAX5 Manual de usuario
Quick Start Guide
Pika-aloitusopas
Snabbstartsguide
Hurtigstartguide
Hurtigstartveiledning
Sparčiosios paleisties vadovas
Īsa pamācība
Kiirtutvustus
Schnellstartanleitung
Skrócona instrukcja obsługi
Guida rapida
Ръководство за бърз старт
Snelstartgids
150304-1315
Quick Start Guide................................. 1
Pika-aloitusopas................................... 9
Snabbstartsguide................................. 17
Hurtigstartguide.................................... 25
Hurtigstartveiledning............................. 33
Sparčiosios paleisties vadovas............. 41
Īsa pamācība........................................ 49
Kiirtutvustus.......................................... 57
Schnellanleitung................................... 65
Skrócona instrukcja obsługi.................. 73
Guida rapida......................................... 82
Ръководство за бърз старт................. 90
Snelstartgds.......................................... 98
Contents
1
Packing List
Safety rope Bracket
Screws (M4*7)
To install the bracket, you’ll need to prepare
the following tools and materials:
Clean towel Glass cleaner A hex key (φ2.5)
The hex key (φ2.5) is included in the CPE package.
2
To remove the bracket, you’ll need to prepare
the following tools and materials:
Adhesive remover Scraper knife
1. Avoid installing the bracket on any hard to reach
windows, for example, outward opening windows in
high-rise buildings or the outermost sash on sliding
windows.
2. Inward opening windows are recommended. You can
also install the bracket on balcony windows or rst
oor windows, as you can do so by standing outside
the window.
3. Make sure that the window glass is strong enough,
secure, and intact. The glass must not bend, deform,
or crack due to the installed bracket.
4. Make sure that the glass surface is clean and smooth,
and free of any foreign objects. It is recommended
that you avoid installing the bracket on rough, non-
transparent glass. Before the installation, clean the
glass surface thoroughly to remove any oil stains,
water stains, dust, or other foreign objects.
5. Make sure that the position where you install the
bracket is no more than 2 meters from the ground
(such as terrace or other obstacles), and that there are
no people walking around this area.
Selecting the Installation Position
2 3
Installation Guide
It is recommended that you install the bracket in
environments of 15°C and above.
1. Determine the area where you are going to install the
bracket, and clean the area with the glass cleaner.
Wipe the area clean and dry with a towel. Choose a
location near the window’s hinge, and no more than
20 cm away from the lower edge of the window, so
that you can route the network cable through the
window later.
2. Connect the safety rope buckle to the bracket, fasten
the safety rope, and x it along the window sill or on
another immovable object nearby.
4
3. Remove the liner from the double-sided adhesive tape
on the back of the bracket.
4. Attach the bracket to the area you have cleaned, and
press the bracket from top to bottom hard and evenly
with at least 15 PSI (1 kg/cm2) of pressure for 30
seconds or longer. Check the bubbles from the other
side of the glass, and make sure that the bracket is
fully attached to the glass. Do not remove or touch the
adhesive, as doing so may impair the adhesive force.
If there are a lot of bubbles on the double-sided
adhesive tape, remove and then re-install the bracket.
4 5
5. Keep the bracket still in place for 48 hours. Mount the
four screws into the holes on the bracket, and fasten
the screws using a hex key (φ2.5).
6. Mount the CPE and route the network cable through
the window, by referring to the CPE user manual.
Check the safety rope to make sure that it is secure
and locked. Check the outdoor CPE on a regular
basis for optimal safety.
6
Removal Guide
1. Heat the bracket with a hair dryer or hot towel for 1 to
2 minutes.
2. Use a scraper knife to slowly pry the bracket from the
glass.
3. Spray adhesive removal (main ingredients: acetone,
ethyl acetate, butyl acetate, and ethanol) onto the
adhesive tape.
6 7
4. Wait for 1 to 2 minutes. Then use the scraper knife to
remove the bracket from the glass.
5. Spray adhesive removal to the glass and the adhesive
on the bracket. Wait for 1 to 2 minutes, and remove
the residue using the scraper knife and towel.
8
a. Repeat steps 1, 2, and 3 in sequence.
b. Do not exert excessive force when removing the
bracket, as doing so may damage or deform the glass.
Safety information
This section contains important information about the
operation of your device. It also contains information
about how to use the device safely. Read this
information carefully before using your device.
● Extreme heat or cold may damage your device or
accessories.
● Keep the device away from sources of heat and re,
such as a heater, microwave oven, stove, water
heater, radiator, or candle.
● Observe local laws and regulations, and respect the
privacy and legal rights of others.
● Do not drop or cause an impact to the device.
Disposal and recycling information
The symbol on the product, battery, literature,
or packaging means that the products and
batteries should be taken to separate waste
collection points designated by local authori-
ties at the end of the lifespan. This will ensure
that EEE waste is recycled and treated in a
manner that conserves valuable materials and protects
human health and the environment. For more informa-
tion, please contact your local authorities, retailer, or
household waste disposal service or visit the website
https://www.brovi-tech.com.
Reduction of hazardous substances
This device and any electrical accessories are compliant
with local applicable rules on the restriction of the use of
certain hazardous substances in electrical and electronic
equipment, such as EU REACH, RoHS and Batteries
(where included) regulations, etc. For declarations of
conformity about REACH and RoHS, please visit our
web site https://www.brovi-tech.com.
Tabla de contenidos
Idiomas:
Otros manuales de Enrutador inalámbrico de Huawei
Huawei
Huawei WA8011V Manual de usuario
Huawei
Huawei E5730s-2 Especificaciones técnicas
Huawei
Huawei Speed Wi-Fi HOME L01 Guía de inicio rápido
Huawei
Huawei E5786 Manual de usuario
Huawei
Huawei HW-02E Manual de usuario
Huawei
Huawei 7900 Series Manual de usuario
Huawei
Huawei B525s-23a Manual de usuario
Huawei
Huawei E176 Instrucciones de montaje
Huawei
Huawei B315 LTE CPE Manual de usuario
Huawei
Huawei B535-232 Manual de usuario
Huawei
Huawei V100R001_01 Manual de usuario
Huawei
Huawei E8238 Guía de configuración
Huawei
Huawei OptiXstar W826E Manual de usuario
Huawei
Huawei E5373s-155 Especificaciones técnicas
Huawei
Huawei E5836 Manual de usuario
Huawei
Huawei WiFi Q2 Especificaciones técnicas
Huawei
Huawei Quidway AR-18-12 Manual de usuario
Huawei
Huawei E5172 Manual de usuario
Huawei
Huawei E5332 Manual de usuario
Huawei
Huawei EchoLife HG532 Manual de lista de piezas
